pulses modulation 中文意思是什麼

pulses modulation 解釋
脈波調調制
  • modulation : n 調整，調節；（聲調的）抑揚，變化；【音樂】轉調，變調；【無線電】調制。 amplitude modulation 振...
  1. There has been a revolutionary advance in ultrashort pulse technology since the discovery of self - mode locking of ti : sapphire lasers. few - femtosecond pulses have already been generated from ti : sapphire lasers, by means of combining self - phase modulation with negative group velocity dispersion, which is similar to the way of soliton generation

    鈦寶石激光自鎖模的發現使得超短脈沖技術發生了革命性的變化，利用自相位調制和負群速度色散結合的類孤子產生方式，人們已經在鈦寶石鎖模激光器上得到了脈寬只有幾個飛秒的光脈沖。
  2. Secondly the detection precision is only related to the synchronization phase but not to the amplitude of the mainline voltage because that it uses the optimized pulses synchronous with the mainline voltage as modulation signals. thirdly it decreases the requirement of the input low pass filter and eliminates the error resulting from the direct component and even harmonics of load current. the most significant merit is that it can eliminate the effect of a few low order odd harmonics and the detecting circuit is easy to be implemented

    模擬和實驗結果表明該方法的主要優點有：不需使用乘法器進行信號調制，調制信號採用與電網電壓同步的優化特定脈沖，其檢測精度只與同步相位有關，而與電網電壓幅值無關；降低了對輸入低通濾波器的通頻帶要求，直流和偶次諧波分量對檢測精度沒有影響；突出的優點是可以消除有限個低奇次諧波對檢測結果的影響。
  3. The system can generate three - phase spwm pulses and has following characters : the range of modulation frequency is from 0 khz to 4 khz. and can be divided to 7 classes to control. the carrier frequency may be selected up to 24 khz, and can be divided to 8 classes to control ; rotational frequency is defined to 16 bits

    該系統能產生三相六路正弦脈寬調制（ spwm ）波形;調制頻率范圍為0 4khz ，分7級控制; 16位的速度控制解析度;載波頻率分8級控制，最高可達24khz ;系統介面兼容intel系列和motorola系列單片機;該系統控制簡單、精確，易修改，可現場編程;同時具有脈沖延時小、最小脈沖刪除、過壓和過流保護功能等特點，可應用於pwm變頻調速系統的全數字化控制。
  4. The results show that wavelength locates in gain zone of semiconductor optical amplifier, and have higher peak power and proper time delay between the two pulses for the second order super gauss control pulse in semiconductor optical amplifier. a high quality amplified signal pulse can be achieved. the chirp can be reduced notability by using cascading soa in cross gain modulation based on soa, and the distance and the peak power of conversion optical pulse can be increased notability, and we can let down the demand for wavelength based on xgm in soa and enhance the flexibility of wavelength conversion

    我們應用二階超高斯光脈沖與高斯信號脈沖同時注入soa和應用soa與非線性光學環鏡（ nolm ）相結合的方案來對信號脈沖進行壓縮整形，模擬顯示，在調節系統合適參數的情況下，波長位於soa增益區的二階超高斯控制光脈沖在具有較高的峰值功率和適當時延下輸入soa時，最後可以得到放大的高質量超簡訊號光脈沖；在基於soa的交叉增益調制（ xgm ）全光波長轉換中，採用級聯的soa能有效地使反轉光脈沖的頻率啁啾得到有效降低，波長向下轉換的距離和反轉光的峰值能量都得到明顯提高，降低了利用交叉增益調制（ xgm ）波長轉換中對波長精度的要求，從而提高了波長轉換的靈和性。
  5. Simulations on light intensity are validated by experiments and influence of mechanical dither on gyro frequency stabilization is studied for the first time. then it is point out that the key to improve the precision of frequency stabilization is to choose appropriate modulation frequency based on the frequency spectrum of sharp pulses, which is introduced by mechanical dither. thereafter, experiments of frequency stabilization under different modulation frequencies are made

