porosity 中文意思是什麼

porosity 解釋
n. 名詞 1. 多孔性。
2. 【物理學】孔積率；孔度，隙度。
3. 多孔部分；多孔結構；多孔的東西。

  1. Test method for aluminium foil part 2 : test method for porosity

    鋁箔試驗方法.第2部分:鋁箔的針孔檢測方法
  2. Swelling and porosity of the propellant mixture became evident after 6 days at ambient temperature.

    在室溫下放置6天後，推進劑混合物呈現膨脹和氣孔。
  3. In general, smaller grain size and greater angularity tend to increase the porosity while an increase in range of particle size tends to decrease porosity

    通常，顆粒越小曲率越大孔隙度越大，而當顆粒尺寸增大時孔隙度會減小。
  4. The material was sintered at 1050 for three hours to get the porous artificial bone, that its apparent porosity was54 %, its volume density was 1. 28 g / cm3, and its bending strength was 13. 25mpa. the results showed that the sintering temperature was reduced by adding bioglass

    本研究採用含生物玻璃前驅體粉末原料，添加檸檬酸造孔劑，模壓成型，在1050燒結保溫3小時，獲得了顯氣孔率為54 、體積密度為1 . 28s cm ~ 3 、抗彎強度為13 . 25mpa的多孔hap人工骨材料。
  5. The black earth is a kind of alfisol, with a thick layer of humus, loose texture, high fertility, high porosity ratio, poor permeability and a high content of clay, which is suitable for cultivation

    摘要黑土是一種腐殖質層厚，質地鬆散，肥力很高，孔隙比較大而透水性差，粘粒含量高，適于耕作的淋溶土。
  6. With the development of human society, because of the lack of sustainable utilization consciousness, and the eager for quick success and instant benefit, the black earth suffered excessive cultivation and management, causing the reduction of its recycled ability, decrease in organic content, porosity ratio, fertility dropped and the properties of water retaining and water retention, which make the black soil harden and degenerate seriously

    但是隨著人類社會的發展，在缺乏保護和可持續利用意識、急功近利思想影響下，黑土遭到過度墾殖和掠奪式經營，人類對其活動范圍遠遠超過了其再生能力，導致有機質含量減少，肥力下降，孔隙比減小，保水持水能力降低，土壤板結，黑土嚴重退化。
  7. Shallow burial seems to preserve chalky textured porosity.

    淺埋藏似能保留具白堊狀結構的孔隙。
  8. There is no dissociative ch and bigger porosity existing in hardened mortar, depended on the testing results of xrd and sem, and this entire characteristic expresses its excellent anti - penetrability and durability

    Xrd 、 sem檢驗結果表明硬化砂漿中沒有游離的caph人存在，結構緻密，預示其有好的抗滲性能和耐久性能。
  9. Cavernous porosity can take the equidimensional form of vugs or follow channels, but the void dimensions are measurable in meters.

    溶洞孔隙可呈等尺度的溶孔形態，或者呈溶溝形態，但空間大小是以米度量的。
  10. Other factors that affect porosity are compaction, consolidation and cementation.

    影響孔隙率的其它因素是壓縮，固結和膠結
  11. The present work indicates the organic nf membranes and the inorganic nf membranes all have shortages, so develop composite nf membranes that have low cost, mechanically strong and thermally / chemically - resistant, easy to cleanout and good performances is a very important task. in this paper, the preparation of inorganic - organic composite nf membranes were presented. this composite comprise a porous sio2 / al2o3 support substrate, the pore diameters of which ranging from 10 to 15 nm, this inorganic support substrate having a polymer membrane which comprises an polyvinyl alcohol ( pva ) or polyamide ( pa ) densely deposited on at least one of the face surfaces thereof, the structural porosity of such pva and pa membrane ranging from 3 to 5 nm

    本論文以開發無機?有機復合納濾膜為出發點，首先在al _ 2o _ 3多孔微濾膜上利用溶膠?凝膠法制備sio _ 2 al _ 2o _ 3無機復合超濾膜作為無機?有機復合納濾膜的基膜；選用聚乙烯醇和聚酰胺為表面功能層材料，分別探討了以羥基丁二酸和磺基水楊酸為混合交聯劑，採用浸塗法制備了聚乙烯醇sio _ 2 ? al _ 2o _ 3復合納濾膜；以均苯二甲酰氯、哌嗪和二胺為單體，採用界面聚合法制備了聚酰胺sio _ 2 ? al _ 2o _ 3復合納濾膜，並對影響膜性能的諸多因素進行系統研究。
  12. As an advanced materials preparation technology, spray - deposition has shown remarkable superiority in producing large - sized alloys and metal matrix composites. however, the spray deposeted preforms usually contain a certain quantity of porosity. besides, the oxide films on the surface of the particles lead to week metallurgic conjunction between the particles. in order to obtain an ideal structure and performance, the porous preforms need further densifying and plastical forming. in this paper, a new technology named wedge pressing was used to densify spray - deposeted 5a06 aluminium alloy, in which the large deformation can be obtained through the sum - up of local deformation and multi - step small deformation. this method can also solved the problems in traditional processing and greatly decreased the producing cost. what ’ s more, the reserch on the wedge pressing desification rules about the large - sized spray deposeted preforms was significant it was vital not only to the further densification of the prefoums but also to the further research on plastical deforming the research was also benefit to the industrialization an the application of the spray deposeted porous materials

    坩堝移動式噴射沉積技術作為一種先進的材料制備新技術，在制備大尺寸合金及金屬基復合材料方面具有顯著的優越性。然而噴射沉積坯件特別是大型坯件通常存在一定量的孔隙，顆粒表面存在一定量的氧化膜，顆粒之間未能完全達到良好的冶金結合狀態，因此需要進行后續緻密化和塑性變形才能獲得理想的組織和性能。本文採用一種新型的楔形壓制工藝，即通過局部變形、多道次小變形累積實現大變形的緻密化加工方法，對噴射沉積多孔坯料進行后續緻密化和塑性變形，很好地解決了傳統加工工藝的難題，大大降低了生產成本。
  13. Commonly the dolomite crystals form a framework with evenly distributed porosity.

