multiple timing 中文意思是什麼

multiple timing 解釋
幾個秒錶同時計時
  • multiple : adj 1 多重的;復合的 復式的 多數的 多樣的。2 倍數的 倍。3 【電學】並聯的;多路的 復接的。4 【植物...
  • timing : n. 1. 時間選擇。2. 定時,校時,計時,調速。3. 【自動化】同步;時限。
  1. Traditional multiuser detector make good use of all signals which resuilt in multiple access interference so that it provides optimum mai resistance. ( 1 ) nevertheless, it assumes that the receiver can acquire the signature waveform and timing of desired user and the interfering users ; ( 2 ) it has no ability to suppress intercell multiple access interference ; ( 3 ) it cannot be applied in downlink channels. adaptive multiuser detector eliminates the need to know the signature waveforms and the timing of the interferes and has to need training data sequences for every active user

    傳統多用戶檢測在單用戶檢測技術基礎上,充分利用造成多址干擾的所有用戶的信息進行聯合檢測,從而具有良好的抗多址干擾能力,但存在一些缺陷: ( 1 )不僅要求知道期望用戶的地址pn碼及其定時信息,還要求其他干擾用戶的地址pn碼及其定時信息; ( 2 )不能消除其他相鄰小區的多址干擾對本小區的影響; ( 3 )不能直接應用在cdma移動通信系統中的下行鏈路。
  2. After analyzing and comparing different partition rules, md32 pipeline architecture is finally defined, which meets the required instruction function, frequency and timing spec of md32. a complete set of creative design method for risc / dsp md32 micro - architecture is presented, such as parallel design, internal pipeline, central control, etc. thanks to the adoption of these design methodology, control path and data path are separated, circuit delay is reduced, and complex instruction operations are balanced among multiple pipeline stages

    它們將若干復雜指令操作均勻分配在幾個流水節拍內完成,實現了任意窗口尋址等復雜指令操作,將整個處理器的數據通路與控制通路分離,減小了電路時延,從而滿足了risc dsp不同指令功能和系統時鐘頻率的要求,構成了統一的、緊密聯系的、協調的md32系統結構。
  3. ( 3 ) based on principle analysis and simulation, the main parameters are obtained. and the hardware solution is proposed - parallel processing system with multiple dsp. ( 4 ) the design of the software used to control logic and timing is presented

    ( 4 )在硬體設計的基礎上,提出了在本系統中實現時序和邏輯控制的軟體(不包括正交波束形成演算法的實現)設計方案(包括系統中斷系統的設計和系統的bootload設計) 。
  4. Some theoretical extensions are first made in this paper, with the following concepts, theorems and models presented - partial derivative and high - order partial derivative of waveform polynomial for describing the relation between input transitions and output transitions and redefining circuit sensitization ; the concept of waveform polynomial vector for describing a circuit with multiple inputs and outputs, especially for the unified description of circuit modules ; a sensitization theorem for sequential circuits for the purpose of exact timing ; theorems for transition numbers in circuits used to solve problems on noise, power consumption and etc ; waveform polynomial description for sequential circuits used to give a unified form for the function and timing behavior of a sequtial circuit ; and a data structure of generalized list for the representation and manipulation of waveform polynomial

    波形多項式偏導和高階偏導的新概念,用來精確描述輸出跳變與輸入跳變之間的關系,並在本文中用來重新定義了電路的敏化和冒險;波形多項式向量的概念,用於形式化描述實際中的多輸入多輸出的電路,特別是用於統一描述電路模塊的功能及定時行為;時序電路的敏化定理,用於時序電路精確定時分析;波形多項式描述跳變及跳變數的定理,用於噪聲、功耗等問題的描述;時序電路的完整波形多項式描述,用於時序電路功能和定時行為的統一描述;波形多項式的多項式符號表示和運算的模型以及數據結構,用來實現對波形多項式比較有效的描述和運算。
  5. The problem of signal processing for direct - sequence code - division - multiple - access ( ds - cdma ) signal over multipath frequency - selective mobile channels is considered. a new blind receiver is proposed. without the knowledge of the multiple - access interference users spreading code and the channel characteristics, the receiver achieves blind detection with prior knowledge of only the desired users spreading code and approximate timing. by using reduced rank adaptive decorrelating filter and adaptive multipath combiner which is based on decision - directed algorithm, the receiver gets the ability to combat both fading and the near - far effect at low cost. simulation results demonstrate that the proposed receiver offers high performance

    本文研究多徑頻率選擇性衰落通道下直接序列擴頻碼分多址( ds - cdma )信號的處理問題,提出了一種新型的盲接收機.該接收機不需預知多址干擾用戶的擴頻碼,不需預知通道參數,只需已知期望用戶的擴頻碼和粗略的定時,就可以完成用戶的盲檢測.同時,該接收機通過降維自適應去相關濾波和基於判決指導的自適應多徑合併,來獲得低成本和良好的抗衰落、抗遠近效應性能.模擬結果驗證了本文提出的接收機的優良性能
  6. The algorithm is list - based. the timing - constrained scheduling algorithm reduces the power consumption by assigning as many nodes as possible to the resources operating at reduced voltages. in the paper, we propose three kinds of scheduling algorithms with multiple voltages under timing constraints, which have separately lower time complexity, better optimizing effect and better optimizing capability as a whole

    由於多電壓調度是np - hard問題,本文還採用了一種基於模擬退火搜索的時間和資源約束的調度演算法,該演算法是一種啟發式的搜索演算法,通過與基於gain大小搜索的調度演算法的對比,數據表明兩演算法優化效果接近,但此演算法具有較低的時間復雜性。
分享友人