pair-to-pair tube 中文意思是什麼
pair-to-pair tube
解釋
對偶管-
The thesis has done the widespread investigation and study to the domestic and foreign ’ s technologies of analogy low voltage and low power, and analyzes the principles of work, merts and shortcomings of these technologies, based on the absorption of these technologies, it designs a 1. 5v low power rail - to - rail cmos operational amplifier. when designing input stage, in order to enable the input common mode voltage range to achieve rail - to - rail, it does not use the traditional differential input pair, but use the nmos tube and the pmos tube parallel supplementary differential input pair to the structure, and uses the proportional current mirror technology to realize the constant transconductance of input stage. in the middle gain stage design, the current mirror load does not use the traditional standard cascode structure, but uses the low voltage, wide - swing casecode structure which is suitable to work in low voltage. when designing output stage, in order to enhance the efficiency, it uses the push - pull common source stage amplifier as the output stage, the output voltage swing basically reached rail - to - rail. the thesis changes the design of the traditional normal source based on the operational amplifier, uses the differential amplifier with current mirror load to design a normal current source. the normal current source provides the stable bias current and the bias voltage to the operational amplifier, so the stability of operational amplifier is guaranteed. the thesis uses the miller compensate technology with a adjusting zero resistance to compensate the operational amplifier
本論文對國內外的模擬低電壓低功耗技術做了廣泛的調查研究，分析了這些技術的工作原理和優缺點，在吸收這些技術成果基礎上設計了一個1 . 5v低功耗軌至軌cmos運算放大器。在設計輸入級時，為了使輸入共模電壓范圍達到軌至軌，不是採用傳統的差動輸入結構，而是採用了nmos管和pmos管並聯的互補差動輸入對結構，並採用成比例的電流鏡技術實現了輸入級跨導的恆定;在中間增益級設計中，電流鏡負載並不是採用傳統的標準共源共柵結構，而是採用了適合在低壓工作的低壓寬擺幅共源共柵結構;在輸出級設計時，為了提高效率，採用了推挽共源級放大器作為輸出級，輸出電壓擺幅基本上達到了軌至軌;本論文改變傳統基準源基於運放的設計，採用了帶電流鏡負載的差分放大器設計了一個基準電流源，給運放提供穩定的偏置電流和偏置電壓，保證了運放的穩定性;並採用了帶調零電阻的密勒補償技術對運放進行頻率補償。 -
Considering the weakness of the solar - power adsorbers in refrigeration / air conditioning, such as the effects of heat collecting in desorption period and heat loss in adsorption period, here, a new adsorber is proposed ? ? evacuated tube which is cooled by water. simulation calculations and experiments have been performed. with a view to the intermittent characteristics of solar - powered adsorption, a continuous cycle operation for the adsorption refrigeration cooling system with active carbon fibre ( acf ) - methanol adsorption refrigeration working pair is carried out
本文針對目前太陽能固體吸附式製冷系統中吸附集熱床在解吸階段集熱效率不高和在吸附階段散熱效果不理想的狀況，以及針對太陽能固體吸附製冷系統循環的間歇性，本文提出了一種新型吸附集熱器:真空集熱管?水冷型吸附集熱器，以活性炭纖維?甲醇為工質對實現連續製冷循環方式，並對其進行了相關的性能實驗和數值模擬計算。 -
Considering to the weakness of solar adsorption cooling system with a view to the intermittent characteristics, which can not refrigerate in daytime, a new adsorption bed of vacuum tube cooled by water flow is proposed and a continuous cycle operation for the adsorption bed with active carbon fibre ( acf ) - methanol as adsorption - refrigerant pair is achieved
摘要針對目前太陽能固體吸附製冷循環過程只能利用夜晚散熱實現吸附製冷，不能在白天進行製冷的缺點，提出了一種新型吸附集熱系統：真空集熱管水冷型吸附集熱床，以活性炭纖維甲醇為工質對，實現連續製冷循環，並對其進行了兩方面相關的性能實驗。
分享友人