oxidation chamber 中文意思是什麼
oxidation chamber
解釋
氧化室-
It is very difficult to analyze flame radiation in the cylinder of a diesel engine by theoretical method since flame radiation is a function of many parameters, such as the combustion process, the geometrical description of the chamber, the soot formation and oxidation processes, the soot radiant temperature and soot absorption coefficient. the radiant property of the flame in a cylinder is dependent on the combustion process. but the thermodynamic state of real engine cycles can be analyzed from the pressure - volume diagrams in the cylinder. thus a new thermodynamic computational model is set up for the flame radiation in the cylinder of a diesel engine based on the indirect relationship between the flame radiation and the pressure - volume diagram of the combustion process in this paper. the flame radiant heat flux in the cylinder of a di diesel engine is calculated with the variation of crank angle by this model. compared with measured values, the result of the computational values shows the model is available to represent the effects of flame radiation
柴油機缸內的火焰輻射受諸多因素的影響，用理論分析法來確定它是相當困難的，由於柴油機缸內火焰輻射特性依賴于缸內的燃燒過程，而燃燒過程中的實際熱力狀態又可用示功圖來分析，因此藉助於火焰輻射與缸內熱力參數之間的這種間接關系，建立了一種計算柴油機缸內火焰輻射傳熱的新模型，利用該模型對一臺直噴柴油機缸內火焰輻射熱流量隨曲軸轉角的變化情況進行了計算，將計算結果與實測結果進行了比較，表明該模型能較好預測缸內火焰輻射傳熱量。 -
Finally, eels and aes were combined to study initial oxidation processes of uranium, niobium and uranium - niobium alloys in an ultra - high vacuum chamber at the temperature of 373k, 473k, 573k and 673k
最後，還利用eels和aes研究了超高真空下不同溫度（ 373k 、 473k 、 573k和673k ）時鈾、鈮及鈾鈮合金的初始氧化過程。 -
The work mainly consists of four parts : the first part is to use oxidation and lpcvd technique to produce sio2 mask film and si3n4 insulation film in order to enhance the heating efficiency of micro chamber, and guarantee the carry out of the reaction. the second part is to use the combination of dry etching and wet etching to produce reaction micro chamber, it is the container which carry out the pcr reaction, and dna sample carry out amplification reaction here. the third part is to use the sputtering, photolithography to produce heaters and temperature sensors which heat the reaction micro chamber and provide the temperature condition for the pcr reaction
首先，利用氧化工藝和lpcvd技術，生長sio _ 2掩膜層和si _ 3n _ 4絕緣層，以提高反應腔的熱效率，保證擴增反應的順利進行；其次，用濕法腐蝕和干法刻蝕相結合的方法加工微型腔體，使之作為dna樣品進行pcr擴增反應的容器；第三，用濺射、光刻等工藝在微型腔體底部製作微型加熱器和溫度傳感器，實現對反應腔體的加熱及其溫度的精確測量，提供pcr擴增反應所需的溫度條件。
分享友人