oscillator input 中文意思是什麼

oscillator input 解釋
振蕩輸入
  • oscillator : n. 1. 搖擺者。2. 【電學】振蕩器，振動器，振動子，振動部。
  • input : n. 1. 【電學】【自動化】輸入；輸入端。2. 輸入電路，輸入信號，輸入功率[電壓]。3. 放入物，投入的資金。vt. ,vi. 把（數據等）輸入計算機。
  1. The major job is manufactured a transmitter, which has three upmixer channels. its function is to up convert the signals from c - band to ka - band. the input local oscillator is provided by a low frequency crystal oscillator which has a good performance of phase noise, through 512 times multiply to ka band. this sysetem is used in the laboratory as transmitter source of the fuze, for the multidimensional objects in practise, which lead to the complexity of the reflect signal, so the amplitude, frequency and the phase of the transmit signals both have a key role in dealing with the reflection signals. therefore, this system requires for both the coherence of the single channel ’ s amplitude, phase and multi channels

    本文的主要工作是應用戶要求製作一具有三發射通道的上變頻系統，可以將c波段的微波信號上變頻到ka波段的毫米波信號。系統的本振輸入基頻由一相位噪聲非常好的低頻率晶振提供，經過512次的倍頻放大至ka波段。本系統作為實驗室中引信的發射源，由於目標反射信號具有時變的多維性，反射信號變得極為復雜，在信號處理時，不僅信號幅值、頻率有決定意義而且相位關系也很有決定意義。
  2. A type of relaxation oscillator used for the generation of nonsinusoidal waves in which the output of each active device is coupled back to the input of the other to sustain oscillations

    一種產生非正弦波的張馳振蕩器，其中，每個有源器件的輸出端要反饋到另一器件的輸入端以維持振蕩。
  3. The concept of " timing " in the article is not the clock in our ordinary living, but syntheses which is made up of some frequency source in the signal generator ( such as cs atom frequency standard, rb clock & high accuracy quartz crystal oscillator ) which produces the primary frequency, the matching input interface and the matching output interface and controlling circuit etc. for example, bits is a kind of timing equipment, which is used to control the timing of some functions

    本文論及的「時鐘」概念不是指日常生活中使用的鐘表，而是由產生基準頻率的信號發生器（如銫原子頻率標準、銣鐘及高精度石英晶體振蕩器等）中的某種頻率源以及相配套的輸入、輸出介面和控制電路等組成的一整套具有特定同步定時功能的綜合體。如bits就是一種時鐘設備，它提供用在通信系統中控制某些功能的定時的時間基準設備，時鐘提供的信號稱為基準信號、定時信號或同步信號。
  4. In the design of the spll, srd takes the input of a crystal oscillator and generate very sharp and narrow pulses

    在振蕩器之後，本文加了一個緩沖放大器，它起到放大輸出功率和改善頻率穩定度的作用。
  5. Input to the inverting oscillator amplifier and input to the internal clock operating circuit

    反向振蕩放大器和內部時鐘工作電路的輸入。
  6. The resonance network is connected to the gate, then the output and input matching network is designed to satisfy the oscillation criteria. then harmonic balance method is used to analysize and optimize the output power and phase noise. to minimize the load pulling effect a buffer amplifier is designed to isolate the oscillator and the load

    本文在場效應管fet柵極上加上諧振網路（諧振網路是通過cst模擬得到的，它是串聯反饋迴路，介質工作在te01模，對于其後的fet ，它又相當於一個帶阻濾波器） ，然後設計輸入輸出匹配電路，使電路結構滿足起振條件，之後繼續用諧波平衡法模擬和優化，使振蕩器輸出功率合適，相位噪聲很低。
  7. A resistor - condenser circuit at the input to the vertical oscillator

    位於垂直振蕩器輸入端的一種阻容電路。
  8. Third, an active mixer which needs only single - end local oscillator ( lo ) input is presented, which simplifies the rf block design and reduces the impacts of the phase noise of lo

    接著本文提出了一個新型的、只需要單端本振輸入的有源混頻器，簡化了整體電路設計，並降低了本振相噪帶來的影響。
  9. According to leeson model, which had proposed the relationship of noise between output and input in the feed - back oscillator, an experimental crystal oscillator circuit with high stability and low phase noise is designed

    參照提出反饋振蕩器中輸出和輸入噪聲關系的李森模型，設計一高穩定低相位噪聲振蕩器的實驗電路，並在實驗中分析電路關鍵元件對電路整體性能的影響。
  10. The paper proposes a novel learning algorithm for precise phase control of oscillatory neural networks. a target oscillator is employed to temporally synchronize correlated objects in an input binary image while uncorrelated objects are desynchronized via adjustable phase shift that is proportional to their spatial position. the proposed learning rule has a fast convergence, and can achieve an extremely small phase error

    設計了一種新的神經元振蕩器網路快速同步學習演算法，該演算法能保證同組的振蕩器達到完全同步；同時，採用相位延遲方法，使不同圖像目標的振蕩器組的相位延遲正比于其在空間上的距離，實現目標對象的分離與提取
  11. This will decrease the frequency of the local oscillator and simplify the local oscillator design, and increase the performance and the reliability of the mixer. in this article, the input diplexer method was firstly presented in the mixer design

    在設計過程中，本文首次提出了基於合路雙工注入原理實現次諧波混頻器設計的方案，設計思路簡單，適于工程使用。
分享友人
分享到 Line

分享到臉書