measuring circuit 中文意思是什麼

measuring circuit 解釋
測量電路
  • measuring : n. ,adj. 測量（的），測量用（的）。 remote measuring 遙測。
  • circuit : n 1 （某一范圍的）周邊一圈；巡迴，周遊；巡迴路線[區域]；迂路。2 巡迴審判（區）；巡迴律師會。3 【...
  1. This paper studies the inductive displacement transducer ’ s structure and its measuring principle, also studies the whole classical measurement system and analyzes its merits and drawbacks according to related experimental findings. to get rid of classical measurement system ’ s drawbacks such as low stability, narrow linear measuring range, etc. and improve measuring system ’ s performance index, this paper ’ s improves several key technologies in the high - accuracy measuring circuit

    本文研究了電感位移傳感器的結構、測量機理以及其整個測量系統的系統架構，並通過試驗認真分析了傳統的電感位移傳感器精密測量電路的優缺點，結合本課題的研究需要和技術要求，對傳統電感位移傳感器測量系統穩定不高，線性測量范圍小等不足之處進行了改進。
  2. Design of an extremely weak photoelectric current measuring circuit

    極微弱光電流測量電路的設計
  3. This paper introduces design scheme of measurement system and establishes geometric parameter measurement patterns and functions of gearbox case, which are fit for the computer on - line automatic processing. measuring circuit and software are also introduced which are designed to carry out performance of the instrumentation

    文中提出了變速箱殼體綜合檢測方案，給出了變速箱殼體幾何量測量方法，建立了變速箱殼體幾何量參數測量數學模型，推導了測量方程，對測量電路、實現整機功能要求的軟體結構給出了相關論述。
  4. In order to enhance the precision, this design proposes that temperature - measuring circuit of platinum resistors and software should be employed to carry on adjustment of measured precision ; it also proposes that the interference of the grid can be reduced by the voltage front feed ; and meanwhile it calls for the application of the photoelectric insulation, the over heating protection and alarm so as to enhance the security performance of the system

    為了提高精度，本設計還採用了鉑電阻溫度測量電路，並利用軟體對測量精度進行自校準；通過電壓前饋控制減少電網干擾。此外，設計中還加入了光電隔離措施及過熱自動保護和報警功能，以增強系統的安全性能。
  5. The principle and the mechanical structure of the air - gap inductance - type transducer are analyzed in this article, and the static parameters are calibrated. dynamic calibration is applied to air - gap inductance - type transducer which is not good in dynamic capability, to obtain the dynamic parameters of the transducer and its measuring circuit. based on the result of the dynamic calibration, the transducer and its serving circuit are modeled so that the method of how to improve the dynamic performance can be found

    本文對現有氣隙式電感傳感器在原理和機械結構上作了深入的分析，對其參數進行了靜態標定；並且針對常規電感傳感器動態響應低，不宜用於快速動態測量的缺點，引入測試系統動力學的思想，設計了一套動態校準系統，對現有傳感器進行多次動態校準，根據動態校準的實驗結果對現有傳感器建立數學模型，得到現有傳感器的動態特性；在此基礎上，根據磨床工件在線檢測的要求，設計一個硬體補償系統來提高整個測試系統的動態特性。
  6. The main works are listed as follows : ( 1 ) the small capacitance measuring circuit for ect based on the charge amplification principle was deeply analyzed and improved. the stray - immunity and the charge injection effect of this circuit were deeply analyzed. the influence of the charge injection effect was eliminated by practical time sequences and circuit structure differential

    本文的主要工作和創新點如下： （ 1 ）對基於電荷放大原理的微弱電容測量電路進行了深入的分析和改進，深入分析了該電路的抗雜散電容性能及電荷注入效應問題，通過時序的合理設計消除了電荷注入效應等因素對測量結果的影響，改進了該電路的數學模型。
  7. In order to eliminate the influences caused by temperature, electrode - polarization and autoeciousness - capacitance, the traditional instrument has added complicated circuits so that it cause such shortcomings as big error, time - retardation and a relatively small scope. through the problems caused by 2 - probe electrode and ac current source, a new measuring circuit based on the excitation of bi - directional voltage pulse and the sensor of 4 - probe electrode is proposed, using single - chip to achieve auto - temperature compensation

    作者在參閱國內外大量相關參考文獻的基礎上，從電導測試技術的原理性研究出發，分析了採用交流激勵源、兩電導電極為傳感器的傳統電導測試系統所面臨的種種問題，提出並研製了一種基於雙極性脈沖電壓激勵、以四電導電極為探頭、運用單片機進行溫度自動補償的新型電導率測量系統。
  8. And a kind of 16 - step automatic selective programmable amplifying circuit is designed in volume resistivity measuring circuit, so as to handle sampling little and broad signal. the control and disposal system with the core of microchip at89c55wd is analyzed on chapter 4. main function unit such as the interface circuit of lcd display and keyboard, the interface circuit of micro - printer, real time clock ds12c887, and hardware anti - jamming technique are discussed

    本文還設計了以at89c55wd單片機為核心的控制處理系統的外圍介面電路及其軟體，對主要功能部分進行了分析，主要包括：鍵盤液晶顯示介面及界面設計、微型印表機介面、實時日歷時鐘晶元ds12c887 、單片機與單片機及單片機與上位機的通信設計以及控制系統硬體抗干擾措施等。
  9. The design and application of the measuring circuit of inductance sensor base on the soft digital phase sensitivity detection

    基於軟相敏檢波演算法的電感傳感器測量電路的設計
  10. The paper introduces data processing methods in detail after providing the measuring circuit of roll profile. the system adopts vb to design softpanel of measurement system, realizing the serial communication between pc and singlechip base on mscomm control of vb

