phase comparison method 中文意思是什麼

phase comparison method 解釋
相位比較法
  • phase : n 1 形勢，局面，狀態；階級。2 方面，側面。3 【天文學】（月等的）變相，盈虧；【物、天】相，周相，...
  • comparison : n. 1. 比較，對照；類似。2. 【語法】比較法；【修辭學】比喻。
  • method : n 1 方法，方式；順序。2 （思想、言談上的）條理，規律，秩序。3 【生物學】分類法。4 〈M 〉【戲劇】...
  1. This article discussed ar modeling method, capon method, music method and mn method four kinds of high resolution algorithms principle and has separately made the computer simulation in the ideal situation to the above four algorithms. through the comparison, the beam width of high resolution algorithm is much narrower than conventional beamforming method. then unifies the actual utilization, discussed the influence of time delay unbalance, time domain sampling, plane wave supposition and array element with scope and phase not identically to the beamforming and made the computer simulation

    本文首先討論了ar模型法、 capon法、 music法和mn法四種高解析度演算法的原理，在理想的情況下分別對上述四種演算法作了計算機模擬，通過比較，高解析度演算法的束寬比常規波束形成法窄得多;然後結合實際運用時的情況，重點探討了延時失配、時域抽樣、平面波假設和基陣的幅相不一致對波束形成的影響並做了計算機模擬。
  2. As a comparison, ba1. 03ce0. 8gd0. 2o3 - was synthesized by sol - gel method. among these samples, nonstoichiometric samples were synthesized for the first time. the research work involved : the crystal phase of the sinters were determined by xrd ; ionic conduction under different experimental atmospheres was measured by gas concentration cells ; performances of hydrogen - air fuel cells with the sinters as electrolytes and porous pt as electrodes were measured

    用粉末x射線衍射儀鑒定它們的結晶相；在（ 600 1000 ）范圍內，以燒結體作為電解質隔膜，多孔性pt黑為正、負電極， pt - rh合金網為集電極，分別組成氫濃差電池、氧濃差電池及氫?空氣燃料電池並測定了它們的性能，研究了不同氣氛下樣品的離子導電特性及影響燃料電池性能的因素。
  3. As a traditional method, the phase - comparison method has a merit of low cost but a demerit of poor bearing accuracy

    比幅測向法是一種傳統的方法，它的最大優點是價格成本較低，但測向精度較差。
  4. So, deep - through analysis of the phase - comparison method and adoption of new evaluation methods is to be done to increase the bearing accuracy and achieve the best price performance, satisfying the equipment requirement of navy

    因此對它進行深入的研究和採用新的估算方法來提高其測向精度，使性價比達到最優，以滿足海軍裝備的需求。
  5. To increase the bearing accuracy of amplitude - comparison, the multi - channel system was chosen, the angle of reaching of moving antenna pattern serial was estimated from the frequency domain using the phase - delay estimating method, and at the same time, the selection of antenna, quantization of signal and touch switches were optimized in concrete engineering practice, and so the requirement of the index was satisfied

    為提高比幅測向的精度，選用多通道體制，採取相位延時估計法從頻域來估算移動天線方向圖系列的達到角，同時在具體的工程實現上對天線選取、信號的量化、去摸開關等進行優化，從而滿足指標要求。
  6. Focusing on the tactical index of ew system - bearing accuracy, this article makes deep - through analysis, comparison and study of the theory basis for traditional direction finding method. a 16 - channel monopulse amplitude - comparison direction finding method and new phase - delay estimating method has been proposed to use, through computer ' s analog computation and relative measures in actual engineering practices, the bearing accuracy of traditional method has been increased and the service requirement of the ew weapon system and adaptability of equipment satisfied

    本文圍繞著電子戰武器系統的戰術技術指標?測向精度，對傳統的測向方法的理論基礎進行了深入的分析、比較和研究，提出了採用16通道單脈沖比幅測向體制和新的相位延時估算方法，通過計算機的模擬摸擬計算，以及在實際的工程實現中採取的相關措施，解決了採用傳統的測向方法提高測向精度，滿足電子戰武器系統的戰術技術指標要求和裝備的適裝性。
  7. To the single pulse angle measuring, phase comparison and phase sum - difference angle measuring method are discussed and compared. sum - difference channel modeling and simulation are made. based on system research and signal processing discussed above, some basically jamming methods are discussed and simulated

    對于單脈沖測角方法，研究了相位比較法和相位和差單脈沖測角方法，對兩種方法進行了比較並給出了和差通道方向圖的模擬。
  8. The methods of direction finding mainly include maximum ( minimum ) signal method, amplitude - comparison method, phase - comparison method and time difference method

