modulus of shear 中文意思是什麼

modulus of shear 解釋
剪切模數
  • modulus : n. （pl. -li ） 【數、物】模數，模量；系數。 a modulus of elasticity 彈性模量。
  • of : OF ＝Old French 古法語。
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  1. The derived dry bulk modulus must be positive and greater than 2 / 3 of shear modulus to insure a positive lame constant and poisson ' s ratio

    提取的乾燥體變模量必須為正，並且大於剪切模量的2 / 3 ，以保證拉梅常數和泊松比為正。
  2. Test method for measuring strength and shear modulus of nonrigid adhesives by the thick - adherend tensile - lap specimen

    用厚粘附體拉力搭接樣品測定軟質膠粘劑的強度和剪切模數的試驗方法
  3. Macroscale inversion analysis of measured displacements in tunnel, slope and dam is studied detailedly according to inverse formulation method and direct formulation method. aimed at inverse problem for identifying original geostress parameters and stru - ture modulus of rock, linear hypothesis for shear stress field of slope is proposed. structural model of transversely isotropic medium is constructed

    針對逆源（初始地應力）和逆介質（巖層結構模量）的識別問題，提出了地層剪應力場的線性假定，構造了橫觀各向同性體的結構性計算模型，應用了逆定式化有限元反演方法，快速地搜索到了被識別參數的最優值。
  4. ( 1 ) systematic triaxial compression tests are made for the sand reinforced by various national geosynthetics. comprehensive investigations into the interaction characteristics are also made between sand / lime fly ash and various national geosynthetics by direct shear tests and pull out tests, which can help choosing geosynthetic type and understanding the geosynthetic reinforcement mechanism ; ( 2 ) this paper is also firstly systematically presents the results of a comprehensive investigation into the interaction characteristics between lime fly ash and various national geosynthetics ; ( 3 ) by non - linear fem, the influence of the modulus of geosynthetics, the thickness of the soft ground and the width of the foundation on the effectiveness of geosynthetic reinforcement are also studied ; ( 4 ) the main conclusions are as followed : ( geotextiles are likely to be suited for projects allowing high displacement, polyester warp knitting geogrids and oriented geogrids for projects allowing medium displacement, glass fiber geogrids for projects allowing low displacement and geonets for secondary projects. ( the confining effect of fill material to act on different kinds of geosynthetics varies largely, which must be considered

    （ 1 ）本文利用三軸壓縮試驗，比較各種國產土工合成材料對砂土的加筋效果；利用直剪試驗和拉拔試驗，比較各種國產土工合成材料與砂土或石灰粉煤灰的界面摩擦特性，深入研究土工合成材料的加筋機理，首次明確提出加筋土工合成材料的選型原則； （ 2 ）本文首次系統地研究了石灰粉煤灰與各種國產土工合成材料的界面摩擦特性； （ 3 ）本文採用有限元法，系統研究了加筋模量、軟土地基厚度、基礎寬度等因素對土工合成材料加固軟土地基效果的影響； （ 4 ）本文主要結論如下： （無紡土工織物適合用於允許大變形的加筋土工程；滌綸纖維經編土工格柵和塑料拉伸土工格柵適合用於對變形有較嚴格要求的加筋土工程；玻璃纖維經編土工格柵適合用於對變形有嚴格要求的加筋工程；土工網適合用於低等級的加筋土工程。
  5. An important issue is that the dry bulk and shear modulus of sandstone are tightly correlated in a simple relationship with distribution of porosity, mineral composition, clay content, cementation, and differential pressure

    砂巖的乾燥體變模量和剪切模量與孔隙度分佈、礦物成分、粘土含量、膠結度和差壓的關系是嚴格相關的，這一點非常重要。
  6. Rubber, vulcanized or thermoplastic - determination of modulus in shear or adhesion to rigid plates - quadruple shear method

    硫化或熱塑性橡膠.剪切模量或與硬板粘合強度測定.四倍剪切法
  7. The effects of piles interval, embankment height, cap width, shear modulus of embankment fill, horizontal geotextile tensile strength and pile - subsoil stiffness ratio on pile efficacy, were also carried out

    研究了樁間距、路堤高度、樁頂托板寬度、路堤填土剪切模量、水平加筋體拉伸強度及樁土相對剛度對樁體荷載分擔比的影響。
  8. The results show that pile efficacy is significantly affected by piles interval, embankment height, cap size and pile - subsoil stiffness ratio, while shear modulus of embankment fill has less effect and geotextile strength has a little effect

    結果表明：樁間距、路堤高度、托板寬度及樁土相對剛度對樁體荷載分擔比影響較大，路堤填土剪切模量的影響次之，而水平加筋體拉伸強度的影響很小。
  9. Regarding the rc beams subjected to concentrated load or even load and braced by bonding steel, an analysis is made on the relevant factors influencing maximum anchorage shear stress of steel sheet. the analysis is based on elastic theory and makes use of the formula for calculating anchorage shear stress of steel sheet. as indicated by the results, the maximum anchorage shear stress not only realtes to such parameters as height of cross section of rc beam and span but also relates to the thickness of adhesive layer, elastic modulus, thickness of steel sheet, and length of steel sheet. the present method will check maximum an chorage shear stress on the end of shear sheet so as to prevent rc beam from local damage. the present results will offer important reference for our country to further perfect bracing design by bonding steel method

