pseudo shear 中文意思是什麼

pseudo shear 解釋
似剪切
  • pseudo : adj. 〈口語〉假，偽，冒充的。
  • shear : vt vi （sheared 〈古語〉 shore; shorn sheared）1 剪（羊毛等）；修剪（樹木）；剪（呢絨的）長毛。2 ...
  1. The shear mechanism, failure mode, deformation capacity, bearing capacity and the reliability of the anchored angle steels of the wrapped steel concrete cast - in - site frame typical story exterior joints under the middle and high axial compression ratio ( n = 0. 3, 0. 5, 0. 6 ), the working performance, failure mode, and the shear capacity of top story joints under the crack moment, the hysteresis characteristic and the dissipation energy capacity of the test joints are all analysed based on the 1 / 4 model pseudo - static tests of five specimens of wrapped steel concrete cast - in - site frame exterior joints, which varied in axial compression ratio, distribution of the beam angle steels and the stirrup ratio

    基於上述分析，本次試驗通過五個外包鋼混凝土邊節點1 4比例模型的偽靜力試驗，以柱的軸壓比、梁角鋼布置形式、配箍率等為主要參數，分析外包鋼混凝土現澆框架一般層邊節點在中高軸壓比（ n = 0 . 3 、 0 . 5 、 0 . 6 ）條件下，節點的抗剪機理、破壞模式、變形能力、承載能力和角鋼錨固的可靠性；分析了頂層邊節點在張開彎矩作用下的工作性能、破壞模式和抗剪承載力；分析了試驗節點的滯回性能和耗能能力。
  2. To meet the demands for large space and flexible compartmentation of buildings, laminated vierendeel trusses are adopted in high - position transfer story structures. first the bearing characteristics are analyzed, in which reasonable stiffness ratio of the upper chord, middle chord, and lower chord is derived. then combined with an actual engineering model ( 1 8 similar ratio ), the static loading and pseudo - dynamic tests of two models for laminated vierendeel truss used in transfer story structures are conducted, in which one model adopts reinforced concrete, and the other adopts prestressed concrete and shape steel concrete. seismic behaviors are analyzed, including inter - story displacement, base shear - displacement skeleton curves, and equivalent viscosity - damping curves. a program is programmed to carry out the elasto - plastic dynamic analysis, and displacement time - history curves of the two models are derived. the test and analysis results show that the laminated vierendeel truss with prestressed concrete and shape steel concrete has excellent seismic behaviors. it can solve the disadvantages of laminated vierendeel trusses used in transfer story structures. finally, some design suggestions are put forward, which can be referenced by similar engineering

    為滿足建築物大空間和靈活隔斷要求，在高位轉換層結構中採用迭層空腹桁架結構.首先分析了其受力性能，得出了空腹桁架各構件合理的截面剛度以及布局形式.然後結合一實際工程，進行了兩榀迭層空腹桁架轉換結構模型（ 1 : 8相似比）的豎向荷載下靜力試驗以及擬動力試驗.其中一榀為普通混凝土迭層空腹桁架，另一榀配置了預應力和鋼骨混凝土，對比分析了兩模型的層間位移比、骨架曲線以及等效粘質阻力系數等抗震性能的比較，並進行了彈塑性動力分析.試驗和分析結果表明，配置預應力和型鋼混凝土的迭層空腹桁架轉換結構具有良好的抗震性能，可以成功地解決迭層空腹桁架作為轉換層結構所產生的弊端問題，最後對這類轉換層結構提出了相應的設計建議
  3. Based on the pseudo - static experimental results of nine abnormal joints, the damage process of abnormal joint is divided into four stages of original crack, entire crack, ultimate state and failure, the effect of axial force ratio, stirrup ratio and height of column section on seismic behavior of abnormal joint are discussed, the conclusion that anti - shear capacity of abnormal joint are studied in entire crack state by studying the minor core of abnormal joint is made, the calculating formula for anti - shear capacity of abnormal joint is proposed with a view to asymmetry in stirrup yield

