oxygen furnace 中文意思是什麼

oxygen furnace 解釋
氧氣轉爐
  • oxygen : n. 【化學】氧，氧氣。
  • furnace : n. 1. 爐子；熔爐；高爐。2. 極熱的地方。3. 磨煉；艱難。vt. 在爐中燒熱（金屬）。
  1. Such as 180 t oxygen converter, 1550 250 mm plate suspending straightening machine, annealing furnace of the whole hydrogeb mask, 1250mm cantalever straightener etc.

    如180t氧氣頂吹轉爐， 1550250mm板坯連鑄機， 1829球磨機，全氫罩式退火爐， 1250mm懸臂矯直機等。
  2. Electric furnace with double deslagging or in the basic oxygen furnace

    如雙除渣電爐或基本氧爐。
  3. Oxygen - natural rotating gas furnace for cast iron melting

    熔煉鑄鐵用氧氣183 ;天然氣回轉爐
  4. Specifically for the iron and steel industry during the past 15 years, thermo electron has installed over 100 mass spectrometers for gas analysis applications involving the following plants : coke ovens, blast furnace ( bf ), direct reduction iron ( dri ), basic oxygen furnace ( bof ), electric arc furnace ( eaf ), argon oxygen decarburization ( aod ) furnace, vacuum oxygen decarburization vod furnace and ruhrstahl - hausen ( rh ) furnace

    尤其在過去15年的鋼鐵行業中，超過100臺過程質譜儀用於氣體分析，包含：焦爐，高爐，直接還原煉鐵爐，氧氣頂吹轉爐，電弧爐，氬氧脫碳轉爐，真空氧氣脫碳爐和循環法真空脫碳爐。
  5. Kzl series air clean filter to enter empty to is it stand to press since, the compressor and air conditioner imprison the wind system, blast furnace air - introduced machine of steel plant, gas turbine, air making oxygen raw materials air compressor filter, strain and contain a large number of dust except that among them, prevent from in dust particle long - time adjustment air current sports, to operated equipment above blade, impeller, flow dish and part lead to the fact the harm

    Kzl系列空氣自潔過濾裝置kzl系列空氣自潔過濾裝置是對進入空壓站壓縮機及空調關風系統，鋼鐵廠高爐引風機燃氣輪機制氧原料空壓機的空氣進行過濾，濾除其中含有大量塵埃，避免灰塵粒子在長時間的調整氣流運動中，對以上運行設備的葉片葉輪流道及部件將造成損害。
  6. After thermodynamic calculation on several operation conditions of the furnace, cold - state flow and resistance mensuration, the combustion of the tubular - furnace hearth was changed into swirl and addition of radiate cylinder and oxygen content detection minish 1. 25 surplus air to less than 1. 15, improving the combustion condition and convection and radiate heat transfer efficacy, resuling in reducing the waste - gas temperature 45, decreasing exhaust gas loss, and saving fuel by 6 %

    摘要通過對加熱爐幾種工況進行熱力計算、冷態試驗的流場分佈及阻力測定和熱態試驗的爐膛溫度場分佈及管壁溫度等參數的測定，確定將管式加熱爐爐膛內直流燃燒改為旋流場燃燒和增加輻射筒，增設煙氣含氧量分析，可以將燃燒的過剩空氣系數從1 . 35減小到1 . 15以下，極好地改善爐膛內的燃燒狀況和對流輻射傳熱效果，從而降低排煙溫度45 ，減少加熱爐排煙損失，節約了煤氣量6 %以上。
  7. The reads show that gas flow can be well - proportioned distributed in hearth, and effective quantity of gas channels increased under oxygen - enrichment operation with stable air flowrate, thus oxygen - enrichment operation with stable air flowrate is an effective way for improving the productivity of blast furnace

    結果表明：穩定風量的富氧操作方式有利於煤氣流在爐缸的均勻分佈以及有效煤氣通道量增加，是提高高爐產能的有效措施。
  8. Abstract : coke saving measures in the recent ， years at pangang are summarized according to various ways of beneficiated materials ， high blast temperature ， oxygen - enriched blast ， pulverized coal injection rate and improvement of blast furnace operation ， the effect of related smelting factors on coke rate is investigated in combination with the production data and moreover further measures for reduction of coke rate are proposed

