noise design 中文意思是什麼

noise design 解釋
噪聲設計
  • noise : n 1 聲音，聲響。2 叫喊；嘈雜聲，噪音；喧鬧聲；吵鬧，騷動，騷擾。3 〈古語〉謠言，風聲。4 〈美國〉...
  • design : vt 1 計劃，企圖，立意要…。2 指定，預定；留給，留著。3 設計，草擬，擬定，籌劃；起草，畫草圖，打（...
  1. The optimum design of detector arrays for the attenuation of surface waves and of ambient noise is a complex subject.

    為衰減面波和外界噪聲作檢波器組合的最佳設計是一件復雜的事情。
  2. The press is ingenious in design, hign quality in materials, with features as fine workmanship, handsome appearance, compact structure, higher work pressure, lower work noise, and equipped with single skip. controlled temperature, electric autotimer, so that it will be reliable is operation and easy to repair

    本機設計精巧，用材講究、製造精良、造型美觀、結構緊湊，傳動部分採用大功率雙向電磁離合器，可連續工作，也可單獨工作，且有壓力大、噪音小、單級跳位、溫度自控、電子式時間繼電器延時，操作安全可靠、維護保養方便等優點。
  3. According to the application background and the dismatch between single antenna and differential lna, an active balun is needed and has been designed. then we put forward a design scheme that does co - simulation of an active balun and a differential lna on one chip together. at 2. 45ghz, this lna provides a forward gain of 28. 931db with a noise figure of 2. 485db, while drawing 19. 1ma from a 1. 8v supply

    從本設計的應用背景出發，考慮到單端天線與差分lna之間的不匹配性，設計了一個介於兩者之間的有源平衡轉換電路? balun （ balance - unbalunce ） ，並提出了將這個balun電路與前面設計的差分lna作為一個整體進行了模擬的設計方案。
  4. Design of microwave ultra - broad band low noise amplifier

    微波超寬帶低噪聲放大器的設計
  5. Fluid noise mainly comes from out put pulsation of rate of flow, the main reason of out put pulsation of rate of flow is the instant high pressure return flow that obturation cubage produced when the big round curve pressure transition. the v trough on the port plate can reduce the fluid noise. in this paper, the author based on the acting of dam a river and condensability of liquid and used matlab language as tool to calculate the v trough on the original port plate and drew out the p - t diagrammatic curve and analyzed its shortcoming and improved the design of original v trough and got that the best size of its angle was 12. 3 and its length was 5mm and the cross section was an equilateral triangle

    流體噪聲主要來源於輸出流量脈動，造成輸出流量脈動的主要原因是閉死容積在大圓弧段壓力切換時產生的瞬時高壓迴流，在配流盤上開設v型尖槽可降低因高壓迴流而引起的流體噪聲，本文以截流作用和液體的可壓縮性為理論依據，以matlab語言為工具，對原配流盤上的v型尖槽進行了理論計算，繪制出p - t圖線，分析了它的不足，並對原有v型尖槽進行了優化設計，得出了v型尖槽的最佳幾何尺寸：配流盤平面上的v型尖槽的兩邊的夾角為12 . 3 ，槽長5mm ，槽的橫截面為等邊三角形。
  6. Klingelnberg cyclo - palloid spiral bevel gear has construction cramped, excellent transmission quality, low noise and loaded vehavior, it ’ s the main form of gear drives in the bevel gear ’ s technology field. it ’ s cyclo - palloid system, two - part cutter head and high power gears ( hpg ), has certain technology particular than gleason spiral bevel gear. systemic analysing the manufacture principle and meshing principle of klingelnberg cyclo - palloid spiral bevel gear, for accomplishing design theory and analysis method, for enhancement manufacture precision and loaded behavior, for promotion and applied in engineering field, have important theory value and actuality meaning. main work of the paper is tooth form emulation and tooth contact analyse of klingelnberg cyclo - palloid spiral bevel gear

    克林貝格（ klingelnberg ）延伸外擺線齒錐齒輪結構緊湊、傳動性能優良、噪聲小、承載能力高，是錐齒輪技術發展的主要齒制，其連續切削法，雙層刀盤技術和硬齒面刮削法（ hpg ）相對于格利森制齒輪有一定的技術特點。系統的分析這種齒輪的加工原理和嚙合機理，對完善其設計理論和分析方法，提高加工精度和承載能力，在工程中推廣應用具有重要的理論價值和實際意義。
  7. The design hardly has denies measures so that it is convenient to use while its noise is loud " the article analysis the prime factors of noise quantitatively through the fervency spectrum, and make the ways object to noise, in that it is suggested to improve the energy storage system and raise the system control capability to the moving door so to slow the close velocity

    本文通過頻譜分析，定量化確定了電控門噪音的主要成份，提出了針對主要噪音成份的控制方法。文中對電控門蓄能、運動系統的改進性方案，以達到對蓄能系統的改進和加強對門體運動的控制能力，基本上解決了門體安全閉合時正碰與發出噪音的矛盾。
  8. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中，作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  9. Vibration isolating grommets are standard for every hard drive and a complex airflow cooling design to maximise airflow and cooling effects with minimum noise

    振動絕緣索環對每種硬盤驅動器和復雜的氣流冷卻設計最大限度的氣流和最小限度噪音的冷卻效果中的一種標準。
  10. Such as harmonic distorted in front analog circuit, sample clock shaking, analog power and the noise in ground plane etc. some suggestion of circuit design is given to improve high - speed a / d circuit performance

