probe method 中文意思是什麼
probe method
解釋
四點探針法-
Methods to probe into the experience of nursing work of high qualification using phenomenon study method, call on 16 nurses above 40 or charge nurse using semi - framework method thoroughly, divide into reading, analysis, introspection, classification, abstraction five steps to analyze the conversation data, and abstract motif
方法採用現象學研究法探索高年資護士對護理工作的體驗，以半結構式的深入會談法對16名年齡40歲或主管護師職稱護士進行訪談，對訪談資料採用閱讀、分析、反思、分類、提煉5個步驟進行分析，提煉出主題。 -
Measure current density by probe method
電弧的電流密度 -
The main work and achierement are as following : ( 1 ) by using shock impedance matching technique and electric probe method, 5 shots of impact experiments were conducted to measure the hugoniot equation of state for enstatite ( mg0. 92, fe0. 08 ) sio3 with the average initial density 3. 05g / m3 from shock pressure 50 gpa to 115gpa, using two stage light gas gun
本文研究取得的認識主要有以下幾點： （ 1 ）用阻抗匹配法和電探針技術在80 115gpa壓力范圍內對平均初始密度為3 . 05g / cm ~ 3的頑火輝石樣品進行了5發hugoniot狀態實驗測量。 -
The surface resistance and electromagnetic interference ( emi ) shielding effectiveness of the conductive fabrics were measured by four point probe method ( astmf 390 ) and the coaxial transmission line method ( astm d4935 - 99 ), respectively
分別用四探針法和雙軸傳輸線法測量了導電滌綸織物的表面電阻和電磁屏蔽效能。 -
The four - probe method to measure the conductivity of metal thin board
金屬薄板電導率的四探針測量法 -
Water quality - determination of fluoride - part 1 : electrochemical probe method for lightly polluted water
水質.氟化物的測定.第1部分:輕度污染水的電化學探頭法 -
Standard test method for water content of soil and rock in - place by the neutron depth probe method
用中子深探針法對應有位置的土壤和巖石的含水量的標準試驗方法 -
Method for determination of dissolved oxygen in water : electrochemical probe method
水中溶解氧的測定方法.電化學探測法 -
Water quality - determination of dissolved oxygen - electrochemical probe method
水質溶解氧的測定電化學探頭法 -
Water quality ; determination of dissolved oxygen by the electrochemical probe method iso 5814 : 1990 ; german version en 25814 : 1992
水質.溶解氧的測定.電化學探頭法 -
A new thermal probe method for determining thermal conductivity based on the minimal dispersion of thermal diffusivity
據熱擴散率最小離散度確定導熱系數的新熱探針法 -
Water quality - physical, chemical and biochemical methods - determination of fluoride : electrochemical probe method for potable and lightly polluted water
水質.第2部分:物理化學和生物化學方法.第41部分:氟化物含量測定:輕度污染水便攜式電化學測探器法 -
Soil quality. determination of water content of the unsaturated zone. neutron depth probe method
土壤質量.不飽和區域水含量的測定.中子深度探測法 -
Soil quality - physical methods - determination of water content in the unsaturated zone - neutron depth probe method
土質.物理法.不飽和區域水含量的測定.中子深度探測法 -