    文摘:從精料、風溫、富氧和噴煤量以及改善高爐操作等方面總結了攀鋼近幾年來採取的節焦措施，並結合生產數據分析了有關冶煉因素對焦比的影響，同時提出了進一步降低焦比的措施。
  9. It shows that with a metallization degree of burden more than 40 per cent, blast furnace can t be operated with oxygen enriched blast. combining lower burden metallization degree with oxygen enriched blast and coal injection, higher coal injection rate and higher productivity can be obtained. by use of higher burden metallization degree lower coke rate can be obtained than oxygen enriched blast and coal injection

    結果表明：爐料金屬化率達到40后，高爐不能富氧操作；較低的爐料金屬化率與富氧噴煤相結合，能夠獲得更大的噴煤比和更高的產量；使用金屬化率較高的爐料，能夠比富氧噴煤達到更低的焦比。
  10. Abstract : this paper introduces the choice and ramming of the refractories for the 12 t induction channel furnace ， which is one of the import production facilities for producing “ oxygen free ” copper wire by upward - leading continuous casting. the cost of home - made refractories is only 1 / 5 1 / 8 of that of import one. it is of benefit to all similar import furnaces that the domestic refractiones were successfully rammed and used

    文摘:介紹了引進無氧銅桿上引法生產線中12t有芯感應爐爐襯耐火材料的選用和砌築工藝；運行狀況良好，整個材料費僅為進口同類材料的1 / 5 1 / 8 ；該熔銅爐爐襯的成功砌築和使用，為其他同類爐子爐襯耐火材料的國產化提供了範例。
  11. A new technology of oxygen - enriched blasting for the first tap of blast furnace has been developed. the blast furnace can be tapped smoothly and operated normally after blast. the accident of tap failure, followed by tuyere burning due to slag going up can be avoided

    利用富氧燃燒技術研究一種高爐首次出鐵時吹燒鐵口新工藝，使休風后的高爐出鐵順利，盡快達到高爐順行，避免鐵水出不來，爐內渣面上漲，風口燒穿等事故的發生。
  12. Abstract : according to material and local heat balance in the blast furnace, refering to the result of oxygen enriched blast and coal injection into blast furnace and use of metallized burden, the influence of burden metallization degree on oxygen enriched - coal injection rate 、 coke rate and productivity is calculated

    文摘:根據高爐物料平衡和區域熱平衡理論，參照高爐富氧噴煤和使用金屬化爐料的冶煉結果，計算了爐料金屬化率對富氧噴煤率、焦比和產量的影響。
  13. Basic oxygen furnace

    氧氣頂吹轉爐
  14. A series of standard solution made up with standard substance of sodium carbonate, and combusted in a high - frequency induction furnace with pure oxygen, and the amount of total carbon was measured by infrared absorption

    摘要以碳酸鈉為基準物質，配成一系列標準溶液，在通有純氧氣的高頻爐中燃燒，紅外吸收法測定碳含量，繪制校準曲線，測定矽中總碳量，與推薦值基本一致，方法準確、結果滿意。
  15. The blast furnace is a heat exchanger and also an oxygen exchanger of the gas and row, there are many physical and chemical changes in it. it is not very reasonable to develop a model only consider the statistics relations

    但高爐是從風口迴旋區到料線的氣固逆流熱交換器；也是從軟熔帶到料線的逆流氧化交換器，其內進行著非常復雜的物理和化學反應。
  16. Bof basic oxygen furnace

    堿性氧氣轉爐
  17. Abstract : a new technology of oxygen - enriched blasting for the first tap of blast furnace has been developed. the blast furnace can be tapped smoothly and operated normally after blast. the accident of tap failure, followed by tuyere burning due to slag going up can be avoided

    文摘:利用富氧燃燒技術研究一種高爐首次出鐵時吹燒鐵口新工藝，使休風后的高爐出鐵順利，盡快達到高爐順行，避免鐵水出不來，爐內渣面上漲，風口燒穿等事故的發生。
  18. The advances of the application of membrane technology of oxygen enrichment in glass kiln, boiler, evaporator boiler, hot - blast furnace, medical care, and fcc oxygen - rich regeneration are described in details

    主要介紹了膜法富氧技術在國內玻璃窯、鍋爐、注汽爐、熱風爐、醫療保健和fcc富氧再生等方面應用的最新進展。
  19. Abstract : the initial position and velocity of pulverized coal at oxygen - coal lance outlet has been proposed, thus injection of pulverized coal in the blast furnace can be simulated

    文摘:給出了氧煤槍出口處煤粉顆粒初始位置和初始速度的分佈，從而為高爐煤粉噴吹的數值模擬打下了基礎
  20. Oxygen furnace steel

    吹氧煉鋼
分享友人
分享到 Line

分享到臉書