process kinetics 中文意思是什麼

process kinetics 解釋
加工動力學
  • process : n 1 進行，經過；過程，歷程；作用。 2 處置，方法，步驟；加工處理，工藝程序，工序；製作法。3 【攝影...
  • kinetics : n. pl. 〈用作單數〉動力學。
  1. Kinetics of the phase transformation of chalcopyrite in roasting process at lowtemperature in presence of additives

    黃銅礦硫化焙燒相變反應動力學研究
  2. Therrnogravimetric analysis at heating rates 5, 10, 15 and 20 c / min was used to study the decomposition kinetics of the pdms / pma ipn in ni and in air by using tg and dtg, and the upper limit of the temperature was 700 c. it was found that ipn began to decomposite at 350 c. the process of the thermal degradation was multiple steps, the curve of the rate of thermal decomposition had two peaks, one of which lied between 400 c ~ 420 c and the other lied between 500 c ~ 540 c, the result corresponded to the components of ipn

    在熱分解動力學研究中，通過在兩種氣氛中，分別以5 、 10 、 15和20 min四種升溫速率條件下，採用tg - dtg聯動測試， ipn材料在350開始熱分解。熱分解速率存在兩個峰值，一個分解峰值在400 420之間，另一個在500 540之間，這與ipn結構中包含兩組分相對應，同時發現當緩慢升溫時，特別是在空氣氣氛中，兩個分解峰減弱，熱分解趨向於一個連續過程。
  3. Study on the esterifying process and kinetics of polythylene - glycol and methacrylic acid

    聚乙二醇與甲基丙烯酸的酯化工藝及動力學研究
  4. To develop a cad system for cardan cross - groove sphere, the kinematics model of cardan cross - pin spindles and the kinetics model of cardan cross - groove sphere are set up. 3. by applying com / com + technology on the whole development process of a cad system for cardan cross - groove sphere, which is based on the kinematics model and the kinetics model, several practical com components are acquired

    以建立的十字軸式萬向聯軸器的運動學模型和十字環槽式萬向聯軸器的力學模型為基礎，採用基於組件的軟體開發方法，將com com +組件技術應用於十字環槽式萬向聯軸器計算機輔助設計的整個過程，設計出多個具備一定實用價值的com組件。
  5. A co2 laser with the optimized resonator is made and to be proved by experiments. this dissertation focus on the following problems : the kinetics process of the cvl and the co2 laser, the rate equations for the laser level population, electron temperature and electron density

    本文的重點是：闡述清楚銅蒸汽激光和二氧化碳激光的動力學過程，定量描述激光能級的粒子數速率方程、電子溫度和電子密度等速率方程
  6. Abstract : the mathematical model that describes the reaction kinetics and molecular weight distribution for the polycondensation reaction process is developed by methods of reaction extent and generation function, in which an industrial process of poly ( ethylene terephthalate ) production is taken as an example. the methods for solving the model are discussed

    文摘:以一個工業化聚酯生產過程為例，將反應度法和生成函數作為工具，建立了描述此類縮聚反應過程的反應動力學及其分子量分佈的數學模型，並介紹了求解數學模型的方法。
  7. Based on the a - amylase - catalyzed hydrolysis of starch, pqci method has been developed to monitor the growth process of bacillus subtilis and the variation of the a - amylase activity during the growth. bacteria growth equations were derived based on the kinetics of the enzyme - catalyzed hydrolysis of starch

    將pqci技術應用於對枯草桿菌生長的研究，並且基於-澱粉酶對水溶性澱粉的酶促反應，推導出了枯草桿菌的pqci生長模型，包括諧振頻率、動態電阻和動態電感模型。
  8. In the shock tube, the detonation parameters, such as critical initiation energy, detonation velocity, detonation pressure, detonation limitation and etc., have been measured and the relation is too obtained between detonation parameters and equivalence ratio. chemical kinetics process of hydrocarbon fuel has been analyzed according to the chain reaction mechanism

    在立式激波管中測試了工業燃料c _ 5h _ （ 8 . 68 ）的臨界起爆能、爆速、爆壓、爆轟極限，得到了爆轟參數與當量比之間的關系；從爆轟反應是一個鏈反應機理出發，分析碳氫燃料的反應動力學過程。
  9. The thermal return reaction of hg ( hdz ) 2 doped in pmma film in the photochromic process follows second - order kinetics from ambient to 65

