plating solution 中文意思是什麼

plating solution 解釋
電鍍液
  • plating : n. 1. （電）鍍，噴鍍；鍍金（術）。2. 鍍層；外覆金屬板；【造船】（全部）船殼板；（兵艦等的）裝甲。3. 【攝影】曬相。4. 懸賞賽馬。
  • solution : n. 1. 溶解；溶液，溶體，溶劑。2. （補輪胎用的）橡膠水；〈美國〉藥水。3. 解決，解答 （of; for; to）; 解釋；（數學等的）解法，解式。4. 免除，解除。5. 【醫學】消散，消退。
  1. Rapid determination of zinc in brass plating solution

    黃銅鍍液中鋅的快速測定
  2. Since the dry plating does not require the reduction using electricity, the dry plating has many advantages in that it permits to plate the surface of non - conductive polymer materials, and further does not use the electrolyte solution so that wastewater is not produced and the plating thickness can be readily controlled

    由於不要求用電還原，干鍍有許多優點，因為它允許對非導電性聚合物進行上鍍，其次不使用電鍍液，結果不產生廢水，而且鍍層厚度易於控制。
  3. Liberation of hydrogen gas would be increased rapidly and sic particles on the surface might be dispersed if the current density exceed the upper limit. furthermore, nickelous hydroxide would be deposited because the ph of plating solution nearby the surface rapidly increased. all of above might result in coating deterioration

    若電流密度過大，超過所允許的上限值，會析出大量的氫氣，可能沖散表面覆蓋的sic微粒，而且易使磨頭表面鍍液ph值急劇上升而形成氫氧化鎳沉澱，導致鍍層質量惡化。
  4. According the key factors we find, we bring forward a new conception : multilevel suppressor and design a new high performance suppressor whose ion - exchange membrane has bigger areas and using three electrodes including one cathode ( anode ) and two anodes ( cathode ), at the same time we fill the suppression compartment with one kind of ion exchange resin which has moderate exchange capacity. according to our experiment ' s results, we find the new type suppressor has quite high working current efficiency and suppressing capacity. in most cases, the suppressor ' s current efficiency is over 90 % ; the suppressor can transform the naoh ( concentration : 200mmol / l, flow rate : i. oml / min, conductance : over 10000 i - i s cm " ) to pure water ( conductance : 8. 9 it s cm in chapter 3, the high performance suppressor is applied in determination some trace - amounts ions in plating solution, sewage. in this chapter, we also have a research on the gradient ion chromatography

    第二章首先以xyz - 1型電化學抑制柱為例，分析了電化學抑制柱的抑制過程得出影響抑制容量的主要因素主要是抑制柱的電流效率和離子交換膜的極限電流密度，因此採用中等交換能力的離子交換樹脂作為抑制室的填料以提高電流效率，在通常情況下電流效率可達到90以上；在選用同種離子交換膜的前提下，可通過增加離子交換膜的有效面積達到提高極限電流的目的從而提高抑制柱的抑制容量，因此提出了多級抑制的概念並據此研製了共電極式高容量電化學抑制柱，該抑制柱最高可將流速為1 . 0ml / min ，濃度為200mmol / l電導率超過10000 s ? cm ~ （ - 1 ）氫氧化鈉溶液抑制為電導率低至8 . 9 s ? cm ~ （ - 1 ）的純水，並且具有穩定性高、分析結果準確等優點。
  5. Platinum detection in platinum plating solution with light - division luminosity approach

    分光光度法測定鍍鉑溶液中的鉑
  6. The corrosion potential was the biggest and the corrosion current was the smallest one when the concentration of super - 3900 was 0. 5 % ; the corrosion potential was increased with the addition of mps - dl, but the smallest corrosion current is under 0. 01 % mps - dl. the rust time was the longest one when the concentration of super - 3900 was 0. 5 % as well as mps - dl was 0. 01 %. it was increased as a peak curve with al2o3 concentration in plating solution and ph value increased gradually with cathodic current density ; the corrosion weight

    通過測量tafel曲線可知，在super - 3900濃度為0 . 5 % （相對于鍍液的體積百分含量）時獲得的鍍層腐蝕電位最正，腐蝕電流密度最小;隨著鍍液中mps - dl含量的增加，獲得的鍍層的腐蝕電位逐漸正移，在濃度為0 . 01 % （相對于鍍液的體積百分含量）時腐蝕電流密度最小。
  7. The dispersion and diffusion of the effective nickel plating solution were enhanced by adding a small amount of rare earth compound, the depositing rate, hardness, anti - wear and the surface quality of the coating were accordingly improved

    摘要通過在快速鎳電刷鍍液中加入少量稀土化合物，改善鍍液的分散能力和深鍍能力，提高鍍層刷鍍速度，從而增加鍍層的硬度和耐磨性，改善鍍層表面質量。
  8. Composition of cobalt - tungsten deposit was changed with the change of tungsten concentration and current density in plating solution