    在彈性理論的基礎上，利用鋼板錨固剪應力計算公式，對在集中荷載或均布荷載作用下採用粘鋼加固的混凝土梁，分析鋼板錨固最大剪應力的有關影響因數.結果表明，最大錨固剪應力不但和混凝土梁的截面高度、跨度等參數有關，還和粘膠層厚度、彈性模量、鋼板厚度及鋼板長度有關.採用文中方法可以對鋼板端部最大錨固剪應力進行驗算，防止混凝土梁出現局部受拉破壞.研究結果為進一步完善我國粘鋼法加固設計提供重要的參考資料
  10. The following principles are proved : increasing cfp adhesive length will release the concentrating of shear stress near the cutoff point, this will lead to the increment of loading - bear capacity of concrete beams ; increasing the thickness of cfp will improve the transition of load from concrete beam to cfp, this is useful to exert the potential of cfp ; in creasing the anti - shear modulus of adhesive will result enhance the concentrating of shear stress, this is harmful to the effect of cfp reinforced concrete beams

    本文的理論分析結果可以表明：增加碳纖維板的粘結長度可以緩解碳纖維板端部界面上的剪應力集中，改善混凝土梁結構的加固效果；增大碳纖維板的粘結厚度可以增大界面上的剪應力，改善混凝土樑上載荷向碳纖維板的傳遞效果，有利於充分發揮碳纖維布的潛能；如果粘結膠層的抗剪模量過大會加劇剪應力的集中，從而對碳纖維加固的效果不利。
  11. The experiments show all the compression strength shear strength, elastic modulus of the composite blocks and their masonry can satisfy the requirements of standard compared to concrete, the haojiao materials elastic modulus is so low that we ignore it ' s improvement to the composite block ' s compression strength. however the area of horizontal mortar joint of composite block masonry is enlarged just because of the haojiao materials " existence, so the shear strength of composite block masonry is higher than one of small hollow betonblock masonry in thermal performance, the heat - preservation and heat - insulation capabilities of composite block masonry are analyzed and researched

    試驗表明：復合砌塊及其砌體的抗壓、抗剪強度、彈性模量等均滿足規范規定的要求；由於昊角材料與混凝土相比，彈性模量相差懸殊，在受壓時，可以不考慮昊角材料芯塊對復合砌塊及砌體抗壓強度的提高，同時又因為昊角材料的存在，砌體水平灰縫面積增大，復合砌塊砌體的抗剪強度較空心砌塊砌體有較大的提高。
  12. Base on the elastic half space theory of the dynamic foundation, analyzing the relationship between the vibration frequency and the dynamic shear modulus of the soil, a relationship between the vibration frequency and the self - property of the subsoil can be carried out. that is the expression about the relationship between the vibration frequency and the density of the soil can be carried out

    通過採用動力基礎半空間理論，分析錘擊產生的地基土的振動頻率與地基土的動剪切模量之間的相關關系，就又可以得到地基土自振動頻率與土體本身性質之間的關系，即與土體的密實度之間的關系。
  13. The main dynamic parameter of the subsoil is the dynamic shear modulus. base on the data of the experiments, analyzing the relationship between the dynamic shear modulus and the characteristic parameters such as the density, the water content and the shear distortion, the expression of the dynamic shear modulus of the subsoil is picked out

    地基土的主要動力參數為土的動剪切模量，而利用實驗所得的數據，分析動剪切模量g與地基土的干密度（孔隙比） 、含水量以及地基土的剪切變形等參數之間的關系，就可以得到地基土的動剪切模量的表達式。
  14. The framework and results of this study is thus summarized as follows : 1. analyzing the effect of the nonlinear parameters on seismic response. so far the g / g _ max - ( transient dynamical shear modulus over the maximum shear modulus vs. shear strain ) and the - ( equivalent shear hysteretic damping ration vs. shear strain ) curves are widely employed in the experimental method in studying soil dynamic property, supposing under equiamplitude cyclic load

    目前，人們利用實驗手段分析土體動力特性時給出的最基本的描述量是g g _ （ max ） ?曲線（等效動剪切模量與最大動剪切模量的比值隨應變幅值變化的曲線）及?曲線（等效剪切滯回阻尼比值隨應變幅值變化的曲線） 。
  15. Physical testing of rubber - method for determination of modulus in shear or adhesion to rigid plates - quadruple shear method

    橡膠的物理試驗.第a14部分:剪切模量或剛性板粘著力的測定方法.四重剪切法
  16. Aerospace - fibre reinforced plastics - testing of unidirectional laminates ; determination of shear strength and shear modulus in tension

    航空航天.纖維增強塑料.單向層壓製品試驗.拉伸剪切強
  17. Then the formu1a of computing the maxima1 top shear stress in designing masonry bui1dings and the method of checking computations of cracks are brought forward in this paper on the basis of the theoretica1 deduce and the data of these tests and experiments. a1so, the practica1 construct methods and the requirements of preventing such cracks in the aspects of the construct rate. the strength and modulus of e1asticity of the masonry bui1dings are put forward

    隨后，本文在理論推導和試驗數據的基礎上，提出了在砌體結構設計中計算頂層最大剪應力的公式和是否開裂的驗算方法，並且從施工進度、砌體的強度及彈性模量、構造柱和圈樑的設置等方面提出了防止此類裂縫開展的具體施工方法和要求。
  18. Standard test method for shear modulus of wood - based structural panels

    木基結構板剪切模數的標準試驗方法
  19. Dynamic shear modulus of soils

    動剪切模量
  20. Effective modulus of composite materials with doubly periodic rigid line inclusions of unequal length subject to antiplane shear

    含雙周期不等長剛性線材料有效反平面剪切模量研究
分享友人
分享到 Line

分享到臉書