peak to peak noise 中文意思是什麼

peak to peak noise 解釋
峰間噪聲
  • peak : vi 1 瘦弱；消瘦，憔悴。2 減少，縮小 （out）。n 1 山峰，山頂；孤山。2 （胡須等的）尖兒；尖端。3 最...
  • to : adv 到某種狀態；〈特指〉到停止狀態；關閉。 ★也常和動詞結合，略去其後賓語，而構成成語： The door i...
  • noise : n 1 聲音，聲響。2 叫喊；嘈雜聲，噪音；喧鬧聲；吵鬧，騷動，騷擾。3 〈古語〉謠言，風聲。4 〈美國〉...
  1. The columns and rows are constrained by each other. the simulations over binary symmetric channe ( lbsc ) and gilbert - elliott channel ( gec ) shows the performance is great improved, especially over burst error channel peak signal to noise ratio ( psnr ) is improved more. it is tried to be used in wireless communication system

    模擬結果表明，採用行列交替約束的約束維特比譯碼以後，性能得到較大的提升，尤其在突發錯誤通道中，傳輸的圖像經乘積編碼進行通道編碼與譯碼后峰值信噪比有明顯的提高。
  2. The spectrum level of microseismic noise tends to peak at about 1/6 hz.

    微震的噪聲譜在16赫趨于峰值。
  3. Simulation results show that the ringing artifacts around the image are reduced, the main information is preserved, and the peak signal to noise ratio ( psnr ) is higher than the known methods

    模擬計算表明，該方法可有效抑制圖像邊界的振鈴效應並保護了圖像的重要信息，並且比現有的方法具有更高的峰值信噪比。
  4. After analyzed the basic principle of optimized noise reduction on tyre pattern, summarized three approaches to noise reduction. the first is trying to reduce size of single block or socket to reduce noise amplitude on time domain, the second is to adjust stripes sorting order and their interlace value to avoid noise - made by every single block - peak values on time domain overlayed and the last is to adjust ratio of blocks and sockets, ratio of stripe interval and stripe sorting order to avoid noise periodical distribution and abnormal high peak values in some frequency strip

    論文第四章分析了輪胎花紋優化降噪的基本原理，總結出三條降噪途徑：在允許范圍內盡量減小單個塊或槽的大小、刻刀槽軟化花紋塊來減小噪聲時域波幅度；調整節距排列順序、花紋條之間的錯位值，使各發聲單元發出的聲壓時域波形的同向峰值錯開，避免同向峰值疊加；調整花紋塊和槽比例、節距比例、節距排列順序，盡量避免周期性分佈，使輪胎所發出的噪聲趨于白噪化，避免某些頻段的異常高峰值。
  5. By using peak - band algorithm, the aim area ( b area ) is segmented from the wear area image. aiming at the edge noise of image, mathematical morphology theory is applied to integrate edge. test results show that the segmentation algorithm is effective in identifying tool wear degree

    針對邊界中存在的分割噪聲使用圓形形態運算元對邊界進行完整化，最終獲得了完整的刀具磨損區圖像，為實現通過刀具磨損區大小來評判刀具磨損程度的方法奠定基礎。
  6. At the beginning of this thesis, the principle of fiber fabry - perot strain sensor is presented briefly, and the influence on the results of the peak - to - peak algorithm, brought by the spectrum distribution of light source, wavelength quantification or the noise in the output of the fabry - perot sensor is investigated. the limitation of the peak - to - peak algorithm is pointed out

    論文首先闡述了光纖法珀應變傳感器的測量原理，分析了實際光源光譜的非均勻分佈、波長量化和傳感器輸出信號中的噪聲等對波長域的條紋峰值解調演算法的應變測量結果的影響，深入分析了條紋峰值解調演算法的局限性。
  7. With resistant function to peak waves and noise by high reliable electronics. rated residual current from 15ma to 500ma. the overload, short - circuit and earth leakage protection function by dual - voltage, high speed and compact size

    過電流保護特性採用有效值控制方式，可防止因高諧波而誤動作，增加其可靠性，此為一般傳統電子式塑殼斷路器所無法達到的功能。
  8. Frequency - domain equalization. at the same time discusses some key problems in ofdm : high ratio of peak - to - average power of output signals, problem of synchronization, channel estimation, adaptive bit, power and subcarrier allocation. emphasize on channel estimation, and present a new algorithm which can filtering more interpolation errors and noise. for the sake of improve the performance of resist narrowband noise and make efficient use of the spectrum apply malvar wavelet division

