offset method 中文意思是什麼

offset method 解釋
殘余變形法
  • offset : n 1 抵銷，抵銷物，（優點對缺點等的）彌補，補償 （to; against）。2 分支；支脈；【植物；植物學】側...
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. Application of tangent offset method on the revision on cursive track

    切線支距法在曲線校正中的應用
  2. Offset the il offset within the method to look up

    要查找的此方法內的il偏移量。
  3. Measurement of quartz crystal unit parameters - phase offset method for measurement of motional capacitance of quartz crystal units

    石英晶體元件參數的測定.第2部分:用相位偏離法測量石英晶體單元的動態電容
  4. Imposes films and produces offset plates for printing by photomechanical method

    拼大版及以照相法製成柯式平版、供印刷用。
  5. In general, a precise resistor is in series with one of the resistors in wheatstone bridge to compensate the zero offset, and the other one is in parallel with another arm of the wheatstone bridge to compensate thermal zero drift. based on this principle, in this paper, a compensation method based on virtual instrument technology has been put forward. actuated by current source, a good calculation method of compensation resistors and their position in the bridge is deduced

    本文基於串並聯電阻補償法的原理，提出了一種基於虛擬儀器的誤差補償方案，推導了在恆流源供電下可以精確的計算出補償電阻大小和補償位置的演算法，並且在虛擬儀器軟體平臺labview上完成了數據採集、處理、顯示等軟體的設計，經過實驗的驗證，對傳感器的零點溫度漂移補償取得較好的效果，而對靈敏度溫度漂移的工藝補償亦有一定的效果。
  6. The tsf method combines efficiently llsf and tri - cubic spline interpolation, learns from others " strong points to offset one ' s weaknesses, so has rapidity and high accuracy of computation and is suitable for contour surface drawing in real - time. 3

    該方法綜合多元樣條擬合法與局部加權最小二乘法，揚長避短，不僅保證了逼近精度，提高了計算速度，而且加密計算的結果可直接應用於等位面的實時顯示。
  7. 5 ) the system ' s sensitivity and snr can be improved by the method of balancing the standing capacitance using dc offset compensation

    採用直流反饋補償的方法消除電容傳感器極板間的靜態電容，提高了系統的解析度和信噪比。
  8. The carrier wave is modulated directly by the baseband signal at several frequency point in l band and s band. firstly, this paper clarifies the theory of i / q modulation, elaborates evm and acpl, and analyzes the effect of amplitude and phase unbalance and dc offset on evm. secondly we review the basic principle of phase locked loop and it ’ s composing parts, including the basic conception and design method of pll frequency synthesizer, especially introduce the charge pump pll frequency synthesizer in detail

    首先，在闡述i / q正交調制基本原理的基礎上，通過對誤差矢量和鄰近通道功率泄漏的詳細分析，定性、定量地討論了各種非理想電路因素（如相位不平衡、幅度不平衡、直流偏差等）對調制器性能的影響;其次，介紹了鎖相環的工作原理和基本組成部分，包括鎖相環的設計和環路濾波器的設計，特別詳述了電荷泵鎖相頻率源;第三，介紹了採用直接調制技術模擬衛星信號的射頻前端的設計;最後，對整個直接射頻調制系統進行測試，結果基本上達到了課題要求。
  9. The method of combining the simulated annealing algorithms with genetic algorithms not only offset the disadvantages of the simulated annealing algorithms but also enhanced the distributivity and the self - adaptivity of the genetic algorithms

    同時也為遺傳演算法和模擬退火演算法在該項目領域工程中的進一步研究、應用提供理論依據。
  10. According to characteristics of the seismic data from the low snr region with complex surface, this paper is started from solving the static correction problem and reasonable eliminating all kinds of disturbance in the seismic data from the low snr region with complex surface. through the whole process of seismic data processing which includes a series of processing methods that are suitable for the low snr region, namely, from the choosing of the floating base - level, the static correction in the field and indoors, the eliminating of all kinds of noise before and after stacking, the velocity analysis with high - resolution, the reasonable techniques of deconvolution before stacking and wavelet processing after stacking, to the method choosing of the high - resolution stacking and the reasonable and accurate offset imaging, a set of the complete and effective flow for processing seismic data from the low snr region with complex surface are finally formed, which can meet the need of explo

