ordinary temperature 中文意思是什麼

ordinary temperature 解釋
常溫
  • ordinary : adj 1 普通的，平常的，正常的。2 規定的，照常的；平凡的； 拙劣的。3 【法律】直轄的。n 1 普通事，常...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. This paper unfolds engineering disposition and theoretical research of negative temperature high performance concrete ( nthpc ) with the damage of many factors motivation, the project background based on qing - zang railway engineering, which is one of four - emphasized engineering during the tenth five - plan. due to the difference of environment of construction and service between nthpc and ordinary concrete, and therefore durability of nthpc is required to higher level. at a first, nthpc must avoid frozen damage at early age and possess anti - freezing property at later period, in order to meet engineering practicable application need, and this are two emphasized and difficult problems, as for nthpc ; by means of mechanism analysis about deicing - agent ingredient and anti - freezing at early period, adopting composite technique routine of mineral addition + anti - freezing element + water - reducer4 - air - entraining + anti - erosion of steel component etc, based on orthogonal experimental approach, fd - 1 composite functional admixtu re was manufactured, which has more property and orientation on qing - zang railway

    負溫混凝土由於和普通混凝土在施工環境及服役環境上存在的差異，因此表現為比普通混凝土更為較高的耐久性要求；負溫混凝土首先要避免早期的凍害以及具備長期抗凍性能，才能夠滿足工程實際應用的要求，這也是負溫混凝土必須解決的兩大技術關鍵；通過對目前常用防凍劑組分作用機理的分析研究及混凝土早期防凍機理探討，採用礦物外加劑+防凍組分+高效減水劑+引氣+阻銹組分功能復合的技術路線，通過正交試驗設計復配了適應青藏鐵路工程要求的專用多功能復合型外加劑fd - 1 ；並在此基礎上配製不同等級負溫高性能混凝土，開展一系列包括硫酸鹽侵蝕、氯離子滲透、抗凍融循環、收縮及耐磨性等耐久性能研究；通過對fd - 1組分和摻量的調整，優化負溫混凝土在施工特性、力學指標和耐久性三個方面的兼容、協調性。
  2. Based on the analysis of geothermal geology and hydrothermal convection system, the hot groundwater is formed from the mixing of the deep - circulating high - temperature structural - fissure water with the shallow circulating ordinary - temperature karstic water in the hydrothermal convection system

    根據地熱地質條件及水熱對流系統分析，地下熱水是在水熱對流系統中由深循環高溫構造裂隙水與淺循環常溫巖溶水混合而成。
  3. The nano - bulk al should be kept more man 30 minutes at temperature no more than 300 to annealed which is much lower than that of ordinary aluminum materials

    對納米鋁塊體材料的退火實驗表明，模壓成形的鋁塊體材料的退火溫度（ 300 ）比常規的鋁材（ 400 ）要低，退火保溫時間應在30分鐘以上。
  4. It gives the hardware and softeware design of the temperature measure diagnose system of diesel enging ordinary failure. the hardware includes a infrared temperature measure appratus which contains memory and communication unites -, a data analysis computer which is used to analysis the data from the temperature measure appratus and gives the result report. the software includes modules such as comunicatio data analysis result print and operation interface between man and computer. it uses basic computer language which is easy to the users, the data communication instead of the data input with hand avoids the disadvantage of man and the erro of man

    本文給出了柴油機常見故障測溫診斷系統的軟體系統和硬體系統的設計方法，硬體系統包括溫度檢測用的紅外測溫儀（具有數據存儲和數據通訊功能，可以很方便與上位計算機構成數據分析的診斷系統，在機車現場中操作十分方便）及用於數據處理的計算機系統（數據分析和報表） ；軟體系統採用basic語言開發了用於對紅外測溫儀數據讀取、分析和存儲並給出故障診斷結果的程序，具有代碼簡便、容易掌握和界面友好的特點，容易被現場工作人員接受。
  5. The tensile and compression experiment on bulk nanocrystalline ag prepared by igc method was carried on mt810 with different grain sizes and zwick 10tn2s machine at different strain rates under normal temperature respectively. the stain rate sensitivity m was found to be 0. 025, which was extremely lower than the ordinary values. also the work hardening exponent is very low

    本文從用惰性氣體蒸發冷凝和真空原位壓結法（ igc ）制備得到的直徑80mm ，厚度7 . 6mm的大尺寸納米晶金屬ag樣品上切割得到符合力學實驗要求的拉伸和壓縮試樣，在mts810和zwick精密力學測試機上分別精確測定了拉伸和壓縮應力?應變曲線與晶粒尺寸和應變速率的關系。
  6. It is believed that eventually ve will reach sufficient temperature or baryon density to produce a new state of matter - quark gluon plasma ( qgp ). the study of the pha. se transition from ordinary hadronic matter to qgp. and to further investigate the properties of qgp has been the major effects of these experiments at sps / cern

    由於夸克膠子等離子體只在極短時間內存在，加上復雜的普通核物質存在效應的影響，同時而準確地測定qgp存在的各種信號，已成為目前和將來高能重離子實驗的研究方向。
  7. In this paper the experimental research of hydra ulic oil used on a certain composite gearbox are carried on the experimental fo rm ulas are drawn respectively between viscosity 、 density 、 specific heat and temper ature the function of viscosity to temperature and pressure is deduced the com parative analysis among the new oil 、 used oil and ordinary antifriction oil ind icates the performance of the specitic oil is excellent these conclusions are b eneficial to the advanced analysis of the vehicle transmission system and formul ate the manual of relevant armored caterpillar

