oscillation loop 中文意思是什麼

oscillation loop 解釋
振蕩波腹
  • oscillation : n. 1. 【物理學】振蕩，擺動，振動；振幅。2. 動搖，猶豫，仿徨。3. 蹣跚。4. 【無線電】發雜音。
  • loop : n 1 （用線、帶等打成的）圈，環，匝，框，環孔，線圈；【醫學】（常 the loop）宮內避孕環。2 環狀物，...
  1. Here a low cost optimal position system with speed - loop open and position - loop closed based on fuzzy control is presented, it employs fuzzy controller to verdict rotor velocity approximately and a fuzzy switching curve is substituted for real one to achieve bang - bang switch, no limit - loop or oscillation occurs. at the end of this chapter, a dc break curve is discussed

    為了實現經濟實用的點對點快速定位系統，實際系統採用速度開環、位置閉環結構，速度量從模糊控制器得到，既不實測也不軟體估計，用模糊開關線代替真實開關線進行控制量狀態切換，無極限環或振蕩現象，而成本則大大降低。
  2. Analysis and tests show that by using slope compensation, the open - loop instability, sub - harmonic oscillation, non - ideal closed - loop response and noise etc. when duly cycle above 50 %, can be reduced or eliminated

    理論分析與試驗表明，通過引入斜坡補償可以抑制或消除占空比超過5 %時的開環不穩定性、次諧波振蕩傾向、不理想的閉環響應、噪聲等。
  3. On the other hand, the function of the rough regulation is the same as the open loop system. the a / f controller adopts the approaching increment method in the smooth regulation and the pi controller for non - oscillation or stable increment method for low - speed oscillation in the micro - regulation

    噴氣占空比粗調階段為對map圖執行取值操作；細調階段為執行增量逼近法的階段；微調階段為執行pi環節或執行低速振蕩微調。
  4. 2 ) hysteretic loop emphasis has also been focused on the onset and damping behavior of the thermoacoustic oscillation. based on the acute review and analysis on the non - steady processes with hysteresis, a hysteretic loop is proposed and experimentally verified for the first time in the standing wave thermoacoustic prime mover

    熱聲振蕩滯后迴路在系統地考察其它非穩態過程特性的基礎上，首次提出並實驗驗證了熱聲起振和消振過程中存在「滯后迴路」 ，並對滯后迴路的影響因素進行了研究。
  5. Abstract : a two - pole axially - laminated anisotropic ( ala ) rotor reluctance motor, with a high saliency ratio, is de - veloped. based on it, the performance characte istics of the motors are investigated with open - loop operation. it is proposed that an intensive oscillation occurs at low speed, corresponding to the frequency supplied a little greater than the natural one of the system

    文摘:研製了一臺高凸極比的兩極ala轉子磁阻同步電動機，實驗研究了電機的開環運行特性，研究結果表明電機開環運行時存在一個比較嚴重的低頻振蕩，這個振蕩發生在電機電源頻率略大於電機的自然頻率后的某一頻段，且會導致電機失去同步
  6. Used in hi - fi per - amplifiers and tv oscillation loop circuits

    適用於高保真前置放大及電視振蕩迴路。
  7. A bang - bang controller may exists limit - loop or oscillation in vicinity of origin of the plane, so the stability of system destroyed

    Bang - bang控制實現的難點是，在運動相平面的原點周圍易形成極限環或出現振蕩。
  8. On the aspect of errors analysis of hrg, a brief introduction of the close - loop detection theory of hrg is present first. later the expressions of close - loop detection errors are deduced in theory. the impact of stimulating signals, turning speed, outside appended oscillation, the location & area of electrodes, and the current loss in capacitor is considered, and the primary analysis of error compensation is given

    在半球諧振陀螺誤差分析方面，本文從半球諧振陀螺的閉環檢測原理出發，對半球諧振陀螺閉環檢測誤差進行了分析和推導，考慮了激勵信號、轉動速率、外界附加振蕩、電極位置及極板面積和電容傳感器等因素造成的陀螺誤差並對誤差補償進行初步分析。
  9. A hysteretic loop is also found in this system and its influencing factors are analyzed to discuss the condition of its occurrence, which is expected to help further understanding the mechanism of thermoacoustic oscillation

    針對不同的加熱功率和充氣壓力，系統地研究了起消振過程中的溫度、壓力變化特性，著重分析了滯后迴路形成的過程和影響熱聲系統滯后迴路的因素，指出滯后迴路存在的條件，對深入理解熱聲系統的起消振行為具有參考意義。
  10. The detection methods of oscillation and sluggishness in feedback control loop are given, in order to reduce the diagnosis range of poor performance causes

    並通過監測反饋迴路振蕩和響應遲鈍來分析性能降低的原因以縮小原因診斷范圍。
  11. The task in the open loop system is to get lpg injection duty ratio in pre - set two dimension map according to practical engine operation condition, while the task in the closed - loop system is to calculate lpg injection duty ratio by the approaching increment method or the proportion and integral ( pi ) controller according to the signal of the oxygen sensor. to eliminate the oscillation phenomena of the signal of the oxygen sensor in low - speed condition, this paper develops the stable increment method

    開環階段根據實時工況參數對事先制取的噴氣占空比map圖執行取值操作；閉環階段根據氧傳感器反饋信號通過增量逼近法或pi環節計算輸出適合即時工況的噴氣占空比值；為解決低速振蕩現象，本文運用固定增量法，對系統進行低速振蕩微調。
分享友人
分享到 Line

分享到臉書