matching circuit 中文意思是什麼
matching circuit
解釋
匹配電路-
In the case of layout design, discussed the effect and application of the transistor matching in the circuits design deeply. demonstrated the circuit layout check by lvs design
在電路的版圖設計方面，較深入地討論了晶體管的匹配在電路版圖設計中的作用和應用，通過lvs對電路的版圖檢查進行了具體說明。 -
The fourth chapter : in this chapter, it introduces the hardware designing of the dsp system based on pci bus and states every module of the hardware designing : circuit of signal adjusting, filter circuit of anti - overlap, circuit of data - acquisition automatically, expanding circuit of dsp memory, circuit of voltage matching, interfaces circuit of pci etc. it also includes theoretic basis and procedure of pcb designing
第四章介紹基於pci總線的dsp系統硬體設計。敘述了硬體設計的各個模塊：信號調理電路、抗混疊濾波電路、自動數據採集電路、 dsp存儲器擴展電路、電平匹配電路、 pci介面電路等，以及pcb設計的理論基礎和設計過程，並給出了設計和調試的結果。 -
Study on the parameter matching of power circuit for ac servo systems
交流伺服系統主電路參數的研究 -
The concept of " timing " in the article is not the clock in our ordinary living, but syntheses which is made up of some frequency source in the signal generator ( such as cs atom frequency standard, rb clock & high accuracy quartz crystal oscillator ) which produces the primary frequency, the matching input interface and the matching output interface and controlling circuit etc. for example, bits is a kind of timing equipment, which is used to control the timing of some functions
本文論及的「時鐘」概念不是指日常生活中使用的鐘表，而是由產生基準頻率的信號發生器（如銫原子頻率標準、銣鐘及高精度石英晶體振蕩器等）中的某種頻率源以及相配套的輸入、輸出介面和控制電路等組成的一整套具有特定同步定時功能的綜合體。如bits就是一種時鐘設備，它提供用在通信系統中控制某些功能的定時的時間基準設備，時鐘提供的信號稱為基準信號、定時信號或同步信號。 -
Impedance - matching balanced traction transformers ( balanced transformers in this paper for short ) are step - down transformers, they transfer symmetrical three phase voltage in primary side to perpendicular two phase voltage in secondary side. they are different from any other transformers, so their short - circuit current analysis and short - circuit test method must be taken into special account
阻抗匹配平衡牽引變壓器（本文中簡稱平衡變壓器）是一種將一次側三相對稱電壓變換為二次側二相垂直電壓的降壓變壓器，它不同於已有的任何一種變壓器，短路電流的分析計算和短路試驗必須予以重新研究。 -
It is key to have a technique of the image matching that is better 、 quicker and more accurately to enhance the diagnosis precision of the infrared failure circuit detection system
更好、更快、更準確地對圖像進行匹配成為提高紅外電路故障檢測系統診斷精度的關鍵。 -
In the purpose of enhance the circular polarization, the sub - array have used a phase transfer circuit which made each patch have 90deg phase difference in turn. matching branches are added to the full array to enhance the bandwidth of the antenna
在4單元天線子陣的設計過程中採用了移相電路，使4單元間的相位依次相差90 ，展寬了天線的圓極化軸比帶寬。 -
This paper presents the general project design firstly, and then introduces the system hardware circuit design in detail which includes the choice of chips, the loop filter parameters computation and the design of the power amplifier ' s peripheral matching circuit
在介紹了系統總體方案設計之後，本文詳細介紹了系統的硬體電路設計，包括晶元的選擇，環路濾波器參數的設計，以及功率放大器外圍匹配電路的設計。 -
This paper has got an analytical expression with temperature information by curve matching technique, by this means, we can not only predigest hardware circuit but also realize the function of selfrevision and selfcompensation
本論文應用曲線擬合技術，融入溫度信息，得出帶有溫度信息的壓力解析表達式，此方法簡化硬體電路且可實現自校正自補償功能。 -
After select the most suitable topology structure of circuit, we simulate the biasing circuit, input and output matching circuit
在選定合適的拓撲結構后，對放大器的靜態偏置點、輸入輸出匹配電路進行模擬。 -