    摘要根據9個鋼筋混凝土框架異型節點試件的擬靜力試驗結果，指出異型節點受力過程分為初裂、通裂、極限和破壞4個階段；討論了軸壓比、節點核芯配箍率、柱截面高度變化對異型節點抗剪性能的影響；提出應考慮節點核芯區箍筋屈服的不均勻性並在通裂狀態下以「小核芯」為分析單元來研究此類節點抗剪承載力的建議；最終給出了異型節點抗剪承載力的計算公式。
  4. The seismic behavior of longitudinal middling - high r. c shear wall with frame column is discussed through model experimentations and finite element methods in this paper, after taking frame - shear wall structure of a main factory building of the large capacity power plant as experimentative prototype. the major work as follow : in order to appliance pseudo static test, the longitudinal middling - high r. c shear wall with frame column in the large capacity power plant ' s main factory building has been simulated to a model structure with 1 / 15 reduced - scale. the contents of study are process of cracking, course of damage, skeleton curve, rigidity degradation, ductility characteristic etc. that the seismic behavior of this kind of middling - high r. c shear wall is excellent has been proved by chubby hysteretic curve and fine capacity of energy dissipation

    本文以某大型火電廠主廠房縱向框架一剪力墻結構為原型，通過模型試驗和有限元分析，研究了縱向帶邊框柱中高剪力墻結構的抗震性能問題，主要內容有：選用1 15縮尺比把某大型火電廠主廠房縱向帶邊框柱剪力墻原型結構模擬為一個模型結構，並進行了偽靜力試驗，研究了這類縱向帶邊框柱中高剪力墻結構的開裂與破壞過程、骨架曲線、剛度退化、延性性能等問題，試驗滯回曲線飽滿，消能能力強，說明此類中高剪力墻的抗震性能較好。
  5. The major contents are as following : through a test of 1 / 15 - scaled model, the shear wall of a longitudinal frame - shear wall structure main factory building of the large power plant is modeled as testing model structure, and is tested by pseudo static test. this paper mainly investigates the loading behavior, failure proceeding, strength, rigidity, deformation, ductility and energy dissipation capacity of the model structure

    主要內容如下：採用1 15縮尺比，把某大型火電廠主廠房縱向框架?剪力墻原型結構中的剪力墻模擬為試驗模型結構，並對其進行偽靜力加載試驗，研究了此類結構的受力特點、開裂與破壞過程、承載力、剛度、變形、延性及耗能性能等問題。
  6. Based on the pseudo - static experimental results of nine specimens 1 / 5 - scale specimens and failure characteristic in the structural test, the damage mechanism and the failure of abnormal joints under the shear force is analyzed. the paper discusses the possible affections of stirrup ratio, the changes of beam or column sections and initial eccentricity on carrying capacity of abnormal joints. according to experimental data, the formula for calculation of the shear - bearing capacity of abnormal joints is given

    針對該類框排架結構中通常存在異型節點的實際，在9 （其中邊節點4個、中節點5個）個1 5的偽靜力試件試驗研究及整體結構模型中該類節點破損特點的基礎上，提出了異型中節點和邊節點的破壞機理，針對異型中節點和邊節點的受力特點給出了該類異型節點的抗剪承載力計算公式和節點區的加強構造措施。
  7. According to the pseudo static tests on two specimens of transfer floor from inclined column to framed short - leg shear wall, which are subjected to the vertical loads and the horizontal cyclic loads, in this paper the stress distributions, final failure model of the specimens, paths of the load transfer and the mechanical behaviors of the transfer beam are studied in detail, the ductility and energy dissipation of the specimens are also specially studied

