operate voltage 中文意思是什麼
operate voltage
解釋
操作電壓-
An adjustable high voltage supply to operate the counter is necessary.
必須備有一臺供給計數器用的可調高壓電源 -
Because of the elements which run under nonideal linearity and unentire symmetry in the power system, the loads which are different and change randomly, the methods which adjust and control the system faultily and operate improperly, the disturbance and the malfunction which happen somewhere, the current and voltage in the supply system are distorted seriously and thus large amount of harmonics are produced
但是，由於電力系統元件運行的非理想線性或非完全對稱、負載的性質各異且隨機變化、調控手段的不完善以及錯誤操作、外來干擾和各種故障的存在，供電網中的電流（電壓）發生畸變，產生大量諧波。 -
Operate voltage : 12 - 24v d. c. - enclosure : inflammable plastic
-外殼物料:不助燃防火膠料 -
Series reactor is applied to ac power system with rated voltage of 6kv - 63kv and series connected with shunt capacitor banks for restraining wave distortion in grid voltage so as to improving the quality of power system and ensure the safety of its operation. it can restrain harmonic current and surge current in capacitor banks so that the capacitor will operate reliably
Ckdk型串聯電抗器，適用於6 63 kv電力系統中，與並聯電容器相串聯，用以抑制電網電壓波形畸變，從而改變電網質量和保證電力系統安全運行抑制流過電容器組的諧波電流和限制合閘涌流，從而保護電容器的安全可靠運行。 -
Sensitive element is one of the important to measure the concentration of mathane, and it " s export is a little voltage signal, little signal amplify circuit is to transform the analogue signal to digital signal, display circuit is to display the concentration of mathane, monitoring circuit is to monitor the overstep limit of mathane concentration. the feature is new design, accurately measure parameter, convenient to operate and so on
其中cpu是監控儀的核心，完成數據採集、處理、輸出、顯示等功能；敏感元件是準確檢測甲烷氣體含量的主要元件之一，其輸出是與甲烷濃度相對應的電壓信號；小信號放大電路則是用來放大敏感元件輸出的電壓信號； a d轉換電路把放大了的電壓信號由模擬信號變為數字信號送入cpu ；顯示電路則顯示實時甲烷濃度；報警電路對超限甲烷濃度進行報警。 -
Sb2015 - 3 precision decade dc resistance box adopts high voltage glass glaze resistors and special high voltage seal switch. its electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used to calibrate insulation resistance meter, and suitable to be used as high resistance standard
3型精密十進位直流電阻箱採用高壓玻璃釉電阻器及獨特的高壓密封開關，電性能穩定可靠、絕緣強度高、可在不斷開測試電壓的條件下調節電阻值（正在使用的那隻開關不處在「 0 」位置時） 、操作方便，適用於檢定/校準絕緣電阻表，也可作為高阻標準。 -
Sb2015 - 2 precision decade dc resistance box adopts high resistance superfine glass silk and special high voltage seal switch. it electric performance is very stable and insulation intension is very high. the resistance value can be adjusted under the condition of ceaselessly opening voltage ( note : the using switch should not be at the point of 0. ) it is easy to operate and suitable to be used as dc resistance standard to calibrate insulation resistance meter
2型精密十進位直流電阻箱採用高阻玻璃微細絲電阻器及獨特的高壓密封開關，電性能穩定可靠、絕緣強度高、可在不斷開測試電壓的條件下調節電阻值（正在使用的那隻開關不處在「 0 」位置時） 、操作方便，適用於檢定/校準絕緣電阻表，也可作為直流電阻標準。 -
Therefore, the a / d converter should be able to operate with the small supply voltage of the entire system
因此，模數轉換器應該能夠運作在整個系統的小（低）供電電壓下。 -
The author of the dissertation pay a lot efforts to focus on designing the dual - loop control circuit based on optimized psm, include : 1 ). researched the relationship of input and output voltage and output valtage ripple, when psm operate in continuous current mode and discontinuous current mode respectively. what we have done will direct psm apply to converter
