metal liner 中文意思是什麼
metal liner
解釋
金屬襯殼-
The solution of heating expansion and cold contraction to eliminate the heating expansion and cold contraction, we embed metal mesh into ptfe liner
熱脹冷縮的解決方法:採用ptfe層中加鋼絲網，來消除熱脹冷縮，提高強度，消除蠕變。 -
The stove liner of blast furnace is damaged seriously for the influence of iron water melting metal, chemical corrosion of stove residual and furnace lump in the middle and later term
摘要由於鐵水熔融金屬以及爐渣的化學侵蝕和爐瘤的影響，高爐中後期爐襯受損嚴重。 -
The liner of turbine draft tube in ankang water power station was punched by cavitation, which leads to welding crack, metal shed and concrete delve, water spurting out. the cause of the damage is analyzed, the treatment is expounded
論述了安康水電站水輪機尾水管里襯被汽蝕破壞穿透、焊縫開裂、撕裂掉塊、混凝土掏空、大量噴水的事故原因及處理方法。 -
Abstract : the liner of turbine draft tube in ankang water power station was punched by cavitation, which leads to welding crack, metal shed and concrete delve, water spurting out. the cause of the damage is analyzed, the treatment is expounded
文摘:論述了安康水電站水輪機尾水管里襯被汽蝕破壞穿透、焊縫開裂、撕裂掉塊、混凝土掏空、大量噴水的事故原因及處理方法。 -
By adopting unique technique, we mount metal outside the special ceramic liner so that the ceramic liner for mud pump can take the advantages of special ceramics, including high hardness, good anti - wear ability and small coefficient of thermal expansion
缸套是泥漿泵的主要易損件，由於工作條件十分惡劣，金屬缸套不耐腐蝕，使用壽命短，在地層復雜的條件下鉆井時，常因更換缸套而影響鉆井效率，此項工作勞動強度大。 -
Based on characteristics of the whole manufacturing process enclosed the winding, cure and autofrettage processes for the composites filament wound vessel with metal liner, a methodology for the prediction of the induced process stress field has been developed
摘要基於具有金屬內襯復合材料纏繞容器纏繞、固化和預超壓3個製造工藝過程的特點，提出一種溫度參數當量法模型和虛實單元分析策略，以模擬在纏繞預張力工藝中的力學行為。 -
Numerical simulation of curing process for filament wound pressure vessel with metal liner
具有金屬內襯復合材料纖維纏繞容器固化過程的數值模擬 -
Finally, a non - linear finite element method on the basis of the classical plastic theory was introduced to analyze the distribution of residual stress field in the filament winding layers and metal liner after the autofrettage process
採用經典塑性理論為基礎的非線性有限元方法，預測了預超壓工藝后容器復合材料纏繞層和金屬內襯內殘余應力場的分佈。
分享友人