    本文針對復雜地表低信噪比地區地震資料的特點，以解決復雜地表低信噪比地區地震資料靜校正問題及合理剔除各類干擾為出發點，在整個地震資料處理過程中，從浮動基準面的選取、野外及室內靜校正、疊前疊后各類噪音的去除、高精度速度分析、合理的疊前反褶積及疊后子波處理技術、到選用高精度的疊加技術及合理準確的偏移成像方法等一系列適合於復雜地表低信噪比地區的處理方法，最終形成一套較完整且有效的針對復雜地表低信噪比地區地震資料的處理流程。
  11. The estimation of frequency offset is based on pilot symbols and non - pilot symbols. this paper also discusses some parameters in the method and gives the way of compensation. to get the estimation method of doppler spread width, we model the rayleigh channel based on the conclusion of gans ’ spectrum analysis based on clarke model

    其中頻偏估計採用一種基於導頻符號和去極性非導頻符的方法進行估計，並通過試驗環境驗證了此方法，並確定了這個方法中的參數的取值，在此基礎上介紹了本系統中的頻偏補償方法。
  12. Application of arbitrary straight line offset method to highway surveying

    任意直線支距法在公路測量中的應用
  13. A shape design method for satellite antennas with an offset paraboloidal reflector and a single feed

    星載單饋偏置拋物面天線的賦形設計
  14. At the doppler centroid aspect, this paper make use of maximum value method ; energy method and autocorrelation function method to estimate doppler centroid. at the doppler frequency aspect, this paper make use of image offset method ; time - frequency method ; minimum entropy and fractional fourier transformation method to estimate doppler frequency rate

    在多普勒參數估計中，採用了最大值法、能量法和自相關函數法進行多普勒中心頻率估計;採用了圖像偏移法、時頻分析法、最小熵法和分數階傅里葉變換法進行多普勒調頻斜率估計。
  15. Chord offset method

    弦支距法
  16. Application and discussion on the chord offset method for construction survey in underground engineering

    弦線支距法在地下工程施工測量中的應用探討
  17. Measurement of quartz crystal unit parameters by zero phase technique in a - network ; part 2 : phase offset method for measurement of motional capacitance of quartz crystal units

    用型網路的零相位技術測量石英諧振器參數.第2部分:測量石英諧振器的動態電容的相位偏離法
  18. At the last of this paper, we summarized the deficiencies of simulating pre - stressing anchor and proposed the new and accurate simulating method which is given up the traditional tow points applied forces and applied a point reverse forces, made beam element simulate the anchor bolt, made interface element simulate concrete. in addition, we proposed two simulating methods applied on flock anchors which improved on considering the contribution of anchors " tangent - orientation stiff. one is post - stressing offset method ; the other is anchor element method

    另外，本文還提出了兩種改進原有群錨模擬中沒有考慮錨索限制變形的側向剛度貢獻的方法，即后續張拉補償法和錨索單元法，通過平面直線型滑動破壞中這兩種方法與傳統群錨的兩點集中力法的比較、分析，表明這兩種方法的結果與實際情況較為相符。
  19. Measurement of quartz crystal unit parameters by zero phase technique in a pi - network - part 2 : phase offset method for measurement of motional capacitance of quartz crystal units

    用型網路的零相位法測量石英晶體器件參數.第2部分:石英晶體器件動態電容測量的相位補償法
  20. Image offset method that is also fast can be applied to motion compensation, time - frequency method is intuitionistic and have a better accurate, which is applied extensively on offline. fractional fourier transformation method is not accurate, but which have some now application in signal processing

    在多普勒調頻斜率估計中，時頻分析法比較直觀，估計精度也不錯，脫機處理中獲得了廣泛的應用，圖像偏移法估計速度快，在運動補償中得到了應用。
分享友人
分享到 Line

分享到臉書