molecular pressure 中文意思是什麼

molecular pressure 解釋
分子壓力
  • molecular : adj. 分子的,由分子形成的,分子內[間]的。adv. -ly
  • pressure : n 1 壓；按；擠；榨。2 【物理學】壓力，壓強；大氣壓力；電壓。3 精神壓力，政治[經濟、輿論等]壓力。4...
  1. For the pressure to become zero, molecular bombardment must cease.

    當壓強趨近於零時，分子的碰撞就停止了。
  2. Constituting 60 % of total plasma protein, and with low molecular weight, albumin contributes about 80 % of the colloid osmotic pressure

    因其占血清總蛋白質的60 %和低分子量的特性，白蛋白司職約80 %的膠體滲透壓。
  3. In the forth chapter, the sl threshold pressures for bubbles with different noble gases were measured experimentally. results show that the threshold pressure increases with the decrement of molecular mass for gases inside the bubbles

    氣泡內的惰性氣體不同使氣泡內的絕熱系數和熱擴散系數不同，惰性氣體的原子質量越大，氣體的絕熱系數就越大而擴散系數就越小。
  4. The studies show they are practical and promising functional molecules for opto - electronics. the following works put fc16ab to study physical chemistry properties of its monolayer and lb films with other molecules. the conclusions are as listed below : the surface pressure - molecular area ( - a ) isotherms of fc16ab and hexadecyltrimethylammonium bromide ( ctab ) on aqueous subphases were studied

    結論如下：在純水亞相上，我們通過比較十六烷基甲銨鹽（ ctab ）和fc _ （ 16 ） ab的單分子膜壓力-單分子面積（ - a ）等溫線，得到二茂鐵片段的在氣液界面的取向隨著膜壓的增加而發生改變。
  5. This paper analyzes the percolation mechanism and characteristics of gas under low - velocity percolation state in terms of slippage effect and threshold pressure effect by using molecular dynamics, thermodynamics and percolation mechanics in order to understand the practical reason of low - velocity non - darcy percolation

    摘要為明確氣體在低速滲流狀態下的滲流規律以及產生低速非達西滲流的實質性原因，運用分子動力學、熱力學和滲流力學等相關知識，基於滑脫效應和閾壓效應兩方面分析了氣體在低速滲流狀態下的滲流機理及滲流特徵。
  6. 05. 01 molecular weight of hydrocarbons by thermoelectric measurement of vapor pressure, method of test for

    用蒸氣壓力的熱電測量法測定烴類分子重量的試驗方法
  7. Standard test method for relative molecular mass molecular weight of hydrocarbons by thermoelectric measurement of vapor pressure

    蒸氣壓力熱電測量法測定烴類相對分子質量
  8. The technology involved in providing a continual stream of high purity nitrogen is pressure swing adsorption. this technique uses a bed of carbon molecular sieve to selectively remove oxygen and other contaminants from atmospheric air

    碳分子篩從空氣中分離氮氣的原理是根據空氣中氧和氮在碳分子篩中不同的擴散速度或不同的吸附力以及兩種效應同時起作用的結果。
  9. The molecular structure of the sputtered titanium oxide films were investigated by xps and x - ray diffraction. it was found that the ratio of ti / o increases when pressure increases, and there is a optimum ratio of ar / o2 for the sake of obtaining more tio2 on pet surface

    利用x射線衍射法（ x - ray ）對濺射沉積膜的表面物相結構進行了研究，發現在本實驗室條件下濺射生成的膜均是無定型結構。
  10. Molecular dynamics simulation of mgo melting at high pressure

    熔化特性的分子動力學模擬
  11. Molecular dynamics simulation of melting in mgo at high pressure

    材料高壓熔化特性的分子動力學模擬
  12. The results from basic properties, shear resistance, pressure strength and point film test show that different low molecular polyamide may affect extrodinary by the properties of cured expoxy resin the higher viscosity, the lower cured activity ( rate ) ; the higher amine number, the stronger cure construction. the cured expoxy resin will prossess unfavourable mechanics when it is cured by the polyamide with both too high viscosity and amine number

    用基本性能、剪切強度、抗壓強度、塗膜性能測定等方法研究了3種不同胺值及粘度的低分子量聚酰胺對環氧樹脂固化物性能的影響.結果表明，聚酰胺粘度大使固化交聯變難，胺值過高易造成固化收縮；同時粘度過大、游離胺含量過高的產品將對固化物各項力學性能不利
  13. The study indicates that, the slippage effect is a combined result of gas molecule slip on capillary wall and gas molecular diffusion inside capillary tube, and also a result of combination of concentration and pressure fields

    研究認為，氣體滑脫效應是毛細管壁處氣體分子滑流和毛細管內部氣體分子擴散的綜合效應，是濃度場和壓力場作用疊加的結果。
  14. The spinning conditions include spinning methods, the pressure and types of filling liquid, the pes concentration, the molecular weight of pvp and peg and the coagulation length in the first coagulation bam

    紡制條件包括:紡絲方法、填充液的壓力和種類、聚醚礬質量分數、聚乙烯毗咯烷酮的相對分子質量、聚乙二醇的相對分子質量以及在第一凝固浴中的凝固長度等。
  15. Many academicians researched their formation and accumulation mechanism and put forward manifold mechanisms, including the special mechanism of minority liquid molecular controlling the accumulation of lens reservoir by unknown gravitation, difference between liquid pressure compelling hydrocarbon to accumulate firstly in the lens reservoir, along cranny in the case of hydrocarbon replacing pore water in the lenticular body under capillary pressure, difference breakthrough employing hydrocarbon entering lens reservoir and so on

    國內外學者提出了多種成藏機制，包括未知重力運動機製作用下，少數流體分子的個別特性控制透鏡狀砂巖油藏聚集；毛細管力作用下油氣替換透鏡體中的孔隙水；烴濃度差是油氣向砂體運移的主要動力；流體壓力差使油氣首先沿著裂隙向砂巖透鏡體中運移、聚集而成藏；差異突破作用使砂巖透鏡體成藏等。
  16. Abstract : this paper analyzes the reason of pressure drop increase of the downstream equipment - coldbox caused by water penetration of the molecular sieve in jngcc, summarizes the treatment, and gives recommendations

    文摘:對工廠生產中分子篩水「穿透」造成其下游裝置? ?冷箱阻力增大的原因進行了認真的分析，總結了處理方法及分子篩處理后的運行狀況，並提出了改進建議。
  17. High - pressure leak - blocking technique of high molecular grouting resin

    樹脂高壓注漿堵漏技術
  18. Presently the condition of most researches about molecular - sieves work at normal temperature and ordinary pressure

    目前對于分子篩吸附特性的研究集中在常壓環境。
  19. Change in the molecular weight distribution of gelatin by a high pressure slurry jet method

    用高壓漿料噴射法來改變明膠的分子量分佈
  20. Molecular dynamics study mgsio3 perovskite under high pressure

    3的分子動力學研究
分享友人
分享到 Line

分享到臉書