    本文在設計輥型檢測的硬體電路的基礎上，詳細介紹了數據處理的方法，採用vb語言設計測量系統的軟面板，並使用vb的mscomm控制項實現上位機與單片機的串列通信。
  11. An approach to the practicability of temperature - measuring circuit using thermoelectric couple

    鉑熱電阻測溫電路實用性的探討
  12. The bias voltage in the circuit is supplied by the bgr, which reduces the power consumption and the area of the chip. this paper takes polygon interpolation as non - linear calibration method, adopts hdl verilog to design the digital duty cycle measuring circuit, from which we have obtained a group of

    選擇了臺積電0 . 25 mcmos工藝庫，利用hspice模擬工具對整個溫度傳感電路進行模擬測試，結果顯示所設計體溫計在30 c 50 c的溫度范圍內具有0 . 01 c以上的檢測精度、 0 . 1 c的顯示精度和180 w的最小功耗。
  13. Apart from that, it also anlagse the basic princple of ac impedance measurement, and introduce the design and experiment of handware of the workstation in terms of basic princple of ac impedance measurement. the study of this graduation thesis includs the aspects as follwos : ( 1 ) design of measuring circuit diagram. it is designed for the measurment of usual dynamic potentio - scan, experiment of dynamic potentio - scan

    介紹了電化學工作站的三種基本功能和性能指標，電化學交流阻抗測量的原理，並進而提出了電化學工作站的硬體系統結構，構建了電化學工作站的硬體結構設計; （ 2 ）下位機的介面電路板和測量電路板設計，在設計中力圖提高系統精度、靈活性。
  14. The signal generator of sweep frequency is based on dds device ad9954, the signal measuring circuit is based on gain and phase detector ad8302, the real - time control and deal circuit is based on tms320vc5409, and the periphery interface circuit is based on at89s52. the system can generate sweep frequency signal with the frequency range from 100khz to 150mhz, and with the power range from - 45dbm to + 18dbm. it can measure the gain and phase of the network, display the measure data by liquid crystal displayed and print it by the printer

    該測試儀以dds晶元ad9954為核心構成掃頻信號源電路，以增益相位檢測器ad8302為核心構成檢測電路，以dsp晶元tms320vc5409為核心構成控制與運算電路，以及以at89s52為核心構成外圍介面電路。該測試儀能產生頻率范圍達100k ~ 100mhz ，功率范圍為- 45dbm ~ + 18dbm的掃頻信號，能對被測網路的頻率特性進行測量，並留有豐富的外圍介面，可以將測量數據繪圖通過lcd顯示或者由印表機列印輸出。
  15. In the paper, the design of the real - time test system for crystal parameters is presented. the signal generator of sweep frequency based on dds device ad9852, the signal measuring circuit based on gain and phase detector ad8302, and the real - time control and deal circuit based on tms320vc5416 and the design of high - speed printed digital & analog circuit board are discussed in details

    本文闡述了晶振實時測量系統的設計，介紹了以dds晶元ad9852為核心的掃頻信號源電路，以增益相位檢測器ad8302為核心的信號檢測電路，以dsp晶元tms320vc5416為核心的實時控制與運算電路，以及高速數模混合電路板的設計方法。
  16. Abstract : on the basis of describing the factors affecting the normal work in oil well, for the sake of assuring the production safety. a stable and reliable monitoring system is provided. the sensors used and the measuring circuit to match with the system are also studied

    文摘:在論述影響抽油井正常工作諸因素的基礎上，為保證安全生產作業，提出了一種性能穩定、可靠的監控系統，並對該系統中採用的傳感器件及測量電路等進行了討論。
  17. According to the research of the performances of various temperature sensors, this paper designed a new duty cycle modulated digital thermometer configuration of low power consumption, which includes temperature sensing circuit, first - order - modulate circuit and digital duty cycle measuring circuit

    通過對各類集成溫度傳感器性能和特點的研究，設計了新的低功耗占空比調制型數字體溫計電路，包括溫度傳感電路、一階-調制電路和數字占空比檢測電路。
  18. The main works are listed as follows : ( 1 ) based on the excitation of bi - directional current pulse technique, a new measuring circuit for weak variation of resistance was proposed for electrical resistance tomography. traditional ac current source is n ' t adopted as the exciting source. through fast bi - directional current switching, the polarization effects are eliminated

    該電路主要優點如下：該電路沒有採用傳統的交流電流激勵法作為系統的設計原理，而是通過快速的正負極性電流切換來削弱直流電流激勵時激勵電極的極化效應，使通過直流法來測量氣液兩相流的電阻微弱變化成為可能。
  19. The signal measuring circuit of coulostatic polarization is described in this paper based on ad622 and ad1674. the principle and structure of coulostatic monitor controlled by 80c31 microcomputer is also reviewed

    介紹了基於ad622和ad1674的恆電量極化信號檢測電路的設計，並對以80c31微處理器為控制核心的恆電量腐蝕監測系統的結構進行了闡述。
  20. ( 3 ) an ert experiment system is developed base on the new resistance measuring circuit. this system is entirely designed as a field - bus instrument. instructions are sent from the pc to execute some work such as parameter configuration, fault - checking and data - acquiring

    （ 2 ）基於該新型高速微弱電阻變化測量電路研製了一套完整的電阻層析成像系統，該儀表完全基於工業現場儀表模式設計，上位機通過rs232 rs422總線向下位機發送指令完成故障檢測、參數配置、數據採集等各種功能。
分享友人
分享到 Line

分享到臉書