    實驗表明，隨著鍍液中鎢離子濃度的不同和電流密度的改變，鈷鎢合金鍍層組成不同。
  9. In this paper, the preparation of the source of chromium was explored. i lull cell test was used to have the research on the prescription of trivalent chromium plating solution by single factor test and orthogonal test

    本文探索了新型廉價鉻源的制備方法，並應用赫爾槽試驗，對三價鉻鍍鉻溶液的主要配方及成份進行研究。
  10. The use and maintenance of ni - p electroless plating solution in the mining machine production

    磷液在采礦機械生產中的使用與維護
  11. In this paper, the characteristics of the electroless nickel plating, the composition and fuction of the plating solution were introduced. at this base the low emissivity material was successfully prepared by the electroless plating method. the sample detected by edxa, sem, aes, ifr

    本文在系統介紹了化學鍍鎳工藝的特點、溶液組成及各組份的作用的基礎上，採用化學鍍方法制備低發射率材料，成功地在羰基鐵粉體和陶瓷粉體上實施了化學鍍鎳。
  12. The objective of the paper is to get nano sisn ^ co composite powder of high quality by electroless plating at normal temperature. the rules were researched that the composition of electroless plating solution and reaction condition had an influence on the reaction of electroless plating of nano - si3n4 with ultrasonic wave. the best composition of electroless plating solution was obtained

    本文以常溫化學鍍法制備高質量的納米氮化硅?鈷磷復合粉末為目標，研究鍍液組分及其工藝參數對納米氮化硅超聲波化學鍍鈷的影響規律，得到了納米氮化硅超聲波化學鍍的優化配方，制得了鍍層均勻，分散性好的納米復合粉末。
  13. Through parallel experiments, the rules were studied more that the composition of electroless plating solution and reaction condition affected on the reaction of electroless cobalt plating of nano - sian4 with ultrasonic wave, such as " induction period ", the speed of reaction, appearance and morphology of composite powder, the component and phases of the plating et al

    通過對比實驗，分別就鍍液組分及其工藝參數對納米氮化硅化學鍍鈷反應孕育期、反應速度、復合粉末外觀、形貌，鍍層成份及相結構的影響規律進行了深入研究。孕育期是反映化學鍍液質量，影響化學鍍效率的重要參數。
  14. The properties of composite coating is relative to the dispersion of nano - alumina in plating solution and nano - powder content in coating which is leading by particle dispersible quality

    納米顆粒分散效果的好壞將直接關繫到其在復合鍍層中的分佈和復合量，進而影響復合鍍層的性能。
  15. Formula optimization and lifetime of brightening electroless nickel plating solution

    全光亮化學鍍鎳液的組成優化及壽命研究
  16. The hardness and corrosion resistance were evaluated by, the anticorrosion mechanism was also discussed by xps as well. the composited content of particles in coating was high when 0. 5 % super - 3900 was added into al2o3 suspention before plating the composited content increased with the increase of al2o3 concentration in plating solution and the time of stirring before plating and increased as a peak curve with plating temperature, cathodic current density and ph value

    超分散劑super - 3900加入量為0 . 5 % ，對al2o3懸浮液分散后加入時，獲得的鍍層復合al2o3含量高，並隨著鍍液中al2o3含量、鍍前攪拌時間增加而增加，鍍層中al2o3含量隨著施鍍溫度、陰極電流密度、 ph值的增加呈先增加后減少的變化。
  17. 3. xrd results of ni - w - b and ni - w - b - ptfe alloy deposits obtained from the stated plating solution and condition showed that their structure were in nanocrystalline or amorphous, and the addition of boron compound and ptfe in deposits expedited them in amorphous structure. the microhardness of ni - w - b and ni - w - b - ptfe alloy were higher than that of ni - w alloy deposits

    在所述鍍液組成和沉積條件下， xjid實驗結果顯示所獲得的nlwb合金電沉積層及其復合鍍層表現為納米晶或非晶態結構，鍍層中含b物質和pite的加入加劇了鍍層結構的非晶化。
  18. Determination of no - 3 in brightening nickel plating solution by ultraviolet spectrophotometry

    用紫外分光光度法測定光亮鍍鎳液中的硝酸根
  19. Coat the surface with either nickel or copper ( nickel is now generally the preferred commercial process ) from an electroless plating solution

    用鎳或者銅在無鍍電鍍液中進行表面處理，目前鎳是更流行的商業用工藝。
  20. " induction period " was reflected the quality of electroless plating solution, and affected the efficiency of electroless plating, " induction period " was shortened with the increase of the concentration of nah2 ? o2 ? i - ho and coso4. it was shortened by increasing the ph and the loading of powder

    硫酸鈷和次亞磷酸鈉濃度的增加，鍍液的ph值升高，裝載量的增大，反應的孕育期變短；鍍速是反應時間與增重綜合作用的結果。
分享友人
分享到 Line

分享到臉書