    通常白雲石晶體構成格架，它有均勻分佈的孔隙。
  14. At the late diagenesis phase, the dissolution of frame grains, especially the dissolution of felspar and laumontite, is the key to form secondary porosity

    朵狀砂體的大小直接控制油藏的范圍及規模，靖安地區的主要油藏多沿不同的朵狀體成排分佈。
  15. Specification for laboratory sintered or fritted filters including porosity grading

    實驗室燒結或熔結過濾器
  16. The investigation of a lot of parameters about treated sandstone, brick materials and earthen materials with fluorited polymers has been carried out, such as the formation of polymer, the penetration depth, porosity, capillary absorption and penetration coefficient, water uptake, compressive strength, drilling resistance, absorption isotherms of water vapor, water vapor diffusion, color changes as well as resistance to desegregation of water, frizzing - throwing cycles, worming - cooling cycles, and so on. in addition, the influence of salt crystallization, acid and base, and uv aging have also been assessed in order to better understand the protection effects and utilization possibility of two fluorinated polymers, mainly according to astm standard and the combination of international methods together with general technological

    分別以國家級文物保護單位的土質、砂巖和磚材文物樣品為對象，依據astm標準及國際通用文物保護研究方法與評估準則相結合，通過膠化物形成周期、滲透深度、孔隙度、毛細吸水和滲透系數、持水量、抗壓強度、抗鉆強度、吸附水蒸氣的能力、透氣性、外觀顏色等系列參數的測定，及凍融、冷熱循環、酸堿腐蝕后抗壓強度的衰減、可溶鹽對保護效果的影響、酸堿及光照對表面保護效果的影響，對兩種含氟聚合物及其與有機硅的共混物在文物加固保護和表面防護中的可行性和保護效果給予了系統研究。
  17. Study on the synthesis of corundum - mullite - gahnite multiphase materials by one - step sintering process using kaolinite showed that corundum - mullite - gahnite multiphase materials with the apparent porosity less than 5 % can be obtained through sintering at 1700 for 3h

    在1700下保溫3h ，能夠一步合成出顯氣孔率在5以下的剛玉?莫來石?鋅鋁尖晶石復相材料，各物相間結合緊密，發育較好。
  18. The formation of new phase such as mullite and gahnite by solid - phase reaction in multiphase materials can benefit the sintering of materials at 1700, decreased apparent porosity to less than 5 %. reducing atmosphere inhibited the synthesis of mullite and gahnite, played a negative role in the densification of multiphase materials

    固相反應生成的鋅鋁尖晶石和莫來石具有較高的活性，使復相材料在1700燒后顯示出更好的燒結性能，其顯氣孔率降低到5以下；還原性氣氛阻礙了莫來石和鋅鋁尖晶石的生成，不利於復相材料的燒結和緻密化。
  19. Based on orthogonal designed experiment, the synthesis of corundum - mullite - gahnite multiphase materials by two - step sintering process showed that the light fired temperature and holding time mostly influenced the apparent porosity of the multiphase materials. further study on the light firing time indicated that at the light firing temperature of 1300 and died fire temperature of 1600 for 3h, the optimal light fired time was about 1h

    二次煅燒及正交實驗合成復相材料研究表明：輕燒溫度和輕燒時間對復相材料的顯氣孔率影響顯著；通過輕燒保溫時間的進一步研究表明：含剛玉、莫來石、鋅鋁尖晶石的復相材料，在輕燒溫度為1300 、終燒條件為1600下保溫3h時，最佳的保溫時間為1小時左右。
  20. The studies of plane heterogeneity are as follows : the text counts the parameters of the sandlayers " geometric shape of different sedimentous microfacies ; speculates the conditions of lateral communication by sandstone density according to the method brought forward by j. r. l. allen ; gets a group of parameters including the reservoir thickness, porosity and coefficient of permeability by using kriging method according to the data of logging results ; makes certain the direction of coefficient of permeability with variation function by modeling globosity function ; divides the sandlayers into five types by using the method of flowing cell based on three parameters, that is x h, kxh and h / h, and accounts the favorable region. on the base of above - mentioned studies, the text evaluates the heterogeneity of sandlayers and gives the resolutions to these problems to serve the development of the field

    Allen ）等人提出的統計方法，用垂向上砂體密度的界限來推測砂體側向連通情況；根據每口井的測井解釋資料，利用克里金插值法對外間進行插值，得到了一組反映儲層特徵在平面上變化的參數，包括儲層厚度分佈、孔隙度以及滲透率，並且成圖；利用變差函數法，通過球狀函數模擬，確定儲層優勢滲透率方向：根據流動單元法，以儲能系數、容積系數以及凈毛厚度比三個參數為依據，通過聚類分析方法進行流動單元劃分，並且按照參數特徵將其分為五類，統計各砂層有利流動單元區塊。
分享友人
分享到 Line

分享到臉書