oxide film formation 中文意思是什麼

oxide film formation 解釋
氧化膜形成
  • oxide : n. 【化學】氧化物。 antimony oxide 銻白，氧化銻。 deuterium oxide 重水，氧化氘。 mercuric oxide 氧化汞。 nitric oxide 一氧化一氮。
  • film : n 1 薄層，薄膜；薄霧，輕煙；細絲狀的東西。2 【攝影】感光乳劑，照相軟片，電影膠片；影片。3 〈 pl ...
  • formation : n. 1. 構成，形成；設立；編制。2. 組織，構造；形態；形成物，構造物；【軍事】編隊，隊形；兵團。3. 【地質學；地理學】層；組； 【生物學】社區；（植物）群系。adj. -al
  1. The formation process, dynamic variation, deciduous causes of oxide film of work roll are analyzed, and the control methods have been put forward

    分析了氧化膜的形成過程、動態變化及脫落原因，並提出了控制方法和措施。
  2. The formation mechanism and the structural adjustment of nano aluminum anodic oxide film

    納米級鋁陽極氧化膜的形成機理及結構調整
  3. Owing to the interfacial cracking which occurs under higher applied load conditions, the composite with high content of tib _ 2 phase exhibited a transition from mild wear to severe wear over the applied load range from 10 n to 80 n. under moderate applied load, increasing the sliding speed caused a decrease in wear rate and friction coefficient of the in - situ composites because the formation of a protective oxide film occurred on the sliding surface and the hardness of the subsurface layer was maintained due to reinforcement of tib2 nanoparticles in the cu matrix

    隨著載荷的增加， cu -納米tib2原位復合材料的磨損率和摩擦系數增加；由於在較高載荷下發生表面開裂，高含量的tib2相增強原位復合材料發生了由輕度磨損向嚴重磨損形式的轉化。在中等載荷下由於表面保護性氧化膜的形成和基體中納米tib2相的存在使復合材料具有良好的抗軟化能力， cu -納米tib2原位復合材料的磨損率和摩擦系數隨著滑動速度的增加而下降。
  4. If the quantity of sr is over some value ( 0. 02 % - 0. 04 % ), the melt will absorb hydrogen, and result in the formation of cavities. we think the reason is that the dissociated sr destroyed the compact oxide film of the melt

    Sr的加入量過多（ 0 . 02 0 . 04 ）后，反而出現吸氣現象，導致形成孔洞缺陷，我們認為這是游離態sr破壞了al - si合金的緻密氧化膜所致。
分享友人
分享到 Line

分享到臉書