oil-water meter 中文意思是什麼

oil-water meter 解釋
充油外殼
  • oil : n 1 油；油類；油狀物〈一般是不可數名詞，表示種類時則用 pl 如：vegetable and animal oils 植物油和...
  • water : n 1 水；雨水；露；〈常作 pl 〉 礦泉，溫泉；藥水。2 〈常 pl 〉水體；水域；水道；海；湖；河；海域；...
  • meter : n. 1. 測量儀表，計量器；計，表。2. 計量人；計量官。vt. 用表計算[測量、記錄]。n. 〈美國〉＝ metre.
  1. Voltage meter, current meter, frepuency meter, oil pressure meter, water temperature meter, timer, battery voltage or charging current meter, protection indicator, speed and voltage inching switch and etc

    電壓表電流表頻率表油壓表水溫表計時器電池電壓或充電電流表保護指示燈轉速及電壓微調開關等。
  2. There are petroleum densimeter, petroleum meter, sampling cylinder, heat preservation box, 5m oil gauge, water ruler, water cream, 5m static rope, 5ml glass measurement cylinder and thermometer in the toolbox

    由石油密度計石油計量表采樣筒保溫合5m量油尺量水尺試水膏5m量靜電繩1000ml玻璃量筒溫度計組成。
  3. Oil - water meter

    原油水分儀
  4. Typical monitoring systems are earthquake monitoring system, hydrographic monitoring system, oil monitoring system, autoreading system of water meter, watt - hour meter and gas meter in one and so on

    典型的監測系統如地震監測網、水文監測網、石油監測網、水電氣三表合一的自動抄表系統等。
  5. Finally, the paper expatiates the realization process of this design, including the rotation equipment management, the static equipment management, examines and service project management, the electrical management, the meter computer management, the water quality management, the lubricating oil management, the static seal management, the craft pipeline management, the bearing management, the pressure vessel

    最後，文章對系統的設計實現過程進行了闡述，分別對大慶石化總廠設備管理系統的轉動設備管理、靜設備管理、檢維修計劃管理、電氣管理、儀表計算機管理、水質管理、潤滑油管理、靜密封點管理、工藝管線管理、軸承管理、壓力容器管理、安全閥管理進行重點描述。
  6. Meanwhile coaxial line phase water cut meter has realized dynamic measuring of oil well water cut. and the detecting results objectively represent flowing state in pumping wells

    同軸線相位法含水率計實現了油井含水率的動態測量，其測量結果客觀反應了抽油機井中油水兩相流動狀態。
  7. Logging method and pre - processing method of logging data have been ascertained for the logging tool formed by coaxial line phase water cut meter and other function units such as temperature meter and flow meter. data of 10 oil wells obtained by the logging tool has been interpreted using the soft - measuring model, and the result is accordant with data of ground measurement. it indicates that the soft measurement model of coaxial line phase water cut meter has high interpreting precision

    確定由同軸線相位法含水率計組成的組合測井儀的現場測井方法以及測井數據資料的預處理方法，並利用軟測量解釋模型對現場所測10口井的資料進行解釋，結果與地面計量符合較好，說明同軸線相位法含水率計的軟測量模型在現場測井解釋中具有較高的解釋精度。
  8. The distinguishability and precision of the meter is high. but the accuracy still needs to be improved because of the complexity of water oil two - phase flow and the responding condition of the meter

    儀器具有很好的分辨力和測量精度，但由於油水兩相流動的復雜性以及與儀器響應相關的影響條件的復雜性，含水率的測量和解釋精度有待進一步提高。
  9. Measurement theory of coaxial line phase water cut meter and flowing feature of water oil two - phase flow have been studied in this paper. and it has been found that the response of coaxial line phase water cut meter is not only related to water cut, but also related to temperature, salinity of formation water and flowing characteristics. based on soft - measuring theory and operating theory of the meter, soft - measuring model of coaxial line phase water cut meter has been set up with directly obtainable facts such as flux, temperature of oil and water mixture and salinity of formation water

    本文在對同軸線相位法含水率計的測量機理和油井兩相流動特性研究的基礎上，揭示出同軸線相位法含水率計的儀器響應除了與油井含水率有關之外，而且還與油水混合介質的溫度、地層水礦化度以及兩項流動狀態有關；結合軟測量技術理論和同軸線相位法含水率計本身的測量機理以及與儀器響應有關的可以直接測量的流量、油水混合介質的溫度、地層水礦化度等參數，建立基於同軸線相位法含水率計機理的軟測量模型。
  10. The measuring range of coaxial transmission line phase water cut meter is 0 - 100 %. therefore, it can meet present situation of oilfield exploitation, which for most oil wells water cut is high, because of the using of water - driving in oil production, while for some single well or different layers in a well water cut is low

    同軸線相位法含水率計的測量范圍為0 100 ，適應了當前油井以高含水率為主，而單井含水或單井不同層段的含水可能較低的油田開發狀況。
  11. To ensure the stability and reliable, we apply iso9000 manage system in every step of manufacturing and engineering. our products are widely used in oil, water, power, railway, heat system, transportation, factory automation, army, wireless meter. ect

    在此協議中， adi公司負責ic的開發設計生產和市場推廣安美通公司作為adi的第三方approved design house ，負責ic客戶維護， ic運用產品的開發設計。
  12. Water - level meter is generally used in the automatic supervision and control system of water conservancy, rock oil, chemical industry, metallurgy, electric power etc. based on the abundant experience of domestic and abroad intelligent meters, the meter presented in the paper is designed via advanced microchip, which integrates the functions such as data collection and storage, display and remote communication and can be used in various fluid level and strobe opening scale measurements

    水位計廣泛應用於水利、石油、化工、冶金、電力等領域的自動檢測和控制系統中。本文設計的智能水位計是吸收了國內外最新智能化儀表的設計經驗，採用工業控制單片機，集水位採集、存儲、顯示及遠程聯網於一體，適用於各種液位及閘門開度的測量。它具有高精度、高可靠性、多功能和智能化等特點。
分享友人
分享到 Line

分享到臉書