passband 中文意思是什麼

passband 解釋
傳輸頻帶
  1. Thirdly, two kinds of the methods to improve the performance of filter stopband has been discussed. these methods are used to cleared up the influence of the parasitical passband. through the simulation and test result shows that these methods " s performance is expected

    第三，論了2種對濾波器阻帶抑制進行改善的方法，以消除寄生通帶的影響，通過模擬和實際製作濾波器的測試結果。
  2. Later on we discuss the basic theory of multi - rate signal processing, and the polyphase algorithm for interplation filter, then produce the efficient algorithms for interplation : half - band filter and cic filter. we analyze their computing quantity and performance, especially the mirror elimination feature and the at - tenuation in the passband

    之後討論了多速率信號處理的基本理論，比較了不同的內插演算法，分析了半帶濾波器和cic內插濾波器的計算代價、時頻性能，以及各自的抑制鏡像特性。
  3. The main works are as follows : 1. the paper systematically describes basic concepts and theories that form the foundation for design of general microwave filters. the topics will cover filter transfer function, lowpass prototype filters, frequency transformations, immittance inverters and the passband insertion loss under the influence of the dissipation of filter elements 2

    現總結如下: 1 .對微波濾波器的設計理論進行系統的分析，闡述了微波濾波器的傳輸函數、低通原型、頻率變換、倒置變換器以及元件損耗對帶內插損的影響等方面。
  4. To utilize property of saws propagating, it can be made including delay lines, passband filters, oscillators and pitch filters. surface transverse wave ( stw ) was used the configurature of reflective metal - strip grating between the two interdigital transducers, and made the shear horizotal ( sh ) wave on the surface of the piezoelectric substrate, but not to deep in

    聲表面橫波（ surfacetransversewave ，簡稱stw ）是採用在兩個金屬叉指換能器之間加入短路柵的隔離板結構使剪切水平波（ shearhorizontalwave ，簡稱sh波）被嵌制在壓電基片表面上，而不是沿壓電基片內傳播的聲表面橫波形式。
  5. This reduces gain but widens the amplifier's passband.

    這方法降低了增益，但加寬了放大器的通頻帶。
  6. There is always a smooth transition between passband and stopband

    通頻帶和抑止頻帶之間總是存在一個「平滑切換點」 。
  7. In the future it may be possible to have such bandpass sigma - delta adcs with userprogrammable digital filter coefficients, so that the passband of a receiver could be modified during operation in response to the characteristics of the signal ( and the interference

    未來可能會出現用戶可編程數字濾波系數的帶通- adc ，這樣接收機的通頻帶就可以隨著所接收的信號的特性而改變。
  8. Analyze, design and simulate the digital down - convert frequency. first, the analogue if signal is converted to digital if signal in one a / d convertor which used passband sampling theory. the digital if signal is then passed to a pair of digital mixers operating in phase quadrature for mixing the if signal to baseband signal

    首先利用帶通采樣定理對中頻模擬信號進行a / d變換后將其混頻到基帶，然後用平方根升餘弦滾降濾波器同時完成低通濾波和匹配濾波雙重作用，以提高解調器的效率。
  9. The sampling technology is also being explored which including lowpass sampling, quadrature sampling and direct passband sampling and the setting of a / d, sampling rate, data acquisition and selecting filtering parameters. the implementation of each technique is also being discussed

    分別對低通采樣、正交帶通采樣和直接帶通采樣技術中有關a d在系統中的位置、采樣率的確定、信息獲取和濾波參數選取等問題進行系統論述，並討論了各自的技術實現問題。
  10. The hybrid method can simulate accurately both the imaging and polarization - dependent diffraction characteristics of a concave grating. to meet the growing need for flattened passband in a practical wdmsystem, three design methods, namely, the tapered output waveguide structure with air - slots, the three - focal - point method and the analytical method of spatial phase modulation, are introduced to achieve a passband - flattened diffraction grating device

    針對實際光通信應用中對通帶帶寬的需求，本文提出了「結合空氣槽的漸變輸出波導結構方法」 、 「三焦點方法」及「顯式公式空間相位調製法」三種使平面集成型衍射光柵波分復用器件獲得平頂型頻譜響應的優化設計方法。
  11. A method of pitch mark determination for a speech, includes : acquiring a fundamental frequency point and fundamental frequency passband signals by using an adaptable filter ; detecting a number of passing zero positions of the fundamental frequency passband signals ; and generating at least a set of pitch marks from a number of passing zero positions