    同時就ofdm系統中的一些關鍵問題如峰值平均功率比（ papr ）太高，同步問題，通道估計，通道、比特與功率必須動態分配進行了研究，著重研究了通道估計問題並提出一種改進的方法，能濾除更多的噪聲分量和插值誤差，提高系統的性能；為了提高抗窄帶噪聲的性能和提高通道利用率，用malvar小波變換實現了不等帶寬分配。
  9. Secondly, the dissertation proposes a novel blind symbol - timing scheme for ofdm systems based on cyclostationarity feature of received symbols. the proposed schemes also exploits the periodicity of ofdm symbol introduced by cyclic prefix, by applying 2 - dimentional fourier transformation and choosing the appropriate correlation peak value as the symbol start location, the precision of this scheme is higher than previous conventional method. thirdly, the dissertation presents analysis with regard to channel estimation of ofdm systems. several interpolation algorithm in ofdm systems which based on pilot sequence have been analyzed in the first instance, and the influence of the channel noise on interpolation precision has discussed. the theoretic analysis and simulation results show that : the interpolation error induced by the precision of interpolation procedure itself has out weight

    第三，論文在ofdm系統的通道估計方面，先對基於導頻的ofdm通道估計中的多種插值方法進行了分析，討論了噪聲對插值精度的影響，指出插值本身的精度所造成的插值誤差遠大於噪聲所帶來的插值誤差，從而階次更高的插值演算法在實用中並非最優的;並指出插值濾波法比變采樣率演算法對噪聲的影響更為敏感，在信噪比較高時插值濾波演算法比變采樣率演算法更優。
  10. The spectrum level of microseismic noise tends to peak at about 16 hz

    微震的噪聲譜在1 6赫趨于峰值。
  11. The spectrum level of microseismic noise tends to peak at about 1 / 6 hz

    微震的噪聲譜在1 6赫趨于峰值。
  12. Peak signal to noise ratio, psnr

    通過比較降噪前後的峰值信噪比
  13. Experiments are performed on monochrome and color image sequences, and performance is measured by the peak signal to noise ratio ( psnr )

    最後分別對單色和彩色圖像序列進行了實驗，利用峰值信噪比（ psnr ）來度量演算法的性能。
  14. On the other hand, image quality measures haven ’ t been improved correspondingly. the most popular image quality assessment ( iqa ) is still traditional methods whose representative is psnr ( peak signal - to - noise ratio )

    在對圖像質量要求愈來愈高的今天，傳統的圖像質量評價演算法已無法提供令人滿意的結果，成為圖像處理技術的薄弱環節。
  15. Based on adaptive quad - tree fractal image encoding scheme, the concept and algorithm of peak signal noise ratio ( psnr ) based on the fractal codes is put forward, and is used to match the similarities between images

    本文以自適應四叉樹分割的分形圖像編碼為基礎，提出了圖像的分形碼峰值信噪比的概念和演算法，在無須解碼的情況下，直接對分形碼來量化圖像間的相似性。
  16. In the final, we evaluated and analyzed the quality of a series of compressed images with the fuzzy image and psnr ( peak signal - to - noise ratio ) measurement. we have also made some other experiments such as add noise to the images and so on

    然後用峰值信噪比和本文提出的模糊圖像度量分別對一系列壓縮后的圖像質量進行評價，並且分析了它們的評價結果，最後還進行了對圖像添加各種噪聲等實驗。
  17. Simulation results show that both objective gains measured in psnr ( peak signal - to - noise ratio ) and visual improvements of reconstructed video can be achieved by utilizing introduced methods. chapter 5 gives the implementation of jvt - based nwarq technique

    實驗結果表明，各改進演算法能不同程度地提高和改善重建圖像的峰值信噪比（ psnr ）和主觀質量；第五章研究、實現並測試了基於jvt視頻編碼標準的無等待arq技術。
  18. In order to assess the performance of the proposed methods, we propose three types of image measures to quantify the performance compared to some other methods. the first type evaluates the fidelity of the reconstructed image by computing the peak signal - to - noise ratio and euclidean distance in cielab color space between the original and reconstructed image in smooth and edge regions respectively. the second type accounts for a major artifact ? zipper effect

    為了評估演算法質量，本文採用了三類評估手段:一是分別計算原始圖像與重構圖像在平滑區域與邊界區域的峰值信噪比與cielab顏色空間的歐氏距離來分析重構圖像的保真度;二是利用數學手段對重構圖像的一類主要失真現象? ? zipper效應進行定量評估;三是對硬體實現的成本與實際可行性進行了分析。
  19. This method not only quickens the coding speed, but also improves the peak value signal - to - noise ratio ( psnr )

    不僅加快了編碼速度，而且提高了圖像的峰值信噪比（ psnr ） 。
  20. According to this, we propose a new way to renew the traditional method of subjective image quality evaluation, different to only use mse ( mean square error ) and psnr ( peak signal - to - noise ratio ) to evaluate merely on radiation distortion, and complemented quantitative description on compressed image distortion o it is significant to choose the format of video transferation and measuring precision calculation of tracking and measuring systems based on images

    中國科學院長春光機與物理研究所博士學位論文據此提出了不同於傳統的僅用均方誤差（ mse ）和峰值信噪比（ psnr ）來評價圖像灰度輻射畸變的新思路，補充了對壓縮圖像幾何畸變的定量描述。這對于基於圖像的測量跟蹤系統中數字圖像傳輸方式的選擇，以及評價壓縮解壓演算法對測量精度的影響有重要意義。
分享友人
分享到 Line

分享到臉書