moled 中文意思是什麼

moled 解釋
模壓的
  1. The influence of yaotukang on the blood rheology of hypostasis - moled mice and the mesenteric microcirculation of hypostasis - modeled rats as well as the anti - inflammatory and anal - gesic effect of yaotukang : an experimental study

    腰突康對血瘀模型大鼠血液流變學和小鼠腸系膜微循環的影響及其抗炎鎮痛作用
  2. Zhao jiamin ( condensed matter physics ) directed by prof. wang lijun the organic electroluminescence ( el ) device with microcavity ( moled ) can take on some new characteristics, such as narrowed spectrum, intensity enhancement, sharply directed emission in space, due to the microcavity effects compared with the common device without cavity ( oled )

    將微腔引入有機電致發光器件中，由於微腔效應的存在，可以獲得多種不同於普通發光器件的發光特性，象譜線窄化，強度增強，發光方向性增強等。
  3. Oled and moled are made with heat evaporation

    論文敘述了用熱蒸發的方法製作oled及moled的過程。
  4. Using the typical moled structure glass / dbr / ito / htl / eml （ etl ） / al ， the el spectrum narrowing, intensity enhancement in the normal direction as well as emission intensity redistribution in space are observed. by the introduction of single layer silver film instead of the dbr / ito multilayer, a ( / 2 - length cavity is obtained. using this kind of microcavity, three - color single mode pl from a single material alq and three - color single mode el from double layers pvk / alq are achieved for the first time

    通過以金屬銀替代多層結構的dbr / ito ，既作為反射鏡，又作為el器件中的空穴注入電極，設計出腔長只有（ / 2的超短微腔，採用同一種寬譜帶材料alq作為光發射層，首次報道了三基色單模光致發光和pvk / alq雙層結構的三基色單模電致發光。
  5. In making moled, metal film substitutes dielectric films and anode according to technical conditions

    利用現有的工藝條件，在moled的製作中採用了金屬膜以替代介質膜和陽極。
  6. In this paper, a few physical issues are discussed and several device design methods are proposed on moled

    本論文就有機微腔電致發光中的幾個物理問題和器件設計進行了研究探討。
  7. This paper states design approach, computing process and result of microcavity organic light - emitting device ( moled )

    論文論述了微腔有機發光器件（ moled ）的設計方法、計算過程和結果。
  8. Theoretical analysis shows : compared with oled, moled with alq3 as light - emitting layer can emit different wavelength light by modulating length of cavity, spectral full width at half - maximum of moled changes from 100nm to 10nm ~ 20nm and the light intensity at peak is increased by about 20 times, and luminous efficiency can be enhanced

    理論分析表明：通過調節腔長，用alq3作發光層的moled可以發出不同中心波長的光，譜線寬度由oled的約100nm變為10 ~ 20nm ，峰值光強提高20倍左右，總發光效率也有所提高。
分享友人
分享到 Line

分享到臉書