modal of vibration 中文意思是什麼

modal of vibration 解釋
振動模態
  • modal : adj 1 方式上的,形態上的;【哲學】(對本質、內容說的)形式(上)的。2 【語法】語氣 (mood) 的;表...
  • of : OF =Old French 古法語。
  • vibration : n. 1. 振動,顫動;擺動;【物理學】振動。2. (心的)震顫。3. (思想情緒的)激動。4. 猶豫。adj. -al
  1. We acquired the system ' s dynamic response when the satellite attitude was adjusted and the mode of the antenna. then modal analysis and dynamic analysis have been done to the satellite - antenna system by using the finite element analysis ( fea ) software of ansys. through the analysis we got the system ' s connatural characteristic, the amplitude - frequency characteristic of harmonic response, the power spectrum density of random vibration response, the maximal amplitude and resuming time of impact response

    其次藉助ansys有限元分析軟體,對系統進行了模態分析和動力學響應分析,獲得了不同天線結構參數下的衛星?天線系統的固有特性,簡諧響應的幅頻特性,隨機振動響應的功率譜密度,以及沖擊響應的最大幅值和恢復時間等。
  2. Structural vibration modal analysis of engine blocks

    發動機機體結構振動模態分析
  3. In the process of solving, poles are obtained from recurrent formula, modal vector are obtained from superposition formula not residuary. decoupled equation is derived when vibration source is part correlation, severely coupling appears in the process of input and output then frequency response function cannot directly get according to method mentioned above, decoupling is first problem

    當輸入完全相關時,頻響函數無解,可繞過頻響函數,直接運用線性系統的迭加原理來求響應,極點由遞歸公式得出,模態矢量由疊加公式求出,而不是由留數求得的相應的公式。
  4. With dynamical modal analysis of electron gun by use of ansys software, we can get the inherent frequency and vibration model, which can avoid sympa - thetic vibration

    利用ansys軟體對電子槍進行動力學模態分析可以得到電子槍的固有頻率和振型,從而在結構設計上避免共振。
  5. The seism response analysis of aqueduct bridge is analyzed with modal superposition method based on response spectrum which participant mode of vibration chooses the former 1 0 steps and combinatorial method was srss

    渡槽的地震反應分析採用振型分解反應譜法,參與振型取前10階,組合方法用srss法,求得結構的地震作用效應。
  6. Presents the model proposed for analyzing the vibration characteristics of shrouded blades and their calculation method by employing a wave propagation theory and modal synthesis technology coupled with a finite element method from the view point it is possible not only to conduct frequency modulation of the shrouded blades of a gas turbine, but also to utilize the friction effects between them to dissipate energy, thereby attaining the aim of vibration alleviation, as shrouded blades have been widely used in the design of high - speed turbomachinery, such as modern gas turbines and steam turbines, and with the shrouded blades forming an integral whole in a centrifugal force field, the vibration characteristics of the whole ring of blades are different from those of a single isolated blade, and this makes it essential to take into account the integral effect of blade shrouds, concludes from the calculation examples and engineering application that the above approach is valid and correct along with the possibility of considerably reducing the scale of calculation and analysis, and points out it is necessary to take into consideration the coupled effect of the whole ring of blades while the dynamic characteristics of shrouded blades is being analysed

    帶冠葉片不但能調頻,還可以利用葉冠之間的摩擦效應來耗散能量,達到減振的目的.帶冠葉片在離心力場中形成一整體,其整圈葉片振動特性不同於單個孤立葉片,需考慮葉冠的整體效應.利用帶冠葉片系統的循環對稱性,提出了採用波傳播理論和模態綜合技術,結合有限元方法研究燃氣輪機帶冠葉片振動特性的分析模型和計算方法.算例和工程應用證明了該方法是效性的、正確的,並可以大大降低計算分析規模.研究表明帶冠葉片動力特性分析時必須考慮整圈葉片的耦合效應
  7. On the bases of carrying out idle operation, cutting and modal experiment of certain numerical controlled lathe, it is determined that weak dynamic stiffness in the spindle component of machine tool is the reason in the respect of structure for causing cutting vibration of machine tools

    摘要在對某型數控車床進行空運轉、切削及模態試驗的基礎上,確定了機床主軸部件動剛度薄弱是引起機床切削的結構顫振方面的原因。
  8. In chapter 4, the model - building principle and calculating method of finite element dynamic analysis for large - sized assembled structure are discussed. the substructure model for hydropower house vibration analysis is established to obtain precise modal of generator floor. the harmonic vibration assumption is adopted to calculate house structure ' s dynamic response from hydraulic excitation force of hydraulic turbine generator unit

    第四章討論了大型組合結構有限元動力分析的建模原則和計算方法,建立水電站廠房振動分析的下部結構模型,對巖灘廠房進行整體模態分析,較準確地得出發電機層樓板自振特性;同時引進簡諧振動假定,迸行了機組水力振動作用下的廠房結構的動力響應分析。
  9. Then a simplified computational modal of damping isolation systems is established for a platform structure, and the relationships between the parameters of isolation layer and structural damping ratio, including their vibration - suppressed effect on the whole structure and the relative displacement of isolation layer are studied, and the simulation analysis under several representative load case of random wave force and earthquake affairs is performed. under random wave force, using complex mode theories, non - classically damp problems considering the interaction between the structure and wave, lying in deepwater, are studied. and the resolution solution of structural response are achieved. the results of calculating and analysing show that adding damping isolation to a jacket is an effective way to reduce vibration for offshore platforms