    摘要雙硫腙汞絡合物在摻雜的pmma膜中的熱回復反應在不同溫度下遵循二級反應動力學過程，其光致變色反應機理應為雙分子過程，即分子間的氫轉移過程。
  10. With the thermodynamic theories and techniques, it is relatively easy to determine the phase equilibrium data with enough accuracy, however there still exist much more difficulties in crystallization kinetics study even for a simple binary system. that is the reason that nucleation and crystal growth rate are generally represented in form of the empirical expressions. the crystallization kinetic is important for crystallizer design, process control and optimization, and it is strongly depended upon the accurate characterization of process information concerning with multiphase flows and the further disclose of its mechanisms with suitable mathematical models

    熱力學理論和方法已足以獲得準確的相平衡關系；然而即使對于簡單的二元物系的結晶過程，晶核形成和晶體生長動力學的研究仍面臨許多困難，通常採用經驗模型表述，而動力學參數的準確性和可靠性是結晶器放大設計、過程式控制制與優化的關鍵，因此多相流信息的準確表徵、結晶機理的進一步揭示及建立起與之相適應的數學模型有著十分重要的學術研究和實際應用價值。
  11. This course introduced solubility equilibria, oxidation - reduction equilibria, fundamentals of process kinetics, fundamentals of surface and colloidal chemistry, coagulation in water treatment, water softening and neutralization, and ac adsorption

    本課程將簡介溶解度平衡、氧化還原平衡、動力學基本原理、表面和膠體化學基本原理、水處理之混凝、水質軟化與中和以及活性碳吸附處理等。
  12. Kinetics for hybrid process of continuous fermentation and ethanol separation in a silicone rubber membrane bioreactor

    硅橡膠膜生物反應器連續發酵與乙醇分離耦合動力學研究
  13. Recrystallization kinetics of the galvanized strip continuous annealing process with acceleration

    熱鍍鋅原板變速連續退火再結晶動力學
  14. In this dissertation, the reaction kinetics, modeling and optimization of naphtha catalytic reforming process, which is a very important process in hydrocarbon processing industry for octane improvement or as sources of aromatics and hydrogen, is studied

    本論文圍繞催化重整過程，對重整反應機理、過程模型建立、模型參數估計、過程優化等問題進行了研究。
  15. In this paper, to investigate the coagulation process of inorganic suspended particles ( isp ), online monitoring of the coagulation process was conducted by using pda2000. the process of floe formation and the morphological characteristics of floes were investigated in detail through tv - microscope. the mechanism of partical collision and coagulation kinetics were preliminary discussed

    為了考察無機懸浮顆粒體系的混凝過程，研究絮凝體的構造特徵，本文通過pda2000對無機懸浮體系的混凝進行光學在線監測，運用電視顯微攝像儀對絮凝體的形成過程及其形態學特性進行了系統的研究，對膠體顆粒碰撞機制及混凝動力學作了初步探討。
  16. Kinetics of 8 " phase precipitation and influence of electric field applying during solution process are studied by differential scanning calorimetry ( dsc ) technique

    以示差量熱分析技術（ dsc ）研究相析出的動力學及固溶電場的影響。
  17. By using liquid - liquid extraction and photochemical desulfurization process, the technology for photochemical degradation of sulfur compounds and kinetics of reaction was investigated

    摘要從液液萃取光化學脫硫工藝入手，研究光化學反應降解含硫化合物技術並探討其動力學規律，同時還對光處理后的汽油烴族組成變化進行了考察。
  18. The reason of this may be as follows, firstly, the model has not including some important physical process such as gap effect, wall quenching extinction effect, which may greatly influence the emissions ; secondly, the emissions formation in the cylinder are not all of equilibrium process but the process controlled by the chemical kinetics

    原因之一是本模型未考慮諸多對排放具有顯著影響的物理過程，如縫隙效應、壁面激冷淬熄效應等，其次說明發動機的缸內的過程並不全是平衡過程，許多排放物的生成受化學反應速度，即化學動力學的控制。
  19. A novel model for residual fluid catalytic cracking process ( rfcc ) is proposed. it divides the whole reactor into two part : the riser as ideal pipe flow reactor and the sett - ler as ideal cstr. the model contains six lumps reaction kinetics with serial and parallel network

    通過將實際裝置中發生裂化反應的提升管和沉降段反應器分別考慮為理想的活塞流反應器和連續攪拌式反應器，建立了簡化的渣油催化裂化反應6集總組分的串列和并行反應動力學網路模型。
  20. In this paper, we introduce the function of the confocal laser scanning microscopy in the studies of protein crystal growth kinetics, such as measuring the numbers of crystal, reconstruction 3 - d image to acquire the information of crystal growth process

    本文介紹了其在定量測量晶體的個數，重組三維圖像以獲得晶體生長的過程信息及測定晶體生長臺階動態變化等方面的應用。
分享友人
分享到 Line

分享到臉書