mode converter 中文意思是什麼

mode converter 解釋
模變換器
  • mode : n 1 法，樣，方法，方式。2 模，型；樣式，體裁，款式；習慣。3 風尚；〈the mode〉流行，時髦。4 【語...
  • converter : n. 1. 使轉變[改變信仰]的人。2. 改裝者，改裝品。3. 【冶金】煉鋼爐，吹風轉爐；【電，無】換流器，變壓器；變頻器；【自動化】變換器；密碼翻譯[編制]機。
  1. Sliding - mode current control of three - phase ac dc converter

    變換器的滑模電流控制
  2. Based on the thorough investigation of the post - regulation and efficiency in multiple output switching - mode power supplies, an optimal combination topology for multiple output switching converter is presented in this thesis, which is consisted of forward converter with active clamp ( fac ), synchronous rectification ( sr ) techniques and magnetic amplifier technique ( magamp )

    本文通過研究分析近年來多路輸出開關電源輔助輸出電壓調節和提高效率的方案，面對開關電源朝著輸出低電壓大電流方向發展的趨勢，提出多路輸出開關電源新的拓撲優化組合模式? ?有源鉗位正激變換器、同步整流技術、磁放大器。
  3. Then novel circuit structure of bi - directional voltage mode ( based on forward converter ) inverters with high frequency link, are proposed, which is constituted of input cycloconverter, high frequency transformer, output cycloconverter, input and output filter ; the circuit topologies family of this bi - directional voltage mode inverters with high frequency link include six circuit topologies, such as push pull - full wave mode, push pull - full bridge mode, half bridge - full wave mode, half bridge - full bridge mode, full bridge - full wave mode, and full bridge - full bridge mode etc. taking full bridge - full bridge mode circuit as an example, principle of uni - polarity phase shifting controlled bi - directional voltage mode inverters with high frequency link is introduced

    本文首先論述了dc / ac逆變技術的應用前景及發展現狀。基於正激forward變換器的雙向電壓源型高頻環節逆變器電路結構，由輸入周波變換器、高頻變壓器、輸出周波變換器、以及輸入、輸出濾波器構成;雙向電壓源高頻環節逆變器電路拓撲族，包括推挽全波式、推挽橋式、半橋全波式、半橋橋式、全橋全波式、全橋橋式六種電路。
  4. Then, we present a schematic of buck converter by using sliding mode control and then design a circuit based on it

    然後提出了降壓buck變換器的滑動模實現方案，並設計了滑動模控制的buck變換器的電路實現方案。
  5. Circuit simulation demonstrated that the dynamic and static performances of buck converter controlling by sliding mode are better than that of pwm converter

    電路模擬表明，滑動模控制的buck變換器的許多動態性能和靜態性能都優于pwm控制的buck變換器。
  6. Current - mode dc / dc converter adds a current feedback loop on the base of voltage - mode control, achieving both current and voltage feedback loop control

    電流模式dc / dc變換技術是在電壓模式控制的基礎上，增加了電流反饋環，實現了電壓和電流的雙環反饋控制。
  7. Research on modulation strategy of matrix converter to reduce common - mode voltage

    用於抑制矩陣變換器共模電壓的零輸出換相策略
  8. Ogy method is applied to control the chaos exhibited by current - mode controlled boost dc - dc converter, as its chaotic regime has been established in this paper

    本文還使用參數微擾方法控制電流控制模式boost變換器在連續電流模式下產生的混沌行為。
  9. A novel parallel - serial type cttfc ( combined two - transistor forward converter ) with coupled inductor is present in this paper, and the performance of three parallel - serial type cttfcs is studied and compared. the performance of cttfc with coupled inductor is similar to the other two cttfcs while coupling coefficient is less than one and the converter working ccm ( continuous current mode ), and input - to - output voltage gain increase one times while coupling coefficient is one

    本文提出了一種耦合電感並?串型雙管正激組合變換器，並對三種並?串型組合變換器的特性作了比較：耦合系數小於1且耦合線圈電流連續時，三種並?串型組合變換器特性相類似：耦合系數為1時，組合變換器輸入輸出電壓增益增大一倍。
  10. There is difference frequency measurement requirement for every part of pid regulating, difference between dynamic quality and static quality in response time and accuracy. according to these, it use the interrupt functions and high - speed counter of the simens s7 - 200 plc cpu226 basic unit and some peripheral circuit to measure frequency ; in software designed, the procedure frame of hydraulic - turbine governor and disperse process of parallel pid are analyzed, an improved pid algorithm is adopted to realize a pid regulation mode with variable structure and parameters ; the mechanical liquid - pressure system of the hydraulic - turbine governor is with electric - hydraulic converter unit of step motor. according to the drive character of five phase of response step motor, a variable frequency regulated voltage driver unit is designed in order to realize interface between plc and driver of step motor