本文在psm調制理論的基礎上，設計基於優化psm調制模式的雙環控制電路，主要包括以下幾個方面內容: 1 ）對psm調制模式分別在連續和斷續工作模式下的輸入輸出電壓關系以及輸出電壓紋波進行研究，以期指導psm調制模式在變換器中的應用。 -
It is evident from above two expressions when the btl circuit and the ocl circuit operate under same power supply voltage and same load, the output power of the former is four times of that for the latter
對比以上二式不難看出：橋式電路和單端電路在電源電壓和負載相同條件下，前者的輸出功率為後者的四倍。 -
Purpose of the rectifier transformers is to operate with the ac / dc power converters connected to them, to adapt the power line voltage to the voltage required by the load but can ' t provide galvanic separation between load and power line
整流變壓器的作用是連接到ac / dc電源轉換器上將電源側電壓轉換為負載所需電壓但不提供負載和電源之間的電隔離。 -
In order to ensure the whole system operate economically, power department equip transformer with onload tap changer and shunt capacitors for most distribution substations, according to the operating condition, adjusting the position of transformer taps and capacitors can control the variation of voltage and reactive power exchanger of distribution substations and power system in certain extent
為確保整個系統運行經濟性，降低網損，電力部門在大多數變電站配置了有載調壓變壓器和並聯補償電容器組，根據運行情況適當調節變壓器分接頭的位置和投切並聯補償電容器組，可以降低電壓變化和變電站與系統的無功交換控制在一定的范圍內，確保供電質量和電網運行的經濟性。 -
We use a isolating impedance between the gas diode and the silicon avalanche diodes, to permit the gas tube to operate properly and to permit the low energy avalanche diode to perform its voltage limiting function - without being damaged
我們在氣體二極體和硅雪崩二極體之間使用一個隔離阻抗，使氣體放電管正常地運作，同時又使低能量的雪崩二極體發揮其電壓限制功能，而不遭受損害。 -
The optical switch with double - heterostructure gaas / gaalas has low switching - voltage and light loss. and the boa - type optical switch utilizes maximum modal dispersion ( a p ), does not require a specific fabrication length or length range to operate, has simple structure, and can exhibit very high extinction - ration from its two output ports ; so it is suitable for a 2 x 2 unit of optical switch array
而boa型結構（或稱為零間隙定向耦合型）光開關利用了最大的模色散（ ） ，不需要嚴格控制特殊的製造長度或製造范圍，結構簡單，從其兩個輸出端可以得到很高的消光比，是一種很好的2 2波導型光開關單元，同時也是光開關陣列的一種較好的選擇。 -
By adjusting the automatic tracing coil of arc extinction for switch stand and analysing technical parameters of arc extinction coil in normal operation, the paper indicates some problems should be taken care of, so as to operate properly automatic tracing coil, to remove the excess voltage of grounded arc and to ensure reliable power supply
摘要通過調試開關站自動跟蹤消弧線圈，分析自動跟蹤消弧線圈正常運行技術參數，指出設計運行中應注意的問題，保證自動跟蹤消弧線圈正常運行，消除弧光接地過電壓，保證可靠供電。 -
To test the time parameter, namely, is to test the operate time, release time and bounce time when the relay ' s winding is put or removed the rated voltage. these parameters ( especially the bounce time ) are very essential to relay ' s rated load
檢測時間參數的目的是檢查繼電器在線圈施加或切除額定電壓時的動作、釋放、回跳及穩定時間，這些參數（特別是觸點回跳及穩定時間）對繼電器通過額定負載是很重要的。 -
The zero - voltage - switching ( zvs ) pwm hybrid full - bridge three - level ( h - fb tl ) converter can operate in both three - level mode and two - level mode, the output rectified voltage is close to the output voltage over the entire input voltage range, thus the output filter can be reduced significantly, leading to high power density and fast dynamic response. so the zvs pwm h - fb tl converter is very attractive for the applications such as fuel cells, photovoltaic cells, and telecom power supplies, where the voltage varies in a wide range