Secondly, basing on the theory of on - off gain of small signal, the raman gain coefficient for frequency shift between 0. 5 and 20 thz of standard sigle mode optical fiber is measured by pump - probe method through a super luminescent diode ( sld ) as a broadband small signal probe source. thirdly, numerical simulation analysis of gain characteristic of raman fiber amplifier for c band wdm signal light is made according to the raman gain coefficient of the fiber measured before through target and four rank runge - kutta method. at the invariability of wavelength and maximum power of each of two pumps, schematic of powers of two pumps for best flatness on c band wdm optical gain was found out, at the same time, the factors of resulting in gain saturation is analyzed, too
本文首先應用經典的電磁理論對拉曼光纖放大器的工作機制進行了分析，然後，根據小信號理論推導出的開關增益求出了光纖拉曼增益系數的表達式，採用泵浦-探測波的方法，利用超輻射激光二極體（ superluminescentdiode簡稱sld ）作為探測光源，測量了所用標準單模光纖頻移為0 . 5 - 20thz的拉曼增益系數，之後根據所測得的光纖的拉曼增益系數譜對應用該類光纖構成的放大c波段wdm光信號的拉曼光纖放大器的增益特性採用打靶法和四階龍格- - -庫塔進行了數值計算，在給定了兩個泵浦光源的波長和最大功率后，找出了反向泵浦情況下使c波段wdm光源增益最平坦的兩個泵浦的各自最佳功率，同時也分析了導致信號光飽和的原因。 -
In this paper, firstly, monolithic materials cosb3 and bi2te3 were prepared by sparkle plasma sintering ( sps ) respectively, and at the same time the microstructure of cosb3 and bi2te3 were studied by sem ; the seebeck coefficients and electrical conductivities of monolithic materials were measured by standard - four - probe method ( ulvac zem - 700 ) in a he atmosphere simultaneously, and their thermal conductivities were investigated by laser flash method ( tc - 7000 ) in vacuum. secondly, the junction temperature of graded bi2te3 / cosb3 thermoelectric materials was optimized based on the thermoelectric transport properties of monolithic materials, also when graded materials were used in the temperature difference ranging from 300k to 800k, the length ratio of monolithic materials cosb3 and bi2te3 were optimized in theory. thirdly, graded bi2te3 / cosb3 thermoelectric materials were prepared by two - step sps sintering, and the relationship between its average seebeck coefficients and temperature were calculated by theory mo del
均質材料cosb _ 3和bi _ 2te _ 3的電導率和seebeck系數採用標準四端子法于he氣氛下在zem - 1上同時進行測量；熱導率採用激光微擾法（ tc - 7000 ）于真空狀態下進行測量；其次，在對均質材料cosb _ 3和bi _ 2te _ 3熱電傳輸特性研究的基礎上，對結構梯度bi _ 2te _ 3 cosb _ 3熱電材料的界面溫度進行了優化；為了使結構梯度bi _ 2te _ 3 cosb _ 3熱電材料在300k至800k的溫度范圍內具有最佳的熱電性能，本研究同時對梯度結構熱電材料當中均質材料cosb _ 3和bi _ 2te _ 3材料的長度進行了優化設計；第三，通過兩步放電等離子燒結的方法制備出了結構梯度bi _ 2te _ 3 cosb _ 3熱電材料；採用理論計算的方法研究了梯度結構熱電材料平均seebeck系數和溫度的關系；同時為了驗證設計的結果，本論文對結構梯度bi _ 2te _ 3 cosb _ 3熱電材料的開路輸出電壓和熱端溫度之間的關系及梯度材料在300k至800k的溫度范圍內使用時的功率輸出進行了相應的研究。 -
Integrated circuits - measurement of electromagnetic emissions, 150 khz to 1 ghz - measurement of conducted emissions - magnetic probe method
集成電路. 150khz 1ghz電磁輻射的測量.磁性探測法 -
Integrated circuits - measurement of electromagnetic emissions, 150 khz to 1 ghz - part 6 : measurement of conducted emissions ; magnetic probe method
集成電路. 150khz - 1ghz電磁輻射的測量.第6部分:傳導放射測量.磁探測器法 -
Integrated circuits - measurement of electromagnetic emissions, 150 khz - 1 ghz - part 6 : measurement of conducted emissions - magnetic probe method
集成電路. 150khz - 1ghz電磁輻射的測量.第6部分:傳導輻射的測量.磁探測器法 -
Soil : investigation and testing. well logging. neutron probe method
土壤:調查和試驗.測井.中子探測方法
分享友人