meter flow-rate 中文意思是什麼
meter flow-rate
解釋
儀表流量-
Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。 -
Standard test method for volumetric flow rate of metal powders using arnold meter and hall funnel
用阿諾德測量計和霍爾漏斗測定金屬粉末體流率的標準試驗方法 -
The advantages and the disadvantages of every structure and every flow rate dividing method are analyzed. further requirement of techniques and problems to be investigated are pointed out in this chapter. then it presents a new idea of flow rate dividing method based on pressure decrease sensing and meter - in flow rate feedback control to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第一章緒論綜述了多執行器系統的概念、基本構成和一些分流控制方法，分析了各種分流控制結構和分流控制方法的優缺點，在此基礎上指出了一些所需要進一步研究的問題；接著提出了論文的選題意義和一種基於壓差傳感和執行器進油側流量反饋的分流控制方法來實現大小慣性多執行器流量合理分配的構想。 -
Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system. special analysis about simultaneously operating multi - actuators with different inertia loads is made. finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient
第三章介紹了基於執行器進油側流量反饋的分流控制的原理，並針對大小慣性執行器同時起動時採用該分流控制方法進行了具體分析；最後通過模擬說明該分流控制方法能在大小慣性執行器同時起動並在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，並能實現優先級和分流比混合控制。 -
The watts 994hmb fire hydrant backflow preventer meter meets or exceeds registration accuracy for the low flow rate, normal operating flow rate, and maximum continuous operation flow rate as specifically stated in awwa standard c701
美國瓦茨994hmb消防栓防迴流閥儀表滿足或優於美國自來水廠協會（ awwa ） c701標準規定的最小流量、正常工作流量和最大持續工作流量的記錄精度。 -
In order to meet the needs for measuring the coolant water flow rate in - core of a nuclear heating reactor, two types of turbine flow meter with low rotation speed have been developed in our institute
為適應核反應堆堆芯冷卻劑流量測量的需要，開發研製了新型低速渦輪流量變送器，按流量信號輸出不同，分別為磁感應模擬信號輸出和數字開關量輸出低速渦輪流量變送器。 -
It brings about the problems of low flow - used ratio and bad harmony in flow dividing control when simultaneously operating multi - actuators with different inertia loads. this paper is aimed to solve these problems by method based on pressure decrease sensing and meter - in flow rate feedback control of actuators. in this paper, several important points including theoretical analysis, computer simulation, and experiment study will be explained
本論文主要針對因執行器所驅動慣性負載的差異而引起流量利用率低和協調性不佳的問題，提出了一種基於壓差傳感和執行器進油側流量反饋的分流控制方法，並進行了相應的理論分析、模擬研究和實驗研究。
分享友人