reactance voltage 中文意思是什麼
reactance voltage
解釋
電抗電壓降-
Leakage reactance voltage
漏電抗電壓 -
Company main products : voltage stabilizer, high low pressure transformer, reactance implement
公司主要產品：穩壓器、高低壓變壓器、電抗器。 -
The problem about neutral - point - grounding mode is an all - around technical problem which associated with not only power system reliability ， insulation coordination ， electromagnetic interference ， but assault safety 。 in china ， the neutral grounding modes of the 10kv net involved of none grounding, grounding by arc suppressing coils, resistance grounding or reactance grounding in the past 。 with the development of civic power network ， low resistance grounding mode was used to restrain the over voltage, particularly in guangzhou, shanghai ， beijing ， and zhuhai etc. it was reported that the over - voltage level of low resistance grounding mode is lower than that of arc suppressing coil mode, but the operation carried out the other way 。 at substations in guangzhou and shanghai it was found that the low resistance grounding mode is successful 。 but in some areas ， such as zhuhai ， substations grounding with low resistance revealed some problems ， including power supply reliability rapidly dropping ， transmitting line often tripping ； and person safety being threatened 。 so interiorly the grounding mode selection of the 10kv network was disputed, which mainly focused on the fault form of 10kv net grounding, the apply area of suppressing arcing coil grounding mode, power supply reliability level of the two modes, person safety, communication interfere and the workload of maintenance
爭議點主要是在10kv電網接地故障的形式、消弧線圈接地的應用范圍、兩種運行方式供電可靠性的高低、人身安全、通訊干擾和運行維護工作量等諸多方面。 11 17本論文就是針對以電纜為主的城區10kv電網中性點接地方式的選擇問題進行研究。論文首先對10kv電網的中性點運行各種方式進行分析，比較各方式的特點，然後以重慶儲奇門變電站10kv電網的實際參數來建立數值計算模型，在考慮了電網接地電容電流變化、中性點電阻取值大小、接地點接地電阻值變化等多種影響因素的情況下，對中性點經消弧線圈接地和經小電阻接地方式下電網的過電壓水平和接地點短路電流大小進行了數值計算，其計算結果與電科院所作現場試驗進行了比較。 -
It not only solves the problem of optimized control of the reactive current exchanging among branches, in other words, realizes the auto - tracking to the reactance factor, but also greatly improved the reliability of the system. to design the high voltage line wireless signal acquisition device with self - feed source, we applied electromagnet induction principle and digital communication technique
系統在優化控制技術中採用了電容器補償控制的兩段控制模型，不僅解決了分支線路之問穿越無功電流的最優控制問題，實現了功率因數的自動跟蹤，而且使整個系統的可靠性大大提高。 -
3. we do short circuit analysis upon multiple magnetic circuit transformers by use of steady non - linear analysis and get the leakage reactance respectively between high voltage and high voltage 、 high voltage and low voltage 、 two high voltage and low voltage 、 low voltage and high voltage and low voltage and two high voltage. what ’ s more, we do finite element analysis upon the temperature field of transformers and according to its distribution we get the wind speed to forced air cooling
3 、採用穩態非線性分析法對多磁路變壓器進行短路阻抗計算，利用能量法計算出變壓器高壓與高壓、高壓與低壓、兩高壓與低壓、低壓與高壓以及低壓與兩高壓之間的漏感;對變壓器的溫度場進行有限元分析，確定溫度場分佈情況。 -
Traditionally, the resolving - transformer consists of former windings and vice windings. but the resulting output voltage will have aberrance owing to the existence of winding resistors and reactance leakage
傳統上的旋轉變壓器常採用原副線圈來組成，由於線圈電阻和漏抗的存在，將使最終輸出電勢出現畸變。 -
The low voltage impulse method, frequency response analysis method and short - circuit reactance method, which can be used to measure and diagnose the deformation of power transformer winding, are introduced in the paper
目前，監測變壓器繞組變形的方法主要有低壓脈沖分析法（ lvi ） ，頻率響應分析法（ fra ）和阻抗分析法。這些方法都需使變壓器退出運行，在變壓器離線情況下對變壓器繞組變形進行測量的。 -
Consumers successively plunged a large number of silicon controlled commuted devices ( such as steel rolling 、 electrized locomotive 、 aluminium electrolysed devices etc ) and smelting devices to improve their produced efficiency or to save energy. on the one hand it is good for consumers, on the other hand it will arouse the fluctuation of voltage and frequency and it will result in the collision of the active and reactance capacity. meanwhile these nonlinear loads bring much harmonic into the electric network which deteriorate the quality of power supply and hazard the online device enormously
用電部門為了提高生產效益、節約能源，在大電網中相繼出現了大量的可控硅整流裝置（如軋鋼、電氣化機車、鋁加工電解設備等）以及冶煉設備，這些設備的投入使用對節能有一定好處，但給電網造成有、無功沖擊，引起電壓和頻率的波動，同時，這些非線性負荷向電網注入大量諧波，大大惡化了供電系統的電能質量，給用電設備帶來了極大的危害。 -
The equipments and methods were on the level of manual operation, hi this paper, author paid a systemic research into three kinds of measure means : direct current attenuation method, voltage integral method, and direct load method ; theoretically analyzed the measure methods of synchronous armature reaction reactance, and even developed a test system to automatically measure the synchronous armature reaction reactance
作者對直流衰減法、電壓積分法和直接負載法這三種測試方法的測試原理進行了較為深入、系統的研究，從理論上分析了同步電樞反應電抗參數的測試方法，並在此基礎上開發出能夠自動進行同步電樞反應電抗參數測試的系統。
分享友人