measuring transmitter 中文意思是什麼

measuring transmitter 解釋
測量信號發生器
  • measuring : n. ,adj. 測量（的），測量用（的）。 remote measuring 遙測。
  • transmitter : n 傳送者；傳達者；寄交者；傳導物；遺傳者；【無線電】發送機；發射機；發報機；送話機，話筒；【火箭...
  1. Viz. sbwz246pw g230 300150 0100 means integral temperature transmitter, pt100, 24vdc, 420ma, power - output is two - wire, no integral indicator indicator, water - proof joint box, fixed screw thread, tube diameter is 16 total length is 300mm, insert depth is 150mm, measuring range is 0100

    裝非隔離型防爆標志為exdbt4 ，則型號為： sbwr256ty g25dd 1000850 2001600保護管材料鋼玉管，固定螺紋m121
  2. When install, first the two ellipse oval flange on positive - negative pressure measuring container of transmitter would be take off, then take three valve units install on transmitter, turn tighten four screws, final take ellipse oval flange solidly install on three valve units

    安裝時選將變送器正負壓測量容室上的兩只橢圓形法蘭取下，然後將三閥組安裝于在變送器上，旋緊四個螺釘，最後將橢圓形法蘭牢固安裝在三閥組上。
  3. The measuring instruments of the pt - compact family can be delivered based on either pt 100 or pt 1000 or as a high value measuring system with integrated transmitter 4 - 20ma 0 - 10v

    我們提供的pt -緊湊型系列的測量儀是基於pt100或pt1000或集成了傳送器的高位值測量系統4 - 20ma 0 - 10v 。
  4. Viz. lpb8101dnm 01. 6mpa shows a silicon pressure transmitter, gauge pressure, lcd integral indicator, accuracy of grade1, general type, m20 1. 5 of process connection, power - output is two - wire, 24vdc, 4 - 20ma, measuring range is 01. 6mpa

    可承受1 . 5倍測量范圍的過載壓力，經保護變送器免遭沖擊過載損害。
  5. Note 4 : installation dimension used in the cable and pole transmitter, if measuring range of well water - level is 10 m, installation dimension is 11 m, then extra 1 m use to installation regulating, actual measurement is 10 m and does not notice. cable type approves height regulation is 1 m pole type users should be detail noted the installation dimension

    注4 ：安裝尺寸在纜式及桿式變送器使用，如測量水井水位量程10m安裝尺寸11m ，則多出1m作安裝調節用，實際測量為10m ，不註明，纜式默認1m高度調節，桿式用戶應詳細註明安裝尺寸。
  6. Note 3 : installation dimension used in the cable and pole transmitter, for example measuring range in water - level of well is 10 m, installation dimension is 11 m, then extra 1 m acts as installation regulating use. actual measurement is 10 m and does not notice. cable type approves height regulation is 1 m, pole users should be detail noted the installation dimension

    注4 ：安裝尺寸在纜式及桿式變送器使用，如測量水井水位量程10m安裝尺寸11m ，則多出1m作安裝調節用，實際測量為10m ，不註明，纜式默認1m高度調節，桿式用戶應詳細註明安裝尺寸。
  7. Measuring uncertainty verification of 0. 25 precision pressure gauge and 0. 5 pressure transmitter

    5級壓力變送器的測量不確定度評定
  8. Function of three valve units is take signal from lead pressure point introduce the positive - negative pressure measuring container of transmitter, to realize on or off between lead pressure point and measuring container, and on off between positive and negative pressure container, also can use as differential pressure balance check zero and when remove transmitter as cut - off valve

    三閥組的作用是從引壓點將信號引入變送器的正負壓測量容室，實現引壓點與測量容室之間接通或斷開，以及正負壓測量容室之間接通或斷開，亦可作為差壓平衡檢測零點用和卸變送器時作截止閥用。
分享友人
分享到 Line

分享到臉書