micro sensor 中文意思是什麼

Mems ( micro electromechanical system ) has become one of the most rapidly development technologies. along with the rapid development of mems techniques, capacitive sensor is used widely whose capacitance changes small, which has put forward the new request to the measurement technique. the common measure for capacitance measurement is that convert capacitance to voltage, electric current or frequency. the area of polar plate of the capacitor becomes smaller and smaller, and the total capacitance of micro capacitive sensor is usually several pico farad only. as a result, its change amount is smaller

Mems （ microelectromechanicalsystem ）近年來發展最快的技術之一，隨著mems技術的快速發展，電容式加速度計的電容變化變化量越來越小，對檢測技術提出了新的要求。在電容式傳感器中，常用電容檢測電路是將其轉換為電壓、電流或者頻率信號。目前的微型電容傳感器的極板面積變得越來越小，電容總量只有幾個pf ，變化量就更小。

The glass adherence craft has avoided the temperature, humidity, machinery fatigue and medium to the glue water and material influence, and then improved the sensor long - term stability in the industry ambient, in the meanwhile also avoided the sensor p - n effect phenomenon that appeared in the traditional micro machining operation manufacture process

玻璃粘接工藝避免了溫度濕度機械疲勞和介質對膠水和材料的影響，從而提高了傳感器在工業環境中的長期穩定性能，同時也避免了傳感器在傳統微機械加工製造工藝過程中出現的p - n結效應現象。

And the interfaces have analog input, analog output and digital input / output. we have used differently cards, such as pc - 6330d a / d card, pcl - 728 d / a card based isa bus, ipc - 5375 i / o card and so on. in addition, we select micro - stir switches and pressure sensors as sensor elements to inspect the system and choose relays and induction valves to control the bicycle pump and the motor

總線採用isa內部總線；介面主要有模擬量輸入介面、模擬量輸出介面、開關量輸入輸出介面等，課題分別選用pc - 6330d型a d板卡、基於isa總線的型號為pcl - 728的d a板卡、型號為ipc - 5375的i o板卡；另外，課題選用了微動式行程開關、壓力變送器作為傳感元件檢測系統，選用繼電器、電磁控制換向閥實現對氣缸、電機的控制；採用vc + + 6 . 0編制控制軟體，實現了纖維鋪放技術的計算機控制。

The sensor adopted micro melts technology and introduce aviation application science and technology ; using high temperature glass the micro processing silicon voltage dependent resistance strain gauge to melt on the stainless steel diaphragm

傳感器採用的微熔技術，引進航空應用科技，利用高溫玻璃將微加工硅壓敏電阻應變片熔化在不銹鋼膜片上。

After the high - g arrayed micro - accelerometer was designed and fabricated successfully, this paper analyzed the characteristic signal of accelerometer in order to supply the theory sustain for the application of sensor

本文在鉆地引信用高g陣列式微加速度計的成功研製基礎上，首先對加速度計試驗信號進行特徵分析，為傳感器應用提供理論依據。

With the development of micro - electronic, sensor technology and communication technology, wsn develops rapidly and has made a great progress recent years. what ’ s more it has been used in some military and civilian applications successfully

隨著微電子技術、傳感器技術及通信技術的發展，無線傳感器網路技術發展迅猛，在軍事與民用方面的一些具體應用取得了成功。

The micro force sensor for micro friction testing

微摩擦測試的微力傳感器設計

One thick necks ’ thickness measuring instrument with high precise and high efficiency is researched in this dissertation. one special flexible hinge gauge head is designed, differential solenoid inductance displacement sensor is chosen and modern micro - processing technology is used to meet the demand of measuring accuracy

本文通過設計一種專用柔性鉸鏈測頭，採用差動式螺管型電感位移傳感器並結合現代微處理技術，對撓性接頭細頸厚度的高精度高效率測量裝置進行了研究。

An intensity modulated fiber optic micro - accelerometer with a digitally feedback circuit is designed. this sensor employs a graded index lens with a reflective coating on one end and measures the relative displacement between the lens and a pair of optical fibers

在本系統中設計了脈沖數字式再平衡迴路，使得該微型光纖加速度傳感器和一般的光纖傳感器相比，又具有動、靜態性能較好，精度、穩定性較高等優點。

According to the guidline, two nd : yag lasers have been designed and set up, one is end - pumped by lower output power ld using a selfoc micro lens, and the other is end - pumped by high output power ld using a pair of lenses are designed, and the characteristics such as output power and power stabilization of both solid - state lasers are investigated. thirdly, when an empty liquid crystal cell is inserted in the cavity of the nd : yag laser pumped by high power ld, the laser can operates in single axial mode. finally, according to the relationship between the laser output power and the longnitudinal a ld - end - pumped nd : yag laser sensor for displacement measurement has been investigated theoretically and demonstrated experimently, the results indicate that when the mean radius of pumping inside the laser cavity is far less than that of the oscilating laser mode, the exponential of the output power is a gauss function of the longitudinal positon of focused spot of ld pumping beam, both the measurement range and the sensitivity are dependent on the incident pumping power, as the incident pumping power is increased, the measurement range is enlarged and the sensitivity is improve d