    在高速模數轉換電路的應用設計中地電源供電設計、模數地平面設計、采樣時鐘設計等方面提出一些具有指導性的意見。
  11. Presents the steady - state programming with constant coolant average temperature and constant live steam pressure, an ideal programming for marine nuclear power plant ( npp ), under which, both the coolant average temperature and the live steam pressure of nuclear steam supply system ( nsss ) are constant when the steady state operating condition is varied, and points out that in comparison with the steadysate programming with constant coolant average temperature, the ideal programming can improve the overall operating performance of npp effectively, especially in low - load range, for instance, raise the heat efficiency of npp, decrease the operating noise of main coolant pump, and improve the conditions of design, operation and control of the secondary loop system

    雙恆定運行方案是船用壓水堆核動力裝置的理想運行方案.在這種運行方案下，當裝置穩態功率變化時，冷卻劑平均溫度與蒸汽壓都保持不變，與通常採用的冷卻劑平均溫度恆定運行方案相比，有效地改善了核動力裝置的總體運行性能，特別是在低負荷運行時，可以提高裝置經濟性、降低主泵運行噪聲、改善二迴路系統的設計、運行和控制條件，這對于提高船用核動力裝置的運行可靠性和安全性具有實際意義
  12. The noise of the micromotor is not only considered as one of reflections of environment inside of automobiles but also reflects the design technics and fitting level of the motors

    微電機噪聲是作為車內環境污染的噪聲源指標，同時也是電機設計、工藝和裝配水平的綜合反映。
  13. As an important target of frequency synthesizer design, phase noise determines system ’ s sensitivity and selectivity whose design is being the emphasis as well as nodus at all times

    它作為頻率合成器的重要指標，決定了系統的靈敏度和選擇性能，一直是設計者的難點和重點。
  14. In practical design, not only nonideal factors from noise, mismatch, offset etc. are taken into consideration, but also the desired sub _ adc performance is achieved with reduced power dissipation

    在具體電路設計中，不僅充分考慮了噪聲、失調和失配等非理想因素，而且在實現系統對子adc的指標限制前提下，降低了功耗。
  15. Surface transverse wave has the 1. 6 high frequency than rayleigh type surface acoustic wave ( using the same technology the frequency of devices of stw has about 1. 6 high frequency than rayleigh type surface acoustic wave ). the paper introduces the theory, design parament, technology and result expeiment of surface acoustic wave ( includes rayleigh surface acoustic wave and surface transverse wave, simple stw ) with low insertion loss, high q and researches the high frequency, low phase noise oscillator with 1ghz stw resonator as frequency element. and describes measurement method and finally experimantal result of the low phase noise surface acoustic wave oscillator

    本文研究了以低損耗、高q值聲表面波（其中包括聲表面瑞利波- - rayleighsurfaceacousticwave ，和聲表面橫波等）諧振器的工作原理、設計參數、製作工藝及其實驗結果，並且研究了以1ghzstw諧振器為頻控元件的高頻率、低相位噪聲聲表面波振蕩器，以及低相位噪聲聲表面波振蕩器的測試方法和最終的測試結果。
  16. Acoustics - recommended practice for the design of low - noise machinery and equipment - part 2 : introduction to the physics of low - noise design iso tr 11688 - 2 : 1998 ; german version en iso 11688 - 2 : 2000

    聲學.低噪聲機械和設備推薦設計慣例.第2部分:低噪聲
  17. At last, some low phase noise pll designs are to be presented by me to verify the theroies of low phase noise design. all in a word, this article provide some meaningfull instruction for low phase noise hopping frequency pll design

    在本文的最後給出了幾個低噪聲鎖相跳頻源的設計實例，對低噪聲鎖相跳頻源設計理論進行驗證，且取得了很高的相噪指標，具有一定的指導意義和參考價值。
  18. This paper mainly introduce the teconology of design modern microwave hopping frequency pll synthesizer with low phase noise. on the foundation of analysis of phase noise performance of pll circuit, i made some reasearch in system shcemes and methods for low phase noise design of microwave hopping frequency pll. some innovative ideas of low phase noise design about pll is presented in this paper

    本文主要研究現代微波鎖相跳頻源低相噪設計技術。在對鎖相環噪聲性能分析的基礎上，對現代微波鎖相跳頻源多種低相位噪聲設計方案進行分析研究。提出了低噪聲鎖相跳頻源設計的一些獨道見解。
  19. How to reduce noise figure of operational amplifier are studied in this paper. through design of a low - noise opa, introduce low - noise design of the input stage in detail. and with the analysis of computer, suitable sizes of the input apparatus are choosed. at last, by simmulation and verification on this opa, the result is satisfied

    研究了如何從電路結構上減少運算放大器的噪聲，以一種低噪聲運放為例，著重介紹輸入級設計，並藉助計算機分析選擇合適的輸入器件尺寸，最後通過對運放噪聲的模擬驗證，得到了滿意的結果。
  20. Today, as the electronic technology is developing fantasticly fast, the request for higher performance of synthesizers is put forward, especially the low phase noise performsnce. as the pll is the main force of modern synthesizer, do a forwad research in technology of low phase noise design is very necessary. for this reason, the paper is mainly focus on the theory and technology of low phase noise pll design

    隨著現代通信、雷達、電子偵察和對抗技術的飛速的發展，對作為核心部件的頻率合成器的性能指標提出了更高的要求，特別是相位噪聲指標。鎖相式頻率合成器作為現代頻率合成器的主流，研究其低相位噪聲合成技術是很有必要的。
分享友人
分享到 Line

分享到臉書