pull out test 中文意思是什麼

pull out test 解釋
失步試驗
  • pull : vt 1 拉，拖，牽，曳 （opp push）; 勒（馬）。2 拽住；扯破，扯開。3 拔去（雞等的）毛；拔（牙齒、瓶...
  • out : adv 1 〈位置及運動的方向〉向外，向外部；在外，在外部；出去，出外，離開；離岸，向海面；（船等）開...
  • test : n 1 檢驗，檢查；考查；測驗；考試；考驗。2 檢驗用品；試金石；【化學】試藥；（判斷的）標準。3 【化...
  1. Soil reinforcement. backfilled structures reinforced with quasi - inextensible and flexible reinforcing strips or sheets. static pull - out test with constant rate of displacement

    土壤增強.用近似不伸長的軟帶或板加強的回填結構.恆速位移靜推試驗
  2. Finally, an energy approach is combined with the fem in the simulation of the crack propagation along the fiber / matrix interface in a pull out process. the simulated results are in nice conformity with experimental results. the second part of the research deals with the characterization of the failure process in the fragmentation tests, which is one of the most frequently used test methods in studying thermal mechanical properties of fiber / matrix interfaces

    在這一部分工作的最後，採用能量法與有限元法結合起來，模擬纖維抽拔試驗中裂紋的擴展:針對以往研究工作中的不足之處，在模擬中使用能量釋放率，在表徵界面破壞時，所使用的應力強度因子考慮了纖維和基體兩種材料的不同屬性，並考慮裂紋尖端的單元奇異性，來研究裂紋長度和溫度對裂紋擴展的影響。
  3. Currently, the main methods used to measure the fiber / matrix interface properties of composite were based on micro - mechanics, including single - fiber composites fragmentation test ( sfc ), micro - debonding technique, single - fiber pull - out test, and single - fiber push - out test, in which sfc was most widely used

    目前直接用來測定纖維增強復合材料界面力學性能的主要微觀力學方法有單纖維復合材料斷裂實驗（ sfc ） 、微脫粘方法、單纖維拔出法、單纖維頂出法，其中以單纖維復合材料斷裂實驗的應用最為廣泛。
  4. Although numerical methods have frequently been used in the study of frc, theoretical analyses of such test methods as pull out tests and single fiber fragmentation tests, seemingly simple, remain to be challenging problems. problems arise when other factors are considered in connection with the various numerical models. these factors include nonlinearities in the properties and / or geometries of the materials, influences of such environmental conditions as temperature ( which is also to be studied in the present work )

    本論文正是針對以往研究中的不足，在對纖維增強復合材料破壞問題進行數值模擬的研究中，綜合考慮了纖維和基體材料的非線性效應、纖維和基體材料受外載發生大變形時的幾何非線性，以及纖維基體之間界面脫粘時接觸單元的非線性效應。
  5. Through the pull - out experiment, the load displacement curve was obtained. contrasting the test results under the different condition to post - installed bar, it was clear about the mechanism of the inorganically post - installed bars. the test results of inorganically post - installed bars was compared especially with the traditional organically post ? installed bars

    通過拉拔試驗，得到了荷載位移曲線，對比了不同條件下植筋的試驗結果，明確了無機植筋的受力過程，特別同有機植筋進行對比，並提出了帶錐頭無機植筋的施工工藝。
  6. Rubber, bulcanized - determination of adhesion to single - pull out test

    硫化橡膠與單根鋼絲粘合力的測定抽出法
  7. Roofing. fasteners. determination of the characteristic resistance of the assembly. test method to determine the pull - out load of fixings out of insulating material or sealing coating from the frame

    屋面.緊固件.組件抗性的測定.測定嵌固件從框架絕緣材料或密封塗層拉拔力載荷的試驗方法
  8. Reinforcement of soils by inclusion. nail pull out. test with constant rate of displacement

    摻雜法土壤加固.拔釘法.恆定位移速率試驗
  9. Roofing and wall cladding. fasteners. determination of the characteristic resitance of the assembly. test method to determine pull - out load of fasteners in crow or valley fixing out of their subconstruction

    屋面和墻壁覆面.緊固件.組件抗性測定.拱頂和屋面排水溝安裝的緊固件從基底拉出的拉拔負荷的測定試驗方法
  10. Electric connectors - cable pull - out test

    電連接器.電纜拔出試驗
  11. This paper first present a study on the bond properties of furan resin concrete reinforced with gfrp bars, in which the pull - out test was adopted to investigate the bond performance between gfrp bars and furan resin concrete, compare the bond strength of gfrp bars of different surface disposal and validated the feasibility by test the gfrp bars reinforced furan resin concrete beam. then the paper provides a micro - mechanical model for the splitting failure analysis of gfrp reinforced concrete member and deducted the relation between splitting failure load and parameter of gfrp rod