零電壓開關復合式全橋三電平（ zero - voltage - switchingpwmhybridfull - bridgethree - level ， zvspwmh - fbtl ）變換器可以工作在三電平模式和兩電平模式，在很寬的輸入電壓范圍內，輸出整流電壓都接近輸出電壓，從而可以減小輸出濾波器，因此可以提高變換器的功率密度和改善動態性能。 -
With the application of real - time multi - tasks mechanism and modulization software structure, the controller can set and modify the parameters on - line, collect and process the real - time data of the four - battery charge / discharge devices, termly and digitally regulate the closed loop and monitor the real - time faults, so that the system can control different styles of charging and discharging operate mode such as in constant current style, constant voltage with limited current style and static style
控制器軟體採用實時多任務機制和模塊化的設計思想，通過對蓄電池化成充放電過程中工藝參數的在線設定修改、實時數據的採集處理、定時的數字閉環調節和故障的監測，實現對蓄電池靜電、恆流、恆壓限流等多種充放電工作方式的控制。 -
It emphases the selection of secondary voltage of the step - down transformer, the control and protection of thyristor, the calculation of compensation capability and group capability, the technique of cross - zero switched on / off capacitors or reactor, the solution of avoiding possible resonance in switching on / off groups of capacitors or reactor and the measure of the best time to switch ( including the design of the computer survey and control system, instrument deliver system, delay operate and protect system ). although thyristor as a no - contact switch can avoid almost the problem of contact switch with contact, it can not solve the over - voltage, over - current and transient process itself as switching on / off capacitors or reactor. so we must develop a set of thyristor - switched control and protect system with great reliability so that it can realize of cross - zero switching on / off capacitors or reactor at any time
晶閘管具有過零、動作快速的特點，本研究以晶閘管為電容器和電抗器的分組投切開關，重點研究了協調變壓器二次電壓的選擇、晶閘管觸發控制及保護、動態補償容量及分組容量的計算確定、過零投切電容器和電抗器技術的實現、以及分組投切電容器和電抗器可能發生諧振的處理計算方法，給出實現最佳補償投切選擇方法（測控系統、儀表變送系統、操作和保護系統的設計步驟） ，研製了一套高可靠性晶閘管觸發控制及保護系統，實現對無功的靜止可調補償。 -
The recursive criterion of transient current protection based on mallat wavelet transform is presented in order to meet the real - time demands. the reserch shows deficiency existed in the prevenient principle of transient current protection, so a new improved scheme of transient current protection is proposed. the characteristics of transient protection at different bus distribution capacitance is also analysed in this thesis. the study shows that operate of transient protection is correct when the bus distribution capacitance change. other conclusion include : the trip of transient protection must be locked when the power circuit breaker of transimission line operated, because the trip is incorrect at this time ; the features of transient current and it ' s energy is different between the fault and thunder over - voltage in transimission line, and them can be identified ; the ratio of high frequency component of current in serise capaciters compensation line, svc and hvdc system is far little than fault transient current, so all of them do not affect the working of trasient current protection
應用功率譜估計方法討論了故障高頻暫態噪聲信號在頻率軸上的分佈情況，利用功率譜分析結果實現的非參數化系統辨識方法研究了母線分佈電容對電流高頻暫態信號的衰減特性。論文的後半部分（第五，六，七章）著重分析了現有基於故障電流的暫態保護原理和判據存在的問題，提出了新的實現方案，並討論了暫態電流保護的運行性能。利用多分辨分析和小波分解快速演算法構成的遞推暫態保護判據，可以準確區分故障線路和非故障線路，實現超高速暫態電流保護，計算更為簡單方便，計算速度更快。
分享友人