pressure atomizer 中文意思是什麼
pressure atomizer
解釋
壓力零化器-
Then the paper also study the atomizer structure ( the protrusion of the delivery tube value h ), atomizing gas pressure p, over - heat temperature of alloy a t, the component of solder alloy and atomizing medium and so on
進一步對霧化器結構（導液管突出高度h ） 、霧化氣體壓力p 、合金過熱度t 、焊錫合金成份和霧化介質進行了研究。 -
The optimal parameters of making high silicon content aluminum alloys is : spray height is 220 - 230mm, spray angle is 30 ? the scanning velocity of atomizer is 30mm / s, the original offset of the substrate is 30mm, rotation velocity of the substrate is 120rpm, spray gas pressure is l. ompa, the diameter of the delivery tube is 3. 6mm, the drawing velocity of the substrate will be adjusted on - line with a plc on the basis of the spray
通過對多層噴射沉積原理及工藝參數的研究，得出制備al - 22si - 3cu - 1mg合金的最佳工藝參數為：噴射高度為220mm - 230mm ，基底轉速為120rpm ，霧化器掃描速度為30mm / s ，基底下降轉速依據噴射情況由智能控制器進行實時調整，噴射角度為30 ，初始偏心距為30mm ，導流管直徑為3 . 6mm ，霧化氣壓為1 . 0mpa 。
分享友人