    通過實驗驗證了光強模擬結果，首次分析了機械抖動對穩頻的影響，指出提高機抖陀螺小抖動穩頻精度的關鍵在於：根據機械抖動引入的交流光強尖峰脈沖頻譜分佈選擇合適的調制頻率，並給出了不同調制頻率的穩頻實驗結果。
  6. Secondly, considering the need of frequency stabilization, mdrlg ' s light intensity is simulated. the simulations indicate that sharp pulses are produced in the ac light intensity by mechanical dither. as the pulses have a wide frequency spectrum and range over the modulation frequencies of frequency stabilization, mechanical dither may reduce the precision of frequency stabilization

    其次，根據穩頻需要對機抖陀螺輸出光強進行了模擬，模擬表明機械抖動會在交流光強中引入尖峰脈沖，且尖峰脈沖頻譜分佈較寬，在小抖動穩頻調制頻率范圍內有功率輸出，因而可能降低穩頻精度。
  7. As the dispersive influence can be easily described by a frequency transfer function, the feasibility of measuring the function with the g - s algorithm is researched numerically in the next part. from the results of simulation with fibers with different length and pulses with different width, it ’ s known that the convergence of the algorithm is related to the difference between the input and output pulse. then, the influence of attenuation and self phase modulation of fiber is discussed, and the influence of the delay phenomenon and fitted polynomial is also analyzed

    通過對不同光纖長度和不同輸入脈沖脈寬的計算，得到了g - s演算法的收斂性與輸入波形和輸出波形之間的關系;在此基礎上，通過對光纖損耗、自相位調制的模擬，分析了損耗和自相位調制對光纖傳遞函數測量的影響;本文還分析了波形測量中的拖尾現象和多項式擬合對測量的影響，進而，對利用g - s演算法進行單模光纖傳遞函數測量的可行性進行了闡述。
  8. Firstly, the current testing localization in the detection of electric bow is analyzed and the new system ' s whole construction developed in this thesis is introduced ; in the 2rd chapter, the embedded 110v dc power supply is analyzed and constructed, and with experiments, some dissonant results such as the fluctuation of output pwm ( pulse width modulation ) pulses, the power noise added to output voltage, and the drop of output voltage have been analyzed and the problems have been broken down one by one ; in chapter 3, stepping motor ' s drive has been systematically dissertated, and combing stepping motor ' s subdivided drive technology, the author develops an intelligent mini - step driving circuit using a main - sub microprocessor structure, which is validated in the hybrid stepper based system ; in the 4th chapter, liquid crystal driving and displaying technology is specified in detail, with one sort of lcd modules ( tlm12864h ), the author develops an feasible circuit for the new testing system, designs a menu mode based program struc ture and brings here some programming codes using franklin c51 programming language ; in chapter 5, the above built system is used in the electric bow ' s practical detection, and the differentiating rate of this system is analyzed

    論文首先分析了目前機車受電弓檢修方式存在的局限並概述了本論文研製的受電弓測試系統的體系架構；第二章對系統內置110v直流控制電源進行了分析和設計，結合試驗對輸出pwm振蕩、輸出電源噪聲大、輸出電壓下跌等現象進行了分析並提出解決措施；第三章論述了步進電機的驅動，結合步進電機微步驅動技術研製了基於上下位單片機組的混合式步進電機智能驅動電路，並在試驗中得以驗證；第四章詳述了液晶驅動及顯示技術，利用一款液晶顯示模塊tlm12864h研製出本系統用液晶顯示電路，設計了菜單式的程序結構並以franklinc51編程方式給出部分子程序代碼；第五章則將以上構建的整個系統應用在機車受電弓的實測中，並對測試解析度進行了分析。
  9. The above waveforms discussed are to synthesize the wb or uwb with narrow band pulses. assuming the transmitting uwb linear frequency modulation ( chirp ), dechirp processing is introduced, and the method involved to obtain high resolution by reducing the if bandwidth is presented. furthermore, dechirp processing used to sar imaging is discussed, and the processing steps are described

    < wp = 4 >以上研究的兩種信號形式都是通過窄帶子脈沖串相參合成的方法來獲得超寬帶回波信號，本文還探討了去斜率（ dechirp或stretch ）方法，分析了去斜率降低接收機中頻帶寬、 fft獲得目標一維距離像的原理，並探討了線性調頻去斜率合成孔徑雷達成像，給出了具體實現步驟。
分享友人
分享到 Line

分享到臉書