    一種決定語音音高標記的方法，系藉以找出一語音之一組音高標記，此決定語音音高標記的方法系利用一可適性濾波器取得一基頻點與一基頻帶通訊號；求取基頻帶通訊號之復數個過零點位置；然後經由復數個過零點位置產生至少一組音高標記。
  12. The main work of the system can be divided into four main parts as the following : ( 1 ) 10. 5ghz bandpass filter the main contradiction of filter is caused by its function of dividing frequencies. in order to properly divide frequencies, not only need passband ’ s attenuation to be as small as possible and stopbands ’ as big as possible, but also need a sharp and quick change between the attenuation of passband and stopband, thus to make their diversity obvious

    這四個功能模塊分別是: （一） 10 . 5ghz帶通濾波器濾波器的主要矛盾是由它分隔頻率的功能決定的，為了使分隔理想，一方面要求通帶的衰減盡可能小，阻帶衰減盡可能大，亦即通帶和阻帶的衰減差值要盡量大;另一方面要求通帶和阻帶之間衰減的變化應盡可能快，最好是陡峭的跳變，使阻帶和通帶的分隔十分明顯。
  13. The millimeter wave diplexers used in the ka - band satellite communications are investigated. these diplexers are of high working frequency, narrow passband and high selectivity, which demands the channel filters good performance

    所研究的毫米波雙工器工作頻率高（接近40ghz ） ，收發通道帶寬窄、接收頻率和發射頻率間隔很小。
  14. By experimentation, it is shown that time - frequency modulation is efficient and effective, which has rake and fault tolerant capacities in passband. the modem has strong ability of anti - jamming and error - correction which can finish the mission of communication under poor channel qualitative properties

    經過實驗證明，時頻調制是一種簡捷有效方法，它具有很好的帶內分集接收效果和容錯能力，該數據機在通道質量很差的條件下，仍能完成數據通信的任務，具有很強的抗干擾和糾錯能力。
  15. The specification is that the cutoff frequency must be more than 15mhz, the maximum passband ripple must be 0. 2db and the minimum stopband attenuation must be 40db

    該濾波器要求截止頻率大於15mhz ，通帶最大紋波為0 . 2db ，阻帶最小衰減為40db 。
  16. And it turns out that the bit error rate of passband equalizer is smaller than that of baseband equalizer, but the convergent stability of baseband equalizer is better than that of passband equalizer. at the same time, baseband equalizer can be implemented in hardware more easily than passband equalizer

    通帶均衡系統的誤碼率總是小於基帶均衡系統的誤碼率;但基帶均衡器收斂后的穩定性要比通帶均衡器好，且基帶均衡器的采樣頻率較低，易於硬體實現。
  17. Based on this simulation method, the following novel designs are developed : 1, the two - stigma design, which can reduce the aberrations and improve the imaging of the grating ; 2, the flat - field design, which can omit the output waveguides and make an edg easier tc fabricate ; 3, the passband flattening design, which can relax the requirements on wavelength control for lasers and filters in a wdm system ; 4, the reduced back - reflection design, which guarantees very little reflection light back into the input channel and improves the feature of the return loss

    本論文以用於光通信中的平面集成蝕刻衍射光柵為研究對象，具體的分析了的它的工作原理和設計思想，並給出了設計中的經驗和方法。器件設計后需要進行性能計算和模擬以減小復雜的集成光器件製作試驗，本論文描述了計算蝕刻衍射光柵比較準確的模擬方法，其結果能夠很好的接近實際情況。基於這樣的模擬計算方法，本論文提出了改進蝕刻衍射光柵設計的幾種方法： 1
  18. The interleaver with channel spacing of 50ghz is designed and prototype device is achieved. we test experimentally the interleaved spectrum in the c - band which is rectangle with ripple of less than 0. 1 db. and through measuring its time delay, we obtain the character of its dispersion. a novel architecture of 50ghz mfpi interleaver with different passband widths is put forward at first

    2 、設計了通道間隔為50ghz的mgti型interleaver濾波器，獲得了該濾波器的原型器件；實驗得到了該器件在c波段兩組交錯分波的矩形化光譜，其紋波小於0 . 1db ，通過對器件時延的測量，間接獲得了其色散特性；首次提出mfpi型不等帶寬50ghz的interleaver濾波器技術方案。
分享友人
分享到 Line

分享到臉書