    針對某一典型平臺結構,建立了海洋平臺結構阻尼隔振體系簡化計算模型,進行了波浪荷載工況和地震工況的數值模擬,研究了隔振參數與結構阻尼比的關系以及它們對結構整體和隔振層層間相對位移的控制效果,運用復模態理論研究了位於較深水位的固定式導管架海洋平臺在隨機波浪力作用下考慮結構與波浪相互作用時運動方程中非經典阻尼的解耦問題,獲得了結構響應的解析解。
  10. Basing on rc simple supported beam the study of the paper is modal analysis using the finite unit software ansys, and the relationship among the transformation of vibration frequency, value of attached load, position of attached load, degree of damage, position of damage is discussed

    本文利用大型有限元軟體ansys針對工程常用的鋼筋混凝土梁橋進行了模態分析,討論了振動頻率的變化與附加荷載大小、附加荷載位置、破損程度、破損位置之間的關系,研究了混凝土梁橋從完整階段到破壞階段振動頻率的變化規律。
  11. The frequence and modal of main stream piping were analysed under the condition of different velocity of stream and the valve taken as the centralizing mass. this paper also gives the responses of steady state under the condition that the frequency of forced vibration is 4hz 、 8hz 、 12hz respectively

    將閥門作為集中質量處理,分析計算不同蒸汽流速下,某汽輪機主蒸汽管道系統的振動頻率和振型,並給出了激振力頻率分別為4hz 、 8hz 、 12hz時該管道系統的穩態響應。
  12. Then, the experimental modal analysis method was applied to the study of vibration performance of current mem system

    然後,運用實驗模態分析方法對現有熔融擠壓成形設備的振動性能進行深入研究。
  13. Testing datas are gathered by using data picking box cras. a general dynamic model for analyzing characters of vibration system has also been developed according to the input and output applied on the testing system. identifications for structure modal parameters and frequency - spectrum characters have been carried out by calling the interface software developed unpon matlab software in both the time field and the frequency field. the structure modal parameters and frequency - spectrum characters have been accurately calculated

    利用cras數據採集箱的數據採集功能對系統的信號進行數據採集,通過介面軟體調用matlab軟體平臺,分別針對時間域和頻率域兩種研究方向,解決振動系統模態參數的辯識問題和結構的頻譜特性分析問題,得到系統的相干函數等頻譜特性,獲得模態參數,如模態頻率、阻尼等的精確解。
  14. The four parameters ( spring inclination a, the frequency of excitation force w, the amplitude of excitation force f, the spring stiffness k ) are the major factors that take great influences on the vibration plate. in order to analyzing the influences of four parameters, the virtual prototype of vibration plate is built in ansys to get inherent frequency from modal analysis. thorough transient analysis in ansys, the curves of displacement n velocity and acceleration is presented

    為了分析這四個參數對系統的影響,首先在ansys中建立振動排秧盤的虛擬模型,採用有限元方法對模型進行了模態分析,得到振動排秧機構的固有頻率;同時對模型進行動力學分析,分析排秧盤的振動量、速度及加速度,並得出相應數據的曲線圖;另外,校核了主要元件彈簧的疲勞強度及使用壽命。
  15. On the model of the optimum design, it ' s proceed modal of fea ; with the superior design, structural vibration period is studied for providing the theories calculation of construction engineering ; calculating many load cases, some parameters are given and provide the beneficial datum for actual engineering. the research in task evinces the construction cost can be reduced by optimize design and has good dynamic characteristic. optimum technology has a better project applying value in structural design

    並在優化設計模型的基礎上,對其進行模態有限元分析;研究其在最優設計條件下,結構自振特性問題,為工程結構的動力分析提供理論計算依據;同時對剛架進行多工況荷載組合抗震計算,得出地震作用參與荷載工況組合時,各設計參數間的關系並得出結論,為實際工程設計提供有益的參考資料。
  16. The effective law on the frequence and modal of vibration due to the fluid velocity, the fluid press and the number of elements was obtained

    得出流體流速、流體壓力、劃分單元個數等對管道的頻率和振型的影響規律。
  17. It is right that the modal of discontinuous phase method measures blade vibration parameters and the monitoring system has a good perspective in engineering application

    結果證明間斷相位法的計算模型是正確的,研製的葉片振動狀態監測系統有良好的應用前景。
  18. At present, modal analysis technology has been a important engineer technology in china, it has been a important part of vibration engineer

    目前,模態分析技術已成為一門重要工程技術,模態分析已成為振動工程中一個重要分之。
  19. Nondestructive testing technology includes medium detecting technology and dynamic testing technology which make use of vibration respond of constructure and system dynamic behavior to detect damage in structure. dynamic testing technology is significant not only for the assessing of structures, but also for its economy and convenience, which contains modal parameter identification, extracting and analizing damage indices, determining location of damage, quality assessment and life estimation

    無損檢測包括媒介探測技術和振動檢測技術,其中,振動檢測技術利用結構的振動響應和系統動特性參數探測結構損傷,具有經濟、簡便、迅速、可以進行大范圍構件的質量檢測和評定建築結構整體性能等特點,是目前國內外研究的熱點和難點。
  20. ( 4 ) throw the study of the first four vibration modal of reinforced earth retaining wall and the analysis of twelve reinforced earth retaining walls with different height and different materials using ansys programe, the basic discipline of the first four vibration modals of reinforced earth retaining wall is gained

    ( 4 )對加筋土擋墻的前四階振型進行了研究,採用ansys有限元程序分析了12個不同墻高、不同材料的加筋土擋墻,得到加筋土擋墻的前四階振型的基本規律。
分享友人