    本文利用s7 - 200plc自身的特點設計了頻率測量單元，根據pid調節各個環節的特點，以及調速器動態特性、靜態特性對頻率測量的實時性和精度要求的不同，利用s7 - 200plc基本單元中內置的高速計數器以及相應的外圍放大整形、分頻電路，實現了水輪發電機組頻率的測量；在軟體上，對微機調速器的整個程序框架、並聯pid的離散化過程進行了分析，選用改進的pid演算法實現了變參數、變結構的pid調節模式；調速器的機械液壓隨動系統具有步進電機電液轉換元件，採用五相反應式步進電機，根據其驅動特性設計了變頻調壓驅動器，實現plc與步進電機驅動器之間數字介面。
  11. The author of the dissertation pay a lot efforts to focus on designing the dual - loop control circuit based on optimized psm, include : 1 ). researched the relationship of input and output voltage and output valtage ripple, when psm operate in continuous current mode and discontinuous current mode respectively. what we have done will direct psm apply to converter

    本文在psm調制理論的基礎上，設計基於優化psm調制模式的雙環控制電路，主要包括以下幾個方面內容: 1 ）對psm調制模式分別在連續和斷續工作模式下的輸入輸出電壓關系以及輸出電壓紋波進行研究，以期指導psm調制模式在變換器中的應用。
  12. Chaos in three typical topology power electronic converters with a close loop controller is studied. the discrete iterative model is established and analyzed for the chaos in close loop boost converter working in discontinuous conduct mode. the tracking control method is used to control chaos of this converter, simulation results show its effectiveness

    研究了三種典型拓撲結構的電力電子變換器閉環工作時的混沌現象，針對工作在電流斷續模式（ dcm ）下的boost變換器中的混沌現象，分析了其數學模型，並採用軌跡跟蹤控制方法進行了控制，模擬結果表明了該方法的有效性。
  13. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  14. Suppression of common - mode voltage for matrix converter based on svpwm

    空間矢量調制矩陣變換器共模電壓的抑制
  15. A research on common - mode voltage for matrix converter based on two line voltage synthesis

    雙電壓合成矩陣變換器共模電壓的研究
  16. He zero - output commutation strategy for reducing common - mode voltage of matrix converter

    可有效降低共模電壓的矩陣變換器調制方法研究
  17. By the design of microwave electric field mode and microwave mode converter ( mmc ), the thesis participated in equipping an domestic microwave plasma chemical vapor deposition ( mpcvd ) equipment with a quartz glass window and water - cooled stainless steel resonant chamber in 2450mhz / 5 kw, introduced the basic machineries and functions of the sub - systems, including microwave system, gas - route system, vacuum system, detecting system and safeguard system

    論文通過微波場型和模式轉換器的設計，參與建立了一套2 . 45ghz 5kw帶有石英玻璃窗、水冷卻不銹鋼諧振腔的微波等離子體化學氣相沉積（ mpcvd ）系統（ mpcvd - 4型） 。論述了包括微波系統、氣路系統、真空系統、檢測系統和保障系統等結構的組成及基本功能。
  18. A virtual cathode oscillator with an axially extracted te10 or te11 mode has been investigated using the pic code. it can emit microwaves axially through an antenna without mode converter or transition waveguide, making the system more simple and compact. the efficiency of this device can be enhanced by employing premodulation cavity, resonant cavity, feedback mechanism, and virtual cathode formed by two electron beams

    本文利用物理分析和粒子模擬的方法研究了軸向提取te10 / te11模虛陰極振蕩器，結果表明通過引入預調制腔、諧振腔、反饋端面、雙電子束陰極等結構，可以實現結構相對緊湊、束波轉換效率較高的軸向提取虛陰極振蕩器。
  19. Next, the global system architecture is presented upon the design requirements. due to the fact that constant current is required for driving led, as a result, different from conventional current - mode converter with both output voltage and inductor current feedback loop, the proposed converter adopt dual current feedback loop that both inductor current and output current are detected to provide a stable output current for led

    在整體結構設計中，與典型的電流模式採用電感電流反饋環路和輸出電壓反饋環路不同，本文針對驅動led需要電流穩定的特點，採用雙電流反饋環路，即電感電流環路和負載led電流環路，這樣就能對負載led電流做出快速響應，通過反饋環路達到穩定led電流的目的。
  20. Design and experiment study of coaxial fin - inserted tem - te11 mode converter

    11模式轉換器的設計與實驗研究
分享友人
分享到 Line

分享到臉書