（ 2 ） the major circuit has been established, composed of rectifier 、 buck - chopper 、 push - pull inverter and matching network, which realizes high - power supersonic ac output. to achieve maximal output power, the pulse frequency modulation ( pfm ) has been applied to auto - adjustment of output frequency, which corresponds to the load ' s resonant frequency
（ 2 ）建立了超聲電源主電路，其中包括：整流、直流斬波、推挽逆變器和匹配網路等部分，實現了大功率超聲頻交流電的輸出，輸出頻率的脈頻調制（ pfm ）和輸出功率的脈寬調制（ pwm ） 。 -
It has been shown by our calculations that conductor loss is greatly reduced under velocity matching with relatively thick coplanar waveguide electrodes and thick buffer layer, but the characteristic impedance can not match with that of the external circuit at the same time, and the modulation bandwidth is confined in this case
然後，用一般的橢圓積分計算了普通共面波導型調制器的有效折射率、特徵阻抗和導體損耗系數。通過計算發現，採用厚電極和厚緩沖層結構，在實現速度匹配的情況下，可以大大減小導體損耗，但是由於阻抗不能同時滿足匹配，調制帶寬受到限制。 -
Moreover, the matching circuit of electrically small antennas using transmission line is studied in this dissertation. a model is presented. and some theory analyses and the measure result are given
另外，論文中對電小天線的傳輸線匹配模型進行了初步的探討，給出了一種傳輸線匹配電路的形式，以及理論的分析和實驗結果。 -
In this paper, through analyzing and discussing current development of typical hydrostatic drive system of crawlers at home and abroad, it studies property - matching of hydrostatic transmission systems, provides an electronic proportional controlling variable displacement pump - motor hydraulic drive circuit and control plan fit for crawlers " operation, together with typical travel drive system component
本文對國內外推土機行駛靜壓驅動系統研究現狀進行了分析和綜合，對靜壓行駛驅動系統的性能匹配進行了分析，結合典型行駛驅動系統的組成、工作原理提出了適合推土機工作的電比例控制變量泵-變量馬達液壓驅動迴路及其控制方案。 -
Broad band matching circuit
寬頻帶匹配電路 -
Broad - band matching circuit
? ?域整合迴路 -
First, we analyse the power amplifier in theory in the circuit mode, biasing point linearity, thermal stability, input and output matching circuit
論文首先從理論的方面對放大器的設計進行分析，對放大器的電路模型、偏置點、線性、熱穩定性、輸入輸出匹配進行理論上的分析。 -
First, we introduce the basic theory, which is useful to density measurement, namely, transmission - line theory, its content consist of transmission - line equivalent circuit 、 smith chart 、 impedance matching and microwave network technology. the on - line density measurement technology with microwave has been narrated as a key part
首先，分析了微波密度在線測量技術的理論基礎- -傳輸線理論，其內容包括將用於諧振腔設計的傳輸線等效電路、施密斯圓圖以及阻抗匹配和微波網路等多方面的技術。 -
Moreover, the scheme of mmw optically controlled phased array radar is presented also. at last, the matching - circuit and apd receiver circuit are designed. the curves of the system are shown respectively
此外，本文還對l波段光傳輸鏈路實驗系統的性能進行改進，設計了前端匹配電路和apd接收電路，並給出相關電路的實驗結果和測試曲線。 -
Presents the simple but highly reliable on - line detection of ultrasonic transducer clamping capacitance based on the impedance circuit model constructed through the impedance characteristics of the ultrasonic transducer under triple harmonics, and concludes from experimental results that this method can be used to effectively detect the variation of clamping capacitance while the transducer is operating, and the matching inductance can be dynamically regulated according to the results of detection, and dynamic matching can therefore be achieved in the real sense at the end of the transducer to improve the overall performance of the whole system
為了解決大功率超聲應用的換能器電端匹配問題，分析了超聲波換能器在諧振頻率三次諧波下的阻抗特性，給出了超聲換能器三次諧波下的阻抗電路模型.並根據阻抗電路模型建立了對超聲換能器的夾持電容實現在線檢測簡單、可靠性高的方法，實驗證明該方法有效的.該方法可以在換能器工作過程中隨時檢測夾持電容的變化，根據檢測結果對匹配電感進行動態調整，實現真正意義上的換能器電端的動態匹配，從而大大改善匹配質量，提高系統的工作性能
分享友人