oscillator voltage 中文意思是什麼

oscillator voltage 解釋
振蕩器電壓
  • oscillator : n. 1. 搖擺者。2. 【電學】振蕩器,振動器,振動子,振動部。
  • voltage : n. 【電學】電壓,電壓量,伏特數。 the working voltage (電氣的)耐壓限度。
  1. The pll consists of a crystal oscillator, a ring voltage - control - oscillator, a frequency divider, a phase / frequency detector, a charge pump and a loop filter

    設計的電路包括20mhz晶體振蕩器,鑒頻鑒相器,壓控振蕩器,固定分頻器,電荷泵和低通濾波器。
  2. In the sub block circuit design, the contents that the author had introduced include : the principle of band gap voltage reference and the design technique in low power supply ; the analysis of spike pulse noise rejection, frequency divider and dead time in oscillator and control circuit ; the selection of the width and length ratio of four switches and 2x / 1x mode change point in driver and mode selection circuits

    在子電路設計中,作者比較深入分析的內容有:基準電路的原理及低電源電壓下基準電路的設計;振蕩器和控制電路中尖峰脈沖噪聲抑制、兩分頻電路及死區時間設定;驅動及模式選擇電路中開關管的寬長比的選擇及模式轉換點的設計。
  3. Using the particle - in - cell ( pic ) model, a 8 millimeter relativistic backward wave oscillator underlying superradiance mechanism was gotten, the influence on both operation frequency and radiation efficiency of the guiding magnetic field, the diode voltage, the beam current and the beam radius as well as the corrugation structure were also presented

    採用pic方法,通過數值模擬優化設計了超輻射狀態下的8毫米相對論返波振蕩器,分析了引導磁場、二極體電壓、電子束流、電子束半徑、周期慢波結構等對器件的輻射功率及輻射效率的影響。
  4. On account of the low q - factor and small tuning range of the p - n junction varactor, the inversion - mode mos varactor is used in the lc voltage controlled oscillator in this thesis. the simulation results show that the designed lc voltage controlled oscillator has 15 % tuning range

    3 .由於lc壓控振蕩器中的pn結變容管品質因數低、調諧范圍小,本次設計的lc壓控振蕩器採用了強反型mos變容管,模擬結果表明,所設計的lc壓控振蕩器具有15 %調諧范圍。
  5. Microwave assembly detail specification for model wfz816a voltage controlled oscillator

    微波組件wfz816a型壓控振蕩器詳細規范
  6. The study has completed the design of two - phase inverter and made up of the two - phase inverter - motor system for experimental use it is a variable frequency adjustable speed system with a open - loop control of rotational speed, which consists of voltage - controlled oscillator circulating assign device inverter circuit and two - phase induction motor a accurate mathematical model is set based on the whole system, and simulator program of dynamic and steady condition is established, which is used to calculate the dynamic and steady performance by kron and symmetrical coordinate converter by simulator calculation and experimental research with specific parameter of the system, a comparison is made between predicted and experimental characteristics, experimental measurements are shown to compare closely with corresponding theoretical result it is compared with some variable frequency adjus table speed system comprising inverter and single - phase induction motor from the system efficiency torque pulsation and the effect of two - phase inverter capacitance based on the conclusion, harmonic cancellation pulse width modulation control of a two - phase inverter - fed induction - motor drive system is researched, which cancelled the low harmonic and improve the system performance

    通過對電機的kron變換和對稱分量變換,建立了系統較精確的數學模型,編制了系統動態及穩態運行的模擬計算程序分別計算系統的動態和穩態性能。通過對系統的具體參數進行了模擬運算和實驗研究,實驗和模擬結果進行比較,說明實驗和理論較為一致,並從系統效率、轉矩脈動及兩相逆變器電容的影響等方面與各種逆變器和單相異步電動機組成的變頻調速系統加以比較。在此基礎上,對兩相逆變器供電-異步電動機系統使用諧波抑制pwm控制進行了研究,由於減少了低次諧波,改善了系統性能。
  7. The system parameters are developed at the same time, and some universal conclusions on the theoretical analysis of pll are reached. then, we have carried on analysis and research to the theory of differential delay ring voltage controlled oscillator ( vco ). on this basis, a improved differential delay ring vco with more efficient loads is described. this circuit has been designed and implemented in 0. 35 m cmos technology

    本文還對差分延遲結構環形壓控振蕩器電路進行了深入的分析與研究,並提出了一種基於高質量電阻電路的主從差分延遲結構環形壓控振蕩器,其採用了一種新型的主從差分延遲結構,並用一個更有效、更穩定的負載電阻電路結構來替代vco設計常使用的單個mos管電阻結構,使其系統穩定性有了相應提高。
  8. ( 1 ) through simulations on jtl with different parameter conditions, the new phenomenon of annihilation and passing through of voltage pulses are founded, and the conditions are obtained at the same time ; ( 2 ) the jtl ring oscillator is utilized in studying the repulsion effect of pulses on jtl, thus the bounded influence is eliminated, and precision results can obtained

