matching resistance 中文意思是什麼

matching resistance 解釋
匹配電阻
  • matching : 表芯板搭配
  • resistance : n. 1. 抵抗，反抗，抗拒，抵禦；敵對，抵抗力，反抗力，阻力，【生物學】抗病性。2. 【電學】電阻；阻抗；電阻器。
  1. Because some matching always occurs, vertical resistance cannot prevent all allo-infection, but it can only reduce the exodemic.

    由於經常發生對應的異狀侵染，垂直抗性不能阻止所有的異體侵染，但只能減少外源流行。
  2. A triple - layer radar absorbing coatings composed of dielectric and magnetic materials were prepared according to resistance matching principal, which is then further coated with an infrared and visible light camouflage coatings

    摘要依據阻抗匹配原理制備了一種3層雷達吸波塗層，並在吸波塗層表面噴塗一定厚度的可見光、紅外偽裝塗料，比較了噴塗偽裝塗料前後塗層吸波性能的變化。
  3. We profile matching steel production with fire glass formed a complete functional system. corresponding to the fire resistance of the whole system is : 30 minutes, 60 minutes, 90 minutes, 120 minutes and 180 minutes

    我們生產的鋼型材框架與防火玻璃配套后形成了完整的防火功能系統，相應使整個系統的耐火極限達到： 30分鐘、 60分鐘、 90分鐘、 120分鐘。
  4. Under the conditions of high safe coefficient of insulated electrical strength of the stator winding of the generator, the selection of earthing resistance value should meet the needs of matching one - point earthing protection of the stator and limiting the fault current

    在發電機定子繞組絕緣電氣強度有較高的安全系數的情況下，接地電阻值的選取應主要服從與定子一點接地保護的配合及限制接地故障電流的需要。
  5. Firstly, the parameters controlling ductile crack growth are gotten from the resistance curve result of standard 3 point bending specimen, then the resistance curves of the tension specimen for the welded joint with different strength mis - matching are predicted based on the cell model

    首先由標準三點彎曲試件的阻力曲線，得出反映材料微觀損傷的特殊單元模型控制參量，再根據該參量對不同接頭強度匹配下雙邊缺口拉伸試件的阻力曲線進行了定量預測，其結果與試驗結果相當吻合。
  6. Low sheet resistance and good matching between substrate and paste are the principal requirements for conductor paste in multi - layer cofire substrate

    共燒導帶漿料與aln生坯之間的燒結應力是造成基板失效的原因。
  7. There are different thrusts and torques corresponds to difference trailing edge cutting value at different advance coefficients. combined with the real hull ' s resistance and the real engine ' s power and revolution, the matching point between hull - propeller - engine and the value of trailing edge cutting can be calculated

    在得到不同的進速、不同的切割量下螺旋槳的推力、轉矩的情況下，結合實船的阻力和主機的功率、轉速等資料就可以計算出使船?槳?機匹配的切割量。
  8. Based on the analysis of present commonly used scene matching area selection algorithms, this thesis presents a new a approach in the selection of scene matching area, gis supported scene matching area selection based on image content. the new method shows great efficiency in solving the problems faced in present algorithms, which are high reliance on image quality, low resistance to noise, low veracity and mass process time

    依據本文提出的基於最小誤判概率的景象匹配區選擇方法評價標準對目前常用的景象匹配區選擇方法進行評價后，針對現有方法受圖像質量影響較大、抗干擾能力低、準確性低以及計算量大等多方面的問題提出融合圖像內容的景象匹配區選擇方法。
  9. Finally, the design and the test experiment of a high power matching load are introduced. the load has a steady resistance of 5. 82

    最後，介紹了實驗中設計並研製的大功率低電感匹配負載，該負載冷測電阻值5 . 82
  10. Ysialon and casialon glasses also form at the interface. if 0. 45 % wt sio2 is added in the paste, the tungsten paste has low sheet resistance and matching shrinkage of a1n green - sheet bodies. at this concentration of sio2 in the paste, a1n substrate is little porous at interface

    在陶瓷介質和導帶漿料之間的界面位置，有sio _ 2 、 aln ，以及aln的添加劑cao和y _ 2o _ 3存在，它們四種單質材料發生反應，在界面位置形成ysialon ， casialon玻璃相和casialo和ysio的晶相，提高了焊盤的附著力。
  11. The effects of strength mis - matching and specimen geometry on the resistance to ductile crack growth for welded joint were conducted by 3 - d fe analysis based on the micro - damage model

    摘要基於材料微觀損傷模型，採用三維有限元數值方法，定量研究了焊接接頭中強度匹配、試件幾何型式對接頭抗延性裂紋擴展阻力特性的影響。
  12. In this paper, the part of apis based on minutia features includes mainly computing orientation, filtering, binarization, thinning, feature extraction, postprocessing and minutia matching ; the part of apis based on statistical features is composed of reference point location, extracting feature, classification and matching. some new approaches are brought forward : 1 ) in the preprocessing, a new binarization method of fingerprint images based on the orientation and the dynamic threshold is proposed, which has the excellent capability of noise resistance. this method makes fully use of the orientation and the characteristics of grayscale change, gets the binarized images from the primitive fingerprint images directly, instead of the series of processing such as smoothing, enhancement and binarization

    本論文對這兩種系統做了深入地研究，從基於細節點特徵的系統中求取指紋方向圖? ?濾波? ?二值化? ?細化? ?特徵提取? ?后處理，到基於統計性特徵的系統中選取指紋圖像參考點? ?提取統計性特徵? ?分類? ?匹配等環節，都一一進行了討論，並提出了一些新方法： 1 ）在基於細節點特徵系統的預處理部分，本論文提出一種新的基於方向圖具有動態閾值的指紋圖像二值化方法，這種演算法能夠在保持特徵點不丟失的基礎上一次性完成一般指紋圖像處理中的無效塊分割、增強、濾波、二值化的過程。
分享友人
分享到 Line

分享到臉書