overlap channel 中文意思是什麼

overlap channel 解釋
重疊通道
  • overlap : vt vi ( pp )1 (與…)交搭;疊蓋。2 (與…)部分一致[巧合],(時間等)重復,一致 (in)。n 1 重復...
  • channel : n 1 水路,水道,渠,溝;海峽;河床,河底。2 (柱等的)槽,凹縫;【機械工程】槽鐵,凹形鐵。3 〈比...
  1. A complementary input stage, which consists of a p - channel pair and a n - channel pair, was used in the circuit, so that the common mode input range can extend from rail to rail. a dcls is used to shift the n - transistor curve leftward to overlap the p - transistor curve properly and keep constant transconductance in the whole common mode input range

    輸入級採用pmos差分輸入對和nmos輸入差分對並聯的結構,從而實現共模輸入范圍擴大到電源的正負兩端,並且通過兩個源級跟隨器平移nmos輸入管跨導曲線,使nmos輸入管和pmos輸入管跨導曲線的適當交疊,從而保持了這個輸入級的跨導在整個共模輸入范圍內保持恆定。
  2. ( 2000 ). the neutron irradiation is assumed to derive primarily by the reaction 13c ( a, n ) i60 with a minor contribution from the marginal burning of 22ne through the channel 22ne ( a n ) 23mg in the final, high temprature phase of each flash. and we considered the influence of the various parameters such as the initial core mass, the envelope mass, the mass - loss rate, the overlap factor and the delution factor etc., and we vary their value with the pulse number

    本文採用分叉s -過程反應通道,以~ ( 13 ) c ( , n ) ~ ( 16 ) o 、 ~ ( 22 ) ne ( , n ) ~ ( 25 ) mg為雙脈沖中子源,用最新的中子俘獲截面,利用gallino和busso等人給出的agb星三殼層核合成模型,考慮到核心質量、挖掘程度、重疊因子、稀釋因子及星風質量損失率隨脈沖數的變化,詳細計算和研究了各個金屬豐度情況下的3m 。
  3. This system characterized with good anti - multipath performance and low complexities when the channel matrix extending technique or overlap - adding technique and minimum mean square error equalization are employed

    當採用通道矩陣擴展技術或重疊相加技術,並採用最小均方誤差均衡時,該系統有著良好的抗多徑性能和較低的計算復雜度。
  4. Another reason to separate the aps is that coverage overlap between aps operating on the same radio channel ( known as co - channel overlap ) degrades performance

    之所以拉開存取點,還基於另一個原因:採用相同無線電頻道的存取點所覆蓋的范圍若有重疊(也就是同道重疊) ,會降低網路的效能。
  5. Channel assignment, which is the second part of the design process, is typically carried out so as to minimize co - channel overlap, which reduces interaction between stations in different co - channel cells

    指定頻道為設計過程的另一個部份,一般都以減少同道重疊現象為目的,以便減少各同道單元內站臺之間的交互影響。
分享友人