    ( 2 )首次將jtl環振蕩器結構應用到jtl某些傳輸特性的分析上來,消除了端界的影響,使分析更為精確;如對推斥效應的模擬就獲得了良好的效果。推斥效應的研究使我們認識到rsfq的工作頻率在某種程度上要受其效應的制約。
  9. For digital audio encoding and decoding modules, delta - sigma modulation is introduced and audio data, preambles with accessorial data are multiplexed according to the digital audio interface standard ; for carrier wave, pll frequency synthesizer is used ; for frequency modulation, voltage control oscillator is taken ; for demodulation, pll frequency discrimination is adopted

    調制方式,並按照數字音頻介面標準對音頻數據、同步字和附加信息進行通道復用;對于載波信號,採取鎖相環頻率合成技術手段;對于頻率調制,採用壓控振蕩器;對于解調電路,採取鎖相環鑒頻電路。
  10. Voltage controlled oscillator

    電壓控制振蕩器壓控振蕩器
  11. Vco voltage controlled oscillator

    電壓控制振蕩器
  12. Also, jian wang and xiao - ling ding found a special property named " quasi - dissipative " in a system concatenated by two area - preserving maps. the system can be viewed as a model of an electronic relaxation oscillator with over - voltage protection

    王健、丁曉玲等人在一個描述有過壓保護功能的電子張弛振子的分段光滑保面積映射中發現了一種被稱為「類耗散性」的特殊性質。
  13. In the thesis, some of the most important functional modules of the smart power control ics are researched and designed, including voltage reference, voltage regulator, under voltage lockout, oscillator and zero - voltage comparator. their topologies, schematics and layouts are introduced and developed

    本畢業設計研究和提出了構成智能電源控制晶元的主要功能模塊,完成了其中若干模塊ip核的電路與版圖設計? ?包括基準電壓源,電壓調節器,欠壓鎖定比較器,振蕩器,電壓過零比較器等。
  14. The current source plays an important part in the performance of the oscillator. with the help of the voltage reference, we design a constant current source which does not vary with the temperature 、 the voltage source and the process

    由於充放電電流對弛張振蕩器的性能有很大的影響,因此本文把基準電壓源結合在一起設計出一個受溫度、電源電壓、工藝條件影響很小的基準電流參考源。
  15. In this circuit, reference current sources are used to charge and discharge capacitors. this oscillator ’ s output is very ideal through control circuit under 5. 7v reference voltage, and oscillator ’ s frequency and duty - cycle could be adjusted if reference current source or capacitors in the circuit was adjusted. and the changes of temperature and voltage affect stabilize of the frequency little

    此電路利用系統內部基準源產生的電流信號來對電容進行充放電,然後經過控制電路作用后,產生的輸出振蕩波形的上升時間和下降時間非常小,更接近理想矩形波形;通過調節基準源電流信號或者電容值大小,可調節振蕩波形的頻率和占空比,同時溫度和電壓的變化對振蕩器輸出波形頻率穩定度的影響很小。
  16. Applying the criterion of the work state of operational amplifier, the stable operating condition of voltage - controlled voltage source filter 2 is proved in detail and the condition that the filter can be used as the sinusoidal oscillator is given

    摘要利用運放工作狀態的判據,系統地證明? 4種二階壓控電壓源型濾濾器穩定工作的條件,同時給出了用作正弦波振蕩器的條件。
  17. On the basis of physical concept, applying mathematical method, the condition that the problem can be transformed from the voltage - controlled voltage source lpf of two orders to the sinusoidal oscillator is proved and the calculation formula of oscillatory frequency is presented

    摘要以物理概念為基礎,利用數學手段證明?二階壓控電壓源lpf轉化為正弦波振蕩器的條件,同時給出了振蕩頻率的計算式。
  18. Inside the integrated circuit ic1, after suitable divisions, the two frequencies are sent to the phase comparator that generates the lock voltage of the secondary oscillator

    在綜合電路ic1的內部,經過合適的劃分,兩個頻率被送往相位比較儀,這兩個頻率產生二級振蕩器的鎖電壓。
  19. Rc oscillator ’ s frequency is 1khz. the voltage reference of ic is 2. 2v, which can keep stabilization when the power supply is bigger than 2. 3v. in that case circuits can insulate yawp from power supply

    在穩壓源電路設計中,採用了運算放大器負反饋的形式,使參考電壓源為2 . 2v ,並在電源大於2 . 3v時保持穩定,隔離了電源噪聲。
  20. And then, based on the above theories, the circuit design and simulation means have been concretely applied in the internal modules of voltage reference, bias circuit, oscillator, error amplifier and drive circuit of the chip and so on. the relevant design indexes are successfully achieved. at last, the whole circuit simulation and layout design are completed

    在此理論基礎上對該電源晶元內部的各個模塊,如電壓基準源、偏置電路、振蕩器、誤差放大電路和驅動電路等模塊進行了具體的電路設計和分析模擬,且達到了相應地設計指標,最後,完成了整體電路模擬和版圖設計。
分享友人