power dissipation 中文意思是什麼

power dissipation 解釋
電力分散
  • power : n 1 力，力量；能力；體力，精力；（生理）機能；〈常 pl 〉才能。2 勢力，權力，權限；威力；政權；權...
  • dissipation : n. 1. 消散，分散；【化學】散逸。2. 浪費；消耗，損耗。3. 放蕩，閑游浪蕩。4. 消遣，娛樂。
  1. To eliminate the bootless power dissipation of the redundant transition of the clock, a design method named det ( double - edge - triggered ) shift register is proposed

    摘要從消除時鐘信號冗餘跳變而致的無效功耗的要求出發，提出雙邊沿移位寄存器的設計思想。
  2. Then, we propose a design method named det ( double - edge - triggered ) shift register to eliminate the bootless power dissipation of the redundant transition of the clock

    接著，從消除時鐘信號冗餘跳變而致的無效功耗的要求出發，提出雙邊沿移位寄存器的設計思想。
  3. It is designed dimply and low power dissipation

    其電路設計簡單而且功耗低。
  4. In practical design, not only nonideal factors from noise, mismatch, offset etc. are taken into consideration, but also the desired sub _ adc performance is achieved with reduced power dissipation

    在具體電路設計中，不僅充分考慮了噪聲、失調和失配等非理想因素，而且在實現系統對子adc的指標限制前提下，降低了功耗。
  5. For the requirement of abpm ' s low power dissipation, pocket size and 24h ambulatory mornitoring, the paper first put forward and accomplished a new method : charging self - adaption blood pressure measurement method ( csbpm ). it is the key technology on abpm

    針對abpm微型化、低功耗、 24h動態監測的要求，我們在大量理論研究和臨床實驗的基礎上，首次提出並實現了基於充氣的自適應無創血壓測量技術，它是abpm的關鍵技術。
  6. From the simulation results, we can see that, for the presented cmos preamplifier - latch comparator, its transfer delay time is 231ps, and the power dissipation is 118. 6 w

    時，其回饋噪聲對輸入信號和電阻串參考電壓產生的毛刺峰值分別是6 . 35mv ， 1 . 57mv ;各級子adc的總功耗為5 . 57mw 。
  7. As for it also has low working voltage and small power dissipation, it has became the ideal succedaneum of crt. furthermore, fed doesn ’ t need negative photo, large visual angle, wide working temperature extent

    另外， fed不需背光、視角大、工作溫度范圍寬等優點也對目前平板顯示器的主流產品有源矩陣液晶顯示器提出了嚴峻的挑戰。
  8. It shows that the injection quantity and the difference of temperature distribute as a parabola which is at the same load, and the minimum of the parabola corresponds to the optimum quantity of injection ( g ). under the condition that the quantity of injected mass, the air speed and the heat quantity is respectively g, v and q, the research demonstrates that the pentium iv chip ' s temperature variation can be controlled under 40c and work normally when the wind speed overpass 1. 5m / s and the power dissipation of the chip is 60w. otherwise this paper calculates the flooding limit of thermosiphon with several different methods

    對其充灌量、散熱量、電子元件（ cpu模擬晶元）表面與環境溫度之差及通風、流速的影響進行了系統的測試，發現充液量與溫差的關系在負荷不變時呈拋物線分佈，其極小值點對應的充液量是最佳充液量g 。在充液量為g時，對風速v 、散熱量q進行的研究表明，當風速超過1 . 5m / s后，奔騰晶元在60w發熱條件下晶元溫度小於40 ，能滿足長期正常工作。
  9. Laboratory measurement of the power dissipation characteristics of aeolian vibration dampers for single conductors

    單根導線風吹震動阻尼器功率耗散特性的實驗室測量
  10. Guide for laboratory measurement of the power dissipation characteristics of aeolian vibration dampers for single conductors