    摘要通過對兩榀框支短肢剪力墻斜柱轉換結構在豎向荷載及水平低周反復荷載共同作用下的擬靜力試驗，分析了試件的應力分佈狀態、破壞形態、荷載傳遞規律以及轉換梁的受力性能和試件的抗震性能。
  8. With the increasing of montmorillonite content, the composites showed a trend of pseudo - solidlike at lower frequencies, the montmorillonite layers could align along the stress direction, and as a result, the dependence of dynamic modules on the frequency was quite different before and after suffering from large amplitude oscillatory shear

    然而當蒙脫土含量低於和臉或蒙脫土片層在基體中呈完全團聚狀態，則復合材料表現出與聚合物基體類似的線性粘彈特性。實驗發現，在熔體經大振幅振蕩剪切后，上述「類固.
  9. The pseudo - dynamic test gives the model ' s earthquake response, failure characteristic and special seismic property, unveil the structure ' s failure procedure of " low density setin block ' s break - slab rib ' s break - end post ' s concrete craze - end post ' s steel bar yielding ", providing full and accurate experimental information to establish the seismic design method. the slab ' s crack discrimination condition is prescribe. the extreme shear strength bearing moment, shear and pressure synchronously shows the bearing capacity components and change in slab ' s failure process

    提出了密肋復合墻體開裂的判別條件；對于墻體在彎剪壓耦合作用下的極限抗剪承載力性能，分析了其構成因素及其隨破壞過程的變化規律；在試驗研究和數值分析的基礎上，提出密肋復合墻體抗剪和抗彎承載力表達式，並對典型墻體多遇地震作用下的承載力可靠指標進行了驗算；對影響墻體抗剪能力的各種因素進行了顯著性分析。
  10. The pseudo - dynamic test of 1 / 3 - scale model six - story building assembled with hollow shear wall with seams. the internal forces, the deformation and the failure mechansm of the building under earthquake are studied. the rules of frequency, damping and response spectrum are studied. the characters of earthquake response such as structure displacement, interstory drift, action of earthquake, the amplificatory coefficient of acceleration and the rule of strain are discussed. at last, this paper presented the design method of this structure based on the aseismic style and put forward the construction

    進行了帶縫空心剪力墻結構六層樓房的1 3模型的擬動力試驗，研究了結構在水平地震作用下的受力特點、變形特徵、破壞形態等力學性能；得到了結構在不同受力階段的頻率、阻尼、反應譜等動力特性變化規律；討論了結構各樓層的水平位移、層間位移、地震力、加速度放大系數及構件應力分佈規律等結構地震反應特徵；指出了結構的抗震類型、薄弱層及薄弱部位；提出了多層帶縫空心剪力墻結構的第一階段設計方法和相應構造措施。
  11. Structure will be a kind of ductile structure with advanced seismic behavior. based on the tests of 25 elements of hollow shear wall r. c. structure and 16 hollow shear wall, we had accomplished pseudo - dynamic tests which employed el - centro wave with different input peak acceleration and pseudo - static test of 1 / 2. 8 scale model 10 - story building

    在已完成了25個基本空心剪力墻試件和16個墻片的試驗基礎上，進行了空心剪力墻結構十層樓房1 2 . 8的模型擬動力、擬靜力試驗，擬動力實驗採用不同輸入峰值加速度的el - centro （ ns ）波。
  12. First, one type of sma - based passive energy dissipation device was developed to utilize pseudo - elastic property. then, according to the characteristic of response of the passive energy dissipation systems, adapting the bilinear restored force model, the mof shear type elastic - plastic time history analysis program is compiled. the vibration - suppressed is verified and vibration control mechanism of sma dampers is studied by time - history analysis

    首先利用sma的超彈性性能，設計了一種新型的耗能減震裝置；其次，結合耗能減震結構的動力反應特點，採用雙線性模型，編制了耗能減震結構串聯多質點體系彈塑性時程分析程序，通過對有控結構和無控結構的地震響應分析比較，檢驗了sma耗能器的被動控制效果，探討了其控制機理。
分享友人
分享到 Line

分享到臉書