master node 中文意思是什麼

master node 解釋
主節點
  • master : n 1 主人；僱主，老闆（opp servant）；船長；船主；家長；校長。2 〈常無冠詞〉善能[長于、精通]…的人...
  • node : n 1 節；結；瘤；【蟲類】結脈。2 【植物；植物學】莖節；【醫學】硬結腫；結，節結；【天文學】交點。3...
  1. This paper presents the element stiffness matrix and equivalent node force of the variable cross - section bar. so the approximation in structural analysis is avoided, and the calculation capacity of equivalent frame method is also developed. this helped the engineers avoid the fem, which consume much time and is difficult to master

    本文對板帶寬度變化的板柱結構推導了變截面直桿單元的單元剛度矩陣和等效結點荷載列陣，避免了在結構分析時所作的近似，也擴大了等代框架法的計算范圍，使工程技術人員免於使用佔用機時、難于掌握的有限元分析法。
  2. First, for its disadvantages in dynamic networking, the separated structure of master and slave is merged. and a new bluetooth node structure which has the ability of dynamic role changing is got. second, for its insufficiencies in nodes controlling, we add a new module btextend above the bthost modual, through which can controll the bluetooth nodes behaviour flexibly

    首先，針對該模擬模塊中的藍牙節點結構無法支持網路拓撲動態創建的問題，將原架構下主節點和從節點分離的架構進行了合併，讓藍牙節點的架構能同時處理不同角色的模擬，從而得到了具備角色動態切換能力的藍牙節點體系結構;其次，針對該模擬模塊在靈活控制藍牙節點的介面方面存在不足，在原架構下的bthost模塊之上添加了一個可以靈活控制藍牙節點行為的新模塊btextend 。
  3. After analysing the codes of tcp / ip protocol stack under rtlinux, a new protocol is added into the stack, in which the network nodes are divided into two parts : a master node and a number of controlled nodes. each controlled node can transmit its data by ethernet only when the master send it a request in a fixed timeslot of a communication cycle

    本文在對rtlinux平臺的tcp / ip協議棧的原碼進行研究分析后，在其原有的協議棧中加入了一種新的協議rcp （ real - timecontrolprotocol ） ， rcp協議採用主/從模式，在固定的傳輸周期中使用分時槽的方式對數據傳輸進行限制。
  4. Finally, a graceful degradation method based on the fttcan protocol is put forward. on the basis of efficient sensor ability, a detailed implementation architecture of qos graceful degradation algorithm is designed, with the master node as the qos manager in the fttcan protocol

    最後，本文給出了一種基於fttcan總線協議的qos適度退化策略，在傳感器采樣能力較為充分的前提下，利用fttcan中的主節點作為qos管理器，對qos適度退化策略進行了具體化的設計。
  5. In the mode of master - slave, the pc with can adapter performs as the master node and the other five field controllers perform as the slave nodes

    在主從方式下，帶有can適配卡的pc機為主節點，其餘5個現場控制器為從節點。
  6. Through developping the formula of two - node linear bar element and the procedure of full - stress optimization, the learners will master the principle and the procedure of the spatial braced structures ' design

    通過對兩節點線性桿單元的簡單推導以及滿應力優化分析的原理分析，了解網架結構的分析設計的基本原理和過程。
  7. The master node divides the work between several slave nodes

    主節點負責將任務劃分到多個從節點上。
  8. Since the slave nodes never listen to another slave response to the master, a slave node cannot reply incorrectly to another slave node

    既然從節點從來都不會監聽其它從機對主機的響應，因此從節點也就不會對其它從節點做出不應該的回應了。
  9. This paper designs the hardware circuit and completed the hardware manufacture of the slave node. the slave node combined with the 5136 - dnp - pci master board made by woodhead company make up of a typical master / slave network. an easy build and reliable hardware solution is available in this paper

    本文設計了從站通訊介面的硬體連接原理圖，完成了硬體電路板的製作，並與woodhead公司的5136 - dnp - pci主站卡一起組成了一個典型的主從網路，從而提供了一種易實現、高可靠的硬體解決方案。
  10. In a typical setup, the master node is where the applications are initiated

    在典型的設置中，應用程序在主節點上開始運行。
  11. It works in unattended mode so its operation is fully controlled by the master node using linux

    它以自動的方式工作，其操作由主節點（使用linux ）完全控制。
  12. This node doesn t have to be a master node

    而不進行任何切換。這個節點不必是主節點。
  13. Last, announce this node as the master node in the cluster

    最後，聲明這個節點是集群中的主節點：
  14. Repeat the first three steps above for initializing the master node

    重復前面初始化主節點的前三個步驟。
  15. Error : master node 26 instance firstone is not on the axis of symmetry

    可是我的26節點明明就在對稱軸上啊！
  16. Initializing the master node

    初始化主節點
  17. The master node assembles the results, further distributes work, and so on

    主節點收集結果，並繼續分發任務，依此類推。
  18. It s the master node s responsibility to migrate applications to the drones when required

    主節點負責根據需要將應用程序遷移到從屬節點上。
  19. In such a cluster, apart from the master node, you don t need to run a gui on the slaves

    在這類集群中，除了主節點以外，不需要在從節點上運行gui 。
  20. Each computing node can be both a master for locally created processes and a slave for processes migrated from other pcs

    每個電腦節點既可以是自行產生程序的主機，也可以是由其他個人電腦轉移程序而至的從屬機。
分享友人
分享到 Line

分享到臉書