本文首先介紹了ld泵浦nd ： yag激光器的發展狀況、主要特性及其應用，從四能級速率方程出發，推導了ld泵浦nd ： yag激光器的閾值、輸出功率和斜效率的表達式，並簡述了激光器的工作原理、結構型式和倍頻方法；其次，以空間相關的速率方程為基礎，提出了ld端面泵浦nd ： yag激光器的設計方法，給出了一定泵浦耦合方式下，振蕩光模尺寸、最佳輸出耦合率、泵浦光模尺寸、泵浦光焦斑位置等參數的選取依據，以此為依據，設計了自聚焦透鏡耦合小功率ld泵浦nd ： yag激光器和透鏡組耦合高功率ld泵浦nd ： yag激光器，對激光器的輸出功率和功率穩定性等特性進行了實驗研究；再次，在帶尾纖輸出的高功率ld泵浦nd ： yag激光腔內插入一隻空液晶盒，觀察到了激光器以單縱模運轉；最後，根據泵浦光焦斑端面位置對激光輸出功率的影響規律，提出了ld端面泵浦nd ： yag激光位移傳感新方法，並進行了理論和實驗研究，研究結果表明：當激光晶體內泵浦光平均光斑半徑遠小於振西安理工大學碩士學位論文蕩光束腰半徑時，激光輸出功率的自然指數與泵浦光焦斑的縱向位置成高斯變化規律，測量范圍和靈敏度依賴于泵浦功率，隨著泵浦功率的增加，測量范圍擴大，靈敏度提高，當端面泵浦功率為7 . 24w （最大輸出功率為1 . 926w ）時，激光位移傳感器的測量范圍和靈敏度分別是13 . 045mm和0 . 148mw / pm 。

Test for micro air pressure semiconductor sensor based on micro - hotplate

微加熱板式半導體微氣壓傳感器的測試

We have accomplished a primary explore of the checkout system, such as, the design of imaging optics road, the calculation and selection of sensor, the selection of digital processing chip. we utilize dam6416p board and ccs2. 2 software to put up a micro - dot simulation system

本文完成了該檢測系統的初步探索：根據幾何光學原理，設計了成像光路的方案；完成所需圖像傳感器分辨能力的計算和型號的選擇；完成了數字信號處理晶元的選擇，及對模擬開發系統的學習和初步應用，並利用基於tms320c6416晶元的dam6416p模擬開發版和集成開發環境ccs2 . 2 ，搭建了一個顯微網點處理系統，從而驗證了系統的可行性。

Mathematical modeling and shock analysis on micro inertial sensor

微慣性傳感器建模及沖擊響應分析

Flexibility, processability, low cost, interesting optical - electric properties and so on make organic materials be a good substitute for inorganic ones. modification of inorganics by organics can change surface properties of inorganics, for example, frictional, optical, electrical, chemical and biocompatible properties. on the other hand, many interests have been shown to integration of functional organics in si - base devices because of their great promise in optoelectronic, micro - electronic and sensor applications

通過對無機半導體材料進行有機改性，可以改變無機材料的表面化學性質，生物相容性質，光電性質等等，因此，有機無機復合材料在光電器件、生物傳感、微電子器件的應用領域有著很好的應用前景，尤其是在微電子工業中廣泛使用的硅材料與有機光電材料的復合更是備受關注。

In the beginning, the working principle, testing and data processing system of pdl micro - control material test machine is introduced ; then more attention is paid to the hardware system which is composed of high precision raster linear displacement sensor, high precision force sensor, the digital displaying sets, the interface equipments and the controlling circuits etc to perform the data collection and ensure the testing precision of the whole system

論文首先介紹了pdl材料拉伸試驗機的工作原理、測試及數據處理系統；接著詳細介紹了由高精度光柵線位移傳感器和壓力傳感器、數顯裝置、介面裝置及控制電路等組成的新的硬體系統，來完成數據採集，並保證整個系統的測試精度要求。

Combined with researches on propagation characteristics, the micro - current sensor for on - line pd monitoring is developed and the effects of coil number, stray capacitance and loading resistance on pass - band and sensitivity are also studied

同時，結合傳播特性，研究了局部放電在線監測寬帶微電流傳感器，並就線圈匝數、雜散電容和負載電阻等對傳感器通頻帶、靈敏度等性能參數的影響進行了分析。

An output buffer amplifier used in detection circuit of micro sensor

用於微傳感器讀出電路的輸出緩沖放大器

In view of micromation of sensor and mems fabrication processing, mos capacitive oxygen micro - sensor was devised

從傳感器微型化方面考慮，結合mems技術和半導體工藝。

According to theory of semiconductor energy band, the working principle of mos capacitive oxygen micro - sensor was elucidated. 5

設計mos電容式氧氣微傳感器，並從半導體能帶的角度出發，闡明其工作原理。

Based on mos capacitive oxygen micro - sensor, the structure of mosfet oxygen micro - sensor was presented. the heater and temperature sensor are integrated into the device

以mos電容式氧氣微傳感器的分析為基礎，設計mosfet氧氣微傳感器結構，在器件中集成了加熱元件和測溫元件。