pump discharge 中文意思是什麼
pump discharge
解釋
泵抽送量-
Equally effective in checking back flows from head pressure on the discharge or suction sides of pump
無論是泵的排泄口的排出壓力，還是泵的吸入口，其流體止回的效果都是相同的。 -
In your reviewing the technical value of the quadruplex pump please consider that this unit is equipped with four pulsation dampeners on the discharge side allowing the pump to achieve a uniformity at least comparable with that of a triplex pump
當考慮四泵頭的泵的技術價值時，請注意到這一裝置在出口側裝有四個脈沖緩沖器，這就可以使泵達到平穩的操作，至少是可以同三泵頭的泵相比。 -
Automatic control system for submersible fire discharge pump
系統的開發與研究 -
The sludge is passed under a vacuum pump and allows the water to pass through a discharge or recirculation drain.
用真空泵除去污泥的固體含量而該泥水則經排水渠或迴流渠排出。 -
Aim at to turn a dense oil pump in the movement the metal bellow expansion joint and buffer tank was installed in the dense oil pump export because of the violent vibration and noise cause by the discharge and the pressure pulsation, the result show lowered the vibration and noise availably was obvious
摘要針對轉子式稠油泵在運行中因流量和壓力脈動所引起的劇烈震動和噪聲，在稠油泵出口安裝金屬伸縮節和緩沖罐，有效地降低了震動和噪聲。 -
Ustable discharge gear pump
可調卸料齒輪泵 -
Then pid flow rate control algorithm is introduced. all experiments made in this chapter are about measuring the valve parameters according to spool positions, single actuator flow rate control by the calculated flow rate feedback control method, free flow rate dividing control under the sufficient pump discharge flow rate situation, proportion flow rate dividing and flow rate dividing based on meter - in flow rate feedback control method under insufficient pump discharge flow rate situation. the results of all experiments proved that the method presented in this thesis is an effective way to overcome the unreasonable flow rate dividing when simultaneously operating multi - actuators with different inertia loads
第四章介紹了多執行器復合控制實驗系統和實驗方法；介紹了實驗採用的流量控制的pid演算法；並測定了執行器控制閥和閥芯位移相關的系數；做了單個執行器計算流量反饋流量控制、流量足夠情況下多執行器流量任意分配、流量不足情況下多執行器按比例調節流量分配和多執行器進油側流量反饋分流控制實驗；通過實驗說明了論文提出的分流控制方法能實現大小慣性負載復合操作時的合理分流。 -
Note : on pump discharge, the preferred check valves are an in - line spring loaded, swing design with lever and weight or lever and spring
注意：在泵的排泄口處，首選的止回閥是管內彈簧負載，旋啟式，配置杠桿和重量或杠桿和彈簧。 -
Install 5 pipe diameters minimum downstream from pump discharge or elbows to avoid flow turbulence. flow straighteners may be required in extreme cases
安裝在距離泵排泄口或彎管下游至少5倍管道直徑的地方，以避免產生水流擾動。在極端情況下，可能需要流向矯直裝置。 -
Mainly, the type of pump in the large - scale irrigation and drainage pumping station in our country is adjustable - blade propeller pump. we can regulate the pump ' s blade mounting angle following the variation of water level at the inlet and outlet of the station in order to control the discharge of pump, we also determine the number of running machines with machine ' s optimal combination. so we can reduce its energy consumption, and make it optimally and economically run
我國大部分大型電力排灌站所安裝的泵都為可調節葉片的軸流泵，這一有利條件使我們可以根據排灌站進、出口水位的變化來調節水泵的葉片角度，控制水泵的流量，併合理的確定開機臺數，通過機組間的優化組合，使整個泵站的能耗最少，達到整體最優、經濟運行的目的。 -
In case of disuse for a long time, it is necessary to discharge the feed in the pump chamber completely and wash it with water or steam
當泵處于長期停止工作時，應將泵腔內料液放凈，並用水或蒸汽沖洗。 -
The analysis starts with the criterion of flood control and the capacity of flood discharge of the watercourse, where the water - intake pump house lies. through an analysis of a large amount of historical hydrological materials, a mathematic model is set up and the calculation is done
課題分析研究主要是從取水泵房所處河道的防洪標準和行洪能力兩大方面入手，通過對大量歷史水文資料的分析建立數學模型進行分析。 -
The optimal layout scheme and design scale of the plant site are determined through the analysis and evaluation of the capacity of flood control and flood discharge of the watercourse nearby the pump house of zhongning electric power plant. this will provide use for reference for the similar water - intake engineering in the future. it has great significance for theoretical research and practicable value for application as well
本課題通過對中寧發電廠取水泵房廠址附近河道的防洪及河道行洪能力的分析和評價來確定其廠址的最優布設方案和設計規模，對今後類似的黃河上取水泵房的設計提供借鑒，因此具有重要理論研究意義和實際應用價值。 -
The differential equation of pump station start - up transient is established and derived from discharge balance and moment equation of pump unit
摘要本文從水量平衡及水泵機組力矩方程出發，建立起水泵從起動到同步的微分方程式。 -
The most common method to "pump" a gas laser--that is, to invert the population in the states that give rise to light amplification--is to use a gas discharge.
「發射」氣體激光（也就是反轉能產生光放大的那些狀態的粒子數）的最普通方法是運用氣體放電。 -
Measurement methods of pump discharge
泵抽排量的測量方法 -
" install chemical tanks as required, and ensure each dose pump discharge tubing is connected to the manifold injection points provided.
按要求安裝化學箱槽時，確保每根加藥泵的排放管線與相對應的注入點相連接。 -
Ctc maximum head is suitable for pump discharge to butanol handling facility
用戶確認泵出口去丁醇處理裝置的最大揚程是合適的 -
Chapter 3 gives an introduction to the flow rate dividing principle based on meter - in flow rate feedback control of multi - actuators control system. special analysis about simultaneously operating multi - actuators with different inertia loads is made. finally the results of simulation proved that the new method is an effective way to improve the flow - used ratio when the pump discharge flow rate is insufficient
第三章介紹了基於執行器進油側流量反饋的分流控制的原理，並針對大小慣性執行器同時起動時採用該分流控制方法進行了具體分析；最後通過模擬說明該分流控制方法能在大小慣性執行器同時起動並在泵輸出流量不足的情況下有效提高泵輸出流量的利用率，並能實現優先級和分流比混合控制。 -
Introduces the structure of the multi - actuators control system based on pressure decrease sensing. then a multi - actuators control system model is developed for the constant pump discharge pressure hydraulic system. also the factors that affect the static accuracy of actuators " speed and flow rate and the dynamic characteristic are analyzed in this chapter
第二章簡單敘述了基於壓差傳感的計算流量反饋流量控制原理及其實現；介紹了基於壓差傳感的多執行器復合控制系統的構成；之後主要針對定壓系統多執行器復合控制建立了數學模型，並分析了影響執行器速度及流量穩態控制精度和動態特性的一些因素。
分享友人