    測向的方法主要有最大（最小）信號法、比幅法、比相法、時差法。
  9. In the comparison of frequency standard, the ordinariest and the simplest method is phase comparison

    在測量頻率標準指標的比對中，最常見且最簡單的是採用比相測量的方法。
  10. Firstly, the experimental phase current and input power data obtained from load test are employed to estimate the parameters in ii rated condition. then, the phase current and input power data in locked rotor condition are used to track the variation of the parameters of the secondary coil with slip frequency. the classical method and the direct modification method are also used to estimate the parameters of the induction machine in comparison with this technique

    首先利用了負載試驗的定子電流和輸入功率數據來識別額定工況下的電機參數，然後又使用了堵轉時的定子電流、輸入功率數據來識別電機二次繞組參數隨轉差頻率的變化，並與傳統參數測試方法和直接修正參數法進行了比較。
  11. Based on the above chosen scheme, the dissertation researches the principle and method of phase calculation. and after the comparison of various principles, the dissertation chooses a method that is suitable to the instrument. finally, a virtual phaser is designed and developed

    基於上述確定的方案，論文深入研究了鑒相原理和方法，並在對各種鑒相原理進行比較后，確定出適合該儀器的方法，最後設計出虛擬式鑒相器。
  12. According to development of inland and abroad, a new measurement method has been put forward that make use of the periodic characteristic of the phase difference between two arbitrary frequency signals. in the light of lissajous graph, we complete comparison of radio frequency and microwave with 105 rates relationship in technique. on the ground of common characteristic of frequency signals, this method can be developed to comparison of microwave frequency and optical frequency to accomplish optical frequency measurement

    根據國內外的情況，提出一種新的測量方法：即利用任意頻率信號之間都存在著相互相位差周期性變化的現象，根據李沙育圖形的原理，在技術上完成了射頻到微波信號之間成10 ~ 5頻率關系的比對，再根據頻率信號的共性，將此方法推廣到微波到光頻信號之間的比對，以完成對光頻的測量。
  13. Firstly, the study of real two - channel data recorded by the airborne battlefield radar is made based on the methods of gmti, which including the study of methods of two - channel equilibrium, that of the precious estimate of beam scanning angle, that of the doppler center, that of the compensation for pattern error and that of gmti and that of location of the moving target using the phase - comparison mono - pulse method

    首先，結合動目標檢測方法，對機載遠程戰場偵察雷達實驗系統錄取的雙通道數據的處理進行了研究。內容包括兩通道均衡方法研究，波束掃描角精確估計方法研究，多普勒中心估計方法研究，方向圖誤差補償方法研究，動目標的檢測和干涉定位方法研究。
  14. 7. based on the comparison with dual band gps phase and c / acode, ambiguity function method, least squares search, ambiguity solution covariance, cholesky disintegrate and least square ambiguity decorrelation adjustment, it is considered the method of ambiguity function using double gps antennas to move baseline and the equation of dual differential carrier phase

    在分析雙頻p碼偽距法、模糊度函數法、最小二乘搜索法、模糊度協方差法、 cholesky分解法、和lambda演算法的基礎上，重點研究基於雙gps天線動一動基線載波相位雙差整周模糊度確定方法。
  15. Theoretical study on the natural circulation precooling involves complicated two - phase fluid flow and heat transfer. the paper discusses several typical analyzing methods concerned with precooling, and also introduces a new analyzing method based on the comparison with the natural circulation boiler

    自然循環預冷法的理論分析涉及到單相、兩相流的流動和傳熱問題，對此不少文獻都有所論述，本文對其中一些具有代表性的方法進行了討論。
  16. This method uses wavelet transform to pick up the transient fault information because of its multi - resolution characteristics and time - frequency localization nature. fault line is detected based on the modulus maxima or energy comparison under some scale of wavelet transform of phase currents or component current. this method is applicable for such power system as only furnished with ct on two phases, so the shortcoming of other methods presented in recent years is overcome

    即利用相應出線相電流或分量的暫態信息突變量在小波變換某一尺度下模極大值或能量比較來確定故障線路，該方法同樣適用於只裝設兩相ct的小電流接地系統，從而克服了迄今為止提出的一些選線方法在系統只裝設兩相ct時失效的問題。
  17. Calibration of vibration and shock pick - ups - method for secondary vibration calibration by comparison of phase angles

    振動和沖擊傳感器的校準.採用相角比較法對次振動的校準方法
分享友人
分享到 Line

分享到臉書