position gyro 中文意思是什麼

position gyro 解釋
位置陀螺
  • position : n 1 位置;方位;地點。2 處境,情況;狀態,形勢,局面。3 姿態,姿勢。4 地位,身份;職位;職務。5 ...
  • gyro : n. (pl. gyros)1. =gyrocompass. 2. =gyroscope. 3. 自轉旋翼飛機 (=autogyro)。
  1. After the simulation of sins, the actual sins is studied, especially studying the compensation of gyro ' s excursion. and it proves that the compensation can improve the navigation accuracy of sins. on the basis of the realization of sins, the integrated navigation of position / velocity for gps and sins are established, and sins and gps integrated navigation is realized by application

    在實現sins的基礎上,研究了sins與gps的位置、速度組合導航,建立全球定位系統和捷聯慣導系統的誤差方程及位置速度測量方程,應用卡爾曼濾波技術實現了sins和gps的組合導航。
  2. The gyro vertical utilizes a gyroscope as an integrating device to obtain the average position of a pendulous gravity reference.

    垂直陀螺利用一個陀螺儀作為積分裝置以得搖擺不定的重力基準線的平均位置。
  3. Analyze item by item the position of unintact cycle, the running clearance of unintact cycle, locking - deform, datum dimension regulating, repeatly install, power voltage wave and marking running etc. at the same time, we give the calculating formula to calculating the running marking random error, and use it to calculate the system error of big diameter measure instrument - - datum dimension frame error, gyro - wheel diameter error, error caused by circumstance temperature, error caused by backing distance, angle error, delay error of data collecting circuit, lathe main shaft running error, workpiece install partial error

    對不完整圓的位置、不完整圓的轉動間隙、鎖緊變形、基準尺調整、重復安裝、電源電壓波動、標記轉動等隨機誤差進行了逐項分析,並給出轉動標記隨機誤差的計算公式。對大直徑測量儀的系統誤差?基準尺尺架誤差、滾輪直徑誤差、環境溫度引起的誤差、後退距離引起的誤差、角度誤差、數據採集電路延時誤差、車床主軸回轉誤差、工件安裝偏心誤差分別進行了計算,最後對誤差進行合成。
  4. In this system, the closed loop is composed of velocity measurement machine used as velocity feedback and coder used as position feedback, the feed - forward signal of ship swaying is measured by rate gyro

    該系統用測速機構成閉環,作速度反饋,編碼器作位置反饋,速率陀螺測量並前饋艦船搖速度信號。
  5. Fiber optic gyro ( fog ) inertial system provides angular velocity and acceleration measurement of measurement body along three axes, based on the attitude matrix refreshed by outputs angular velocity to transform the acceleration from the body frame to the earth frame, finally through acceleration integral we can get the position of the measurement body in the space. fog is popular in the navigation field for many advantages, such as wide dynamic range, high resolution and all solid components

    該測量方法利用捷聯式光纖陀螺輸出的角速度和加速度信息,測出運載體沿三個方向的加速度分量;再利用光纖陀螺輸出的角速率信號,不斷更新測量體的姿態轉換矩陣,將加速度分量用轉換矩陣更換到地理坐標系;最後經過計算機對轉換后的加速度信號積分運算分別可得到運載體在三維空間中的位置。
  6. The results indicate that : with sa, the position precision of the integrated system, whose gyro drifting is 50 degree / hour and whose accelerator offset is 0. 001g, is 60 meters, its velocity precision is about 1. 75m / s out and its attitude angle precision is about 0. 25 degree. without sa, the position precision is about 20 meters, its velocity precision is about 0. 5m / s and its attitude angle precision is about 0. 1 degree. when the signal of gps is lost, the growing rate of the integrated system error is much lower than that of sins system

    模擬結果表明:對于陀螺漂移為50度/小時、加速度計零偏為0 . 001g的組合系統,在有sa的情況下,位置精度大約為60米,速度精度大約為1 . 75米/秒,姿態角精度大約為0 . 25度;在無sa的情況下,位置精度大約為20米,速度精度大約為0 . 5米/秒,姿態角精度大約為0 . 1度;在gps信號丟失時,系統誤差的增長速度比純sins系統明顯減緩。
  7. In the latter, that is in two - position alignment, the method of wavelet analysis is used to filter the output signal of optic fiber optic gyro, at last, the direction cosine matrix is gotten, the inertial components are demarcated,

    在自對準中,利用二位置初始對準,運用小波分析對光纖陀螺的輸出信號進行濾波,並且確定初始方向餘弦矩陣並對慣性元件進行標定。
  8. When a position gyro is used in the pitch plane the missile is usually launched at a set elevation.

    當位置陀螺用在俯仰平面上的時候,導彈通常以一個設定的仰角發射。
分享友人