    該文對某軍用履帶裝甲車輛綜合傳動系統使用的液壓油進行了試驗分析，得出了這種液壓油的粘度、密度、比熱與溫度的經驗關系式，推導出了粘度在溫度、壓力綜合作用下的函數關系，並對新油、舊油、普通抗磨液壓油的粘度進行了對比分析，這對于使用這種液壓油的傳動系的分析計算和制定相關軍用履帶裝甲車輛的使用規范提供了重要的理論依據
  8. Abstract : in this paper the experimental research of hydra ulic oil used on a certain composite gearbox are carried on the experimental fo rm ulas are drawn respectively between viscosity 、 density 、 specific heat and temper ature the function of viscosity to temperature and pressure is deduced the com parative analysis among the new oil 、 used oil and ordinary antifriction oil ind icates the performance of the specitic oil is excellent these conclusions are b eneficial to the advanced analysis of the vehicle transmission system and formul ate the manual of relevant armored caterpillar

    文摘:該文對某軍用履帶裝甲車輛綜合傳動系統使用的液壓油進行了試驗分析，得出了這種液壓油的粘度、密度、比熱與溫度的經驗關系式，推導出了粘度在溫度、壓力綜合作用下的函數關系，並對新油、舊油、普通抗磨液壓油的粘度進行了對比分析，這對于使用這種液壓油的傳動系的分析計算和制定相關軍用履帶裝甲車輛的使用規范提供了重要的理論依據
  9. Identification area : the main equipment here is an ordinary micro - scope, on fluorescence microscope, incubator, instrument for bacte - ria identification, low temperature or ultra low temperature refrigera - tor ( for the temporary storage of bacteria shall follow the regulations of the cdc )

    3鑒定區：主要有普通顯微鏡、熒光顯微鏡、溫箱、細菌鑒定儀、低溫或超低溫冰箱（菌種臨時保存，視cdc規定而定）等。
  10. Excellent heat - resistant, ordinary type can filter 120c high - temperature liquid, special high - temperature resistant type can filter 380 liquid

    耐熱性能好，普通型最高可過濾120c的高溫液體，特種耐高溫型可對最高溫度達380的高溫液體進行連續過濾。
  11. The coefficient of resistance to temperature of the nano - bulk al is more than 50 times that of ordinary al materials

    所測定的納米鋁塊體材料的電阻溫度系數是普通多晶鋁塊體材料的50多倍。
  12. Theory therefore indicates that the dark ages were defined by three distinct temperatures : the spin temperature ( a measure of the relative abundance of atoms with different spin states ) ; the ordinary, kinetic temperature ( a measure of the motions of the atoms ) ; and the radiation temperature ( a measure of the energy of the background photons )

    因此理論上，黑暗年代是由三種截然不同的溫度來定義：自旋溫度（不同自旋狀態原子相對數目的度量） 、一般的動力溫度（原子運動的度量）與輻射溫度（背景光子能量的度量） 。
  13. Made of shaping polytetrafluorethylene resin by moulding in ordinary temperature then through high heat sintering

    將聚四氟乙烯樹脂在常溫下用模壓法成型后再經高溫燒結製成。
  14. This control cabinet can control every point temperature in the hot runner, and keep a plastic flow at an optimum condition so that it is possible to avoid such defects as hollow and contraction cavity from lacking in supply, and to save materials and labor and reduce production costs at the same time. compared with ordinary, such hot runner will shorten the time of mould removal, carry out full - automatic ordinary, such hot runner will shorten the time of mould removal, carry out full automatic operation more easily, reduce the distance of mould - opening and the stroke of mould - closing

    使用本控制櫃能精確控制流道中各點溫度，使塑料流動達到最佳狀態，這樣能克服製件因補料不足而產生凹陷，縮孔等缺陷，同時節省了材料和人力，降低生產成本，與普通流道比脫模周期短，易實現全自動操作，可以縮短開模距與合模行程，縮短成型周期，可以成型較長製品。
  15. Mercury is adverse to other metals in state at ordinary temperature

    常溫下水銀與其它金屬狀態不同。
  16. Ordinary temperature thermistor

    常溫熱敏電阻器
  17. Made of shaping polytetrafluoethylene resin into blank by moulding in ordinary temperature, through high heat sintering, then ratary cut

    用聚四氟乙烯燒樹脂在常溫下用模壓法製成坯料，經高溫燒結后旋切而成。
  18. Made of pressing polytetrafluoethylene resin into various simple shapes of seal in ordinary temperature then through high heat sintering and special treatments

    用聚四氟乙烯樹脂在常溫下壓制各種簡單形狀的密封件，再經高溫燒結后經特殊方法處理製成。
  19. Made of shaping polytetrafluoethylene resin into blank by moulding and sintering in ordinary temperature, then through cutting to have the broad nonstereospecific film

    用聚四氟乙烯燒樹脂在常溫下經模壓燒結製成坯料后再經車削製成寬幅的不定向薄膜。
  20. White crystal ； insoluble in water ； soluble in methanol, ethanol, toluenc etc organic solvents. m. p. 49 52. decomposed at ordinary temperature. storage at below 10

    白色結晶，不溶於水，溶於甲醇、乙醇、甲苯等有機溶劑，熔點49 52 ，常溫下分解，存放在低於10的地方。
分享友人
分享到 Line

分享到臉書