    單芯電纜風振阻振器電力分散特性實驗室測量指南
  11. Oled has been attracting much attention in recent years for its superior performance in the aspects of thin and light - weight, active emitting, wide visual angle, high brightness, fast video response time, low power dissipation, high efficiency, potential low cost, flexibleness, greenness, etc. the intrinsic characteristics of oled give visual and form factor advantages over lcd, and oled has been regards as one of the most ideal and potential next - generation display technologies with its excellent characteristic on information display and device fabrication

    它被業界公認為是最具發展前景的下一代顯示技術。本文對有機電致發光顯示器件的發展歷史、發展現狀和趨勢等都做了簡要的概括，研究了oled的器件結構、工作特徵、獲得彩色顯示的方法以及所具有的優缺點，並在此基礎上提出了一種amoled外圍驅動系統的設計方案。本驅動系統可分為屏上驅動電路和外圍控制電路。
  12. Driven by the requirements of an analog - to - digital converter ( adc ) with excellent performances, adcs have been made a rapid progress towards high speed, high resolution and low power dissipation

    為了適應各個應用領域對模數（ a / d ）轉換器越來越高的要求， a / d轉換器朝著高解析度、高速和低功耗等方向快速發展。
  13. Second, the current routing protocols of wireless sensor network are analyzed, aiming at the disadvantage that the protocols have high power dissipation and short lifetime. based on the leach routing protocol, we improve the leach routing protocol, and then name the advanced routing protocol leach new, in which we improve cluster head selection algorithm and optimal cluster number determination of leach respectively

    並重點對現有的無線傳感器網路路由協議進行了分析研究，針對這些協議存在的整體能耗高、網路生命周期短等缺點，在leach路由協議基礎上，對leach路由協議進行了改進，我們把改進后的路由協議稱為leachnew 。
  14. Secondly, compared with some other kinds of comparator structure and based on the preamplifier - latch fast - compare theory, a novel topology of cmos preamplifier latch comparator circuit is presented. considering trade - off between kickback noise and power dissipation, reference resistance value is optimized. according to the encode demands of different stage resolution, clock - control encode circuit is designed

    其後，在具體的子adc設計中，對比各比較器類型的優缺點，並基於預放大鎖存快速比較理論，提出一種新型高速低功耗預放大鎖存比較器電路拓撲;根據adc系統所允許的參考電壓最大波動限制，在回饋噪聲對輸入參考電平的影響和功耗之間折衷，確定優化的參考電阻串阻值;根據不同級精度的編碼要求，設計出時鐘控制編碼電路。
  15. Two cost functions, targeting area and power, are presented. switching activities of an fsm is linked to its power dissipation

    引入了以優化面積和功耗為目的的價值函數，並把有限狀態機的開關活動性和它的功耗聯系在一起。
  16. It also put forward that how to select appropriate epilayer doping concentration and thickness, pn junction depth and jte technology to increase the breakdown voltage of 4h - sic mps. a power dissipation model of 4h - sic mps was established

    通過對4h - sicmps擊穿特性的二維模擬，提出如何選擇合適的pn結深度、外延層摻雜濃度和厚度以及如何運用jte終端技術來提高擊穿電壓。
  17. Reducing power dissipation during delay test application

    降低時延測試功耗的有效方法
  18. A major problem was heating of the motor due to internal power dissipation and subsequent expansion problems, which eventually caused the table to blind.

    主要的問題是馬達內部功率損耗引起的熱膨脹，嚴重的將造成轉臺鎖住不動。
  19. The power dissipation of 4h - sic mps was calculated. the influences of temperature on sic mobility, ionization rate and intrinsic carriers density were taken into account

    建立了4h - sicmps的功率損耗的解析模型並對其功率損耗特性進行了計算。
  20. The working mechanics, optimum design and power dissipation was studied in this thesis. the transport characteristics of 4h - sic mps was simulated. the working mechanics of 4h - sic mps was two - dimensional analyzed

    本文對4h - sicmps的工作機理進行了模擬分析，優化設計了器件結構，並對其功率損耗特性進行了研究。
分享友人
分享到 Line

分享到臉書