melting method 中文意思是什麼

melting method 解釋
熔煉方法
  • melting : adj. 1. 融[熔]化的。2. 心軟的，受感動的，易感動的。3. 使人感動的，使人感傷的，溫柔的，動人的。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Therefore, seeking the new method of deicing or snow - melting is of great importance to our daily life

    因此，尋求新型的融雪化冰方法具有非常重要的意義。
  2. The samples with smaller grain sides were obtained in our experiment, and the properties are corresponding with that of those samples prepared by melting method mentioned previously. several approaches can be proposed for further increasing the thermoelectric properties. preparation of the material with different compositional deviations availably controlled from stoichiometry is one of the ways to change the carrier concentration, and hence to optimize the value of power factor

    該方法獲取的塊體樣品的片狀顆粒的粒度遠小於熔煉法制備的樣品，樣品的性能也與熔煉法相當，如果能有效控制樣品的化學計量比，提高生成物的純度將會更大程度的提高材料的熱電性能。
  3. Test method for melting point of petroleum wax cooling curve

    石油蠟熔點的試驗方法
  4. Plastics. polyamide resins. determination of melting point. meniscus method

    塑料製品.聚酰胺樹脂.熔點的測定.凹凸鏡法
  5. Afterwards, the remnant lactic acid in lactide was measured by non - aqueous titration with sodium methoxide and the remnant water was surveyed by karl - fisher method. the melting point was investigated by thiele tube and the characteristics of lactide were analyzed by ir, uv spectrum, tg and dsc respectively

    然後，用甲醇鈉非水滴定法測定丙交酯中殘存乳酸，卡爾-費休法測定丙交酯中殘存水的含量，用提勒管測定精製丙交酯熔點，用紅外吸收光譜、紫外光譜、差熱分析對合成的丙交酯以及回收的丙交酯進行表徵。
  6. Used the genomic dna extracted by low melting - point agarose embedding method as pcr template, the full length of structural genes of bacillus subtilis bio operon were gained by long pcr method

    將該方法提取的基因組dna稀釋100倍作為模板，採用長距離pcr方法，獲得了枯草桿菌生物素操縱子基因全長。
  7. Isolate and synthetic aroma chemicals. method for determination of melting point

    單離及合成香料溶點測定法
  8. Plastics. polyamide resins. determination of melting point. so - called capillary tube method

    塑料製品.聚酰胺樹脂.熔點的測定.毛細管法
  9. Plastics. solid phenolic resins. determination of melting range by the capillary tube method

    塑料製品.固態酚樹脂.用毛細管法測定熔化范圍
  10. The molecular dynamics simulation method has been used to study the relation between the melting temperature and the cohesive energy of pb nanofilms

    摘要本文利用分子動力學方法研究了鉛納米薄膜的熔化溫度與結合能的關系。
  11. This research regarded pp grafted mah as compatibilizer, took the method of masterbatch and use new technologies prepare into high relatively content masterbatch of ommt, finally, this kind of masterbatch and pp were mixing and melting together and pp / mmt nanocomposites were prepared through pairs of spiral pole, ( series pp - b ), meantime, pp / mmt nanocomposites without compatibilizer were compared to study ( series pp - a )

    本研究以pp接枝馬來酸酐為相容劑，採取母粒法，運用新型工藝制備出蒙脫土含量較高的接枝母粒，然後將這種母粒與pp通過雙螺桿共混熔融擠出制備出pp蒙脫土納米復合材料（ pp - b系列） ，同時比較研究了不加相容劑的pp蒙脫土納米復合材料（ pp - a系列） 。
  12. Standard test method for melting point of petroleum wax cooling curve

    石油蠟熔點的試驗方法
  13. Dye intermediates general method for the determination of melting range

    染料中間體熔點范圍測定通用方法
  14. Therefore, in this paper, two directional solidification methods, czochralski method and electron - beam floating zone melting method, were used to obtain such material. the directional solidifition microstructures of si - tasi2 system was performed using neophot - 1, amray - 100b sem and jem - 2000cx tem analysis technique

    本文採用切克拉斯基法（ cz法）和電子束區熔法（ ebfzm ）兩種定向凝固方法制備該共晶自生復合材料；藉助金相技術、電鏡技術、圖象處理技術等多種分析測試手段，考察了si - tasi _ 2共晶定向凝固組織和及其相應的工藝規范。
  15. Preparation of layered limno2 by melting method and its modification

    熔融法合成層狀錳酸鋰及改性研究
  16. The microstructure of the polycrystal remains to be optimized to achieve good performance. to reduce the high cost and high - energy expedition of melting method, a solvothermal process followed by a sintering procedure of compacted pellets produced by using cold isostatic pressure method were mentioned to prepare polycrystalline samples of the ternary ( snte ) x ( bi2te3 ) y compounds

    為彌補熔煉法高成本，高能耗等諸多缺陷，本文還採用溶劑熱法，成功合成了bi _ 2te _ 3和三元（ snte ） _ x （ bi _ 2te _ 3 ） _ y化合物，並採用冷等靜壓成型，結合常壓燒結的方法制備塊體樣品。
  17. The single - slag steel melting method affected by the main process parameter of arc furnace

    電弧爐主要工藝參數對單渣法煉鋼的影響
  18. The melting method for determination of the main elements in silicate with the x - ray fluorecent spectromenter is established

    摘要用x -射線熒光光譜儀建立了熔片法測定硅酸鹽中主量元素的測定方法。
  19. Polypropylene staple fiber used by melting method

    熱熔法用丙綸短纖維
  20. The melting method for determination of the main elements in silicate with the x - ray fluorecent instrument

    射線熒光光譜儀熔片法測定硅酸鹽中主量元素
分享友人
分享到 Line

分享到臉書