    本文首先對gfrp筋加強呋喃樹脂混凝土及普通混凝土的界面粘結性能進行了實驗研究，對玻璃鋼筋表面採取了三種處理方法，用拔出試驗研究分析了gfrp筋和呋喃混凝土、普通水泥混凝土之間的粘結強度，比較了用不同方法進行表面處理的效果，確定了合適的表面處理方案，並通過對gfrp筋加強呋喃混凝土梁進行了彎曲試驗，進一步驗證了方案的可行性。
  12. Axial pull - out test of core concrete of prestressed concrete pipe piles and analysis of stress at the pile end

    填芯混凝土軸拔試驗及樁端應力分析
  13. Pull - out test

    拔拉測試
  14. In our country, no pull - out test of pressure - type anchor has ever been made in rock till now. in chapter 4, consulting some pull - out tests of pressure - type anchor made by some civil researchers, contrast pull - out tests of pressure - type and tensile - type anchor in rock is designed in crag slope engineering in chongqing university

    本文第四章在在參考國內一些單位已經進行的部分壓力型錨桿抗拔試驗的基礎上，針對基於巖層的該類型試驗還是空白的現狀，結合重慶大學沿江危巖邊坡治理工程設計了巖層中的壓力型錨桿與傳統拉力型錨桿抗拔力對比實驗。
  15. Bearing capacity and displacement are two main problems in the application of geotechnical engineering. based on a series of pull - out tests using three kinds of paper and a sort of window screening as geogrid, twenty - seven in limit and several in working - stress geogrid - reinforced slope model tests designed through orthogonal principle have been conducted to have obtained the relationship between the bearing capacity and four factors ( i. e. reinforcement, angle of reinforced slope, the designed - length of reinforcement and the distance between layers of reinforcement ). the law of slope lateral ( horizontal ) displacement versus to the height of slope vary with external - load was derived from the model test data, and the main factor affecting the lateral and vertical displacement of geogrid - reinforced slope was obtained through analysis

    承載力（強度）和變形是巖土工程應用領域的兩大主要問題，本文以紙和窗紗布模擬加筋土邊坡的土工格柵，在一系列拉拔試驗的基礎上，以正交設計理論分別安排27個極限應力狀態和若干個工作應力狀態加筋土邊坡模型試驗，並以模型試驗獲得的數據為依據，採用誤差、極差及回歸分析方法，探討了加筋土邊坡承載力與筋類、筋長、層間距、坡角4因素的相關關系，獲得了在外荷載作用下加筋土邊坡的側向位移隨坡高的變化規律（並進行了定性解釋）和坡頂的豎向位移特性，並分析其主要控制因素。
  16. Pull - out test of flexible macro - fiber is conducted firstly, this paper is emphasized effects of fiber embedded length, cured times and matrix strength on bonding strength between synthetic macro - fiber and mortar

    本論文首次完成了柔性粗纖維的拉拔試驗，重點研究了纖維埋置長度、養護齡期、基體強度對粗合成纖維-砂漿基體界面粘結強度的影響。
  17. By the test of anchor cable pull - out intensity, research is carried on anchor capability, stiffness coefficient and prestress losses of anchor cable in reinforcing similar soil slopes. the mechanisms of reinforcing similar soil slopes by prestressed anchor cable sash ( beam ) are studied by the method of combination of field test, theory analysis and numerical simulation, as a result, the calculational pattern of internal force of anchor cable sash ( beam ) is put forward

    本文通過大量野外調查，提出類土質邊坡的概念，並分析了它不同於一般粘性土邊坡的特性；通過錨索抗拔試驗研究了類土質邊坡的錨固力大小、錨索剛度系數和錨索預應力損失情況；通過現場試驗、理論分析和數值計算相結合的方法，研究預應力錨索框架（地梁）加固類土質邊坡的機理，提出預應力錨索框架（地梁）的內力計算模式。
  18. Soil reinforcement - backfilled structures reinforced with extensible and flexible reinforcing strips - part 1 : pull out test of reinforcing strip by loading step

    土壤加固.用可伸展的軟增強帶材加固回填結構.第1部分:用荷載梯進行增強帶材的固著力試驗
  19. Roofing - determination of the characteristic resistance of the assembly - test method to determine the pull - out load of fixings out of insulating material or sealing coating from the frame

    屋頂.耐安裝特性的測定.框架絕緣材料或封裝塗層外的部件拉出力測定的試驗方法
  20. Stress singularity analysis and fracture toughness on interface end of steel epoxy pull - out test

    環氧拔出試件界面端奇異應力場強度表徵及其試驗測試
分享友人
分享到 Line

分享到臉書