reduction ratio 中文意思是什麼

reduction ratio 解釋
沖淡比
  • reduction : n 1 縮小，減少；降級，降位；（刑罰等的）輕減；減速；減價，折扣。2 （城市、國家等的）陷落，投降，...
  • ratio : n. （pl. ratios）1. 比，比率，比值；比例；系數。2. 【經濟學】復本位制中金銀的法定比價。vt. 1. 用比例方式表達；求出…的比值；使…成比例。2. 將（相片）按比例放大或縮小。
  1. Initial growths of disturbances are measured by means of hot - wire anemometry. due to the detected signals with low signal to noise ratio, the coherence function is used to eliminate background noise during data reduction

    在擾動增長的初始階段，信號的信噪比非常地低，根據相關譜分析方法，應用相干函數，將擾動信號有效地提取出來，測量了初始擾動的增長。
  2. With the development of human society, because of the lack of sustainable utilization consciousness, and the eager for quick success and instant benefit, the black earth suffered excessive cultivation and management, causing the reduction of its recycled ability, decrease in organic content, porosity ratio, fertility dropped and the properties of water retaining and water retention, which make the black soil harden and degenerate seriously

    但是隨著人類社會的發展，在缺乏保護和可持續利用意識、急功近利思想影響下，黑土遭到過度墾殖和掠奪式經營，人類對其活動范圍遠遠超過了其再生能力，導致有機質含量減少，肥力下降，孔隙比減小，保水持水能力降低，土壤板結，黑土嚴重退化。
  3. 4. when the chloramines disinfection water is combined with the liquid chlorine disinfection water and reaches some stable ratio for a long time, the great reduction of the remained and total chlorines in the piped system will be obtained

    4 、氯胺消毒處理后的水與液氯消毒后的水在管網中混合達到一定比例，長時間穩定接觸，將會出現管網水余氯、總氯大幅度降低的現象。
  4. In adding - acid system : the resistivities of different lithotypes " cp tend towards being constant and equal when weight percentage of aniline exceeds 50 % ; because of the structure difference of different lithotypes, the polymerizing places and processes are different ; the resistivities of vituain / pan and fusain / pan reach the lowest point respectively when ( ntloisiog / an is 0. 6, 1. 0 ; the resistivities of cp decline fast and tend towards being constant along with the reduction of diameter of coal. in not adding - acid system : the resistivities of different lithotypes ' cp decline evenly ; it is found on the crossed experiment of cp, that ( nflsaog / an mole proportion is the most important factor to influence output ratio of cp and the weight percentage of aniline is the most important factor to influence resistivities of cp. according to the result of the crossed experiment of cp

    在有外加酸體系中：苯胺百分含量大於50時，不同煤巖組分的電阻率趨于恆定和一致；由於不同煤巖組分結構上的差異，導致苯胺聚合場所和聚合過程的不同；當過硫酸銨/苯胺摩爾比為0 . 6 ， 1 . 0時，鏡煤-聚苯胺導電材料電阻率和絲炭-聚苯胺導電材料的電阻率分別達到最低值；在無外加酸體系中：不同煤巖組分/聚苯胺導電材料的電阻率隨著聚合時間的增加而均勻下降，並在8小時左右達到恆定；在對絲炭-聚苯胺導電材料進行的正交試驗中發現：過硫酸銨/苯胺摩爾比對產率的影響最大，苯胺重量百分比對產率影響最小，而對產物電阻率影響最大的是苯胺重量百分比。
  5. Abstract : this paper, by analyzing the effect of differences of mineral structure of 2 1 layer minerals, the properties of their interlayer charge and changes of some properties caused by weathering on the attractive force for interlayer cation, reached the conclusion that : the fixation capacity is determined by the ratio of the total amount of interlayer charge and that of tetrahedral charges. the relationship of interlayer cation fixation and octahedral structure of secondary minerals is probably different from that of primary minerals. the oxidation and reduction of variable valence cations can greatly influence the cation fixation capacity

    文摘:分析2 1型礦物的結構差異、層間電荷性質以及在風化過程中某些性質的變化對層間陽離子吸引力的影響，對已有報道中一些矛盾的結果或不具普遍意義的結論進行了討論.得出幾個較為明確的結論：層間總電荷與四面體電荷所佔比例大小共同決定礦物對層間陽離子的固定能力；原生礦物中八面體結構與層間陽離子固定間的關系對次生礦物而言，也許並不一致；八面體中可變價陽離子的氧化還原，可導致礦物固定陽離子能力發生較大變化
  6. Based on extensive investigation of construction technique history of chinese ancient buildings, the structure method, structure developing history and seismic behavior of chinese ancient timber structure buildings are analyzed in several respects of the structural system and form. through a series of experiments on constituent parts of chinese ancient timber building structure, including the tests on the corbels and brackets called dougong subjected to low cyclic reversed loadings, the tests on the wooden frame using the tenon - mortise joints as connections of column and beam subjected to low cyclic reversed loadings, the tests on vibration isolation effect of friction and slippage between column footing and their socle base, and a series of shaking table tests on a chinese ancient timber structure palace building mode under artificial earthquake at serving conditions, destroyed conditions and reinforced conditions, many valuable results of structures such as moment - curvature hysteretic loops of dougong structure and tenon - mortise joints under low cyckc reversed loadings, the static function, the seismic performance, energy dissipation, vibration reduction, energy - loss mechanism, nechanicalmode and failure mode were studied. aplenty of valuable parameters of the structure system were obtained, such as the natural period of structure, vibration modes, damping ratio, factor of vibration isolation, oscillate amplitude of ineitial accebration, velocity and displacement, magnitude of slippage, and the mechanism of structure failure and collapse etc. based on these research, the complete analysis of ancient timber structure under earthquake were carried out in which including mechanism analysis method, calculating mode, strength analysis of members and joints, strengthening methods for serving damaged ancient timber structure buildings were also taken into account

    依照宋代《營造法式》建造了抬梁式殿堂木結構構件及結構模型，對中國古代木結構中的典型構造如：柱腳在礎石頂面平擱簡支、柱架榫卯連接、柱高不越間之廣、側腳、生起、斗拱等的構造機理及結構功能進行了量化分析和實驗研究： （一）通過木柱石礎靜摩擦試驗，測定了柱腳與石礎古鏡面間的摩擦系數及摩擦力隨上部結構荷載變化的規律； （二）通過單柱承載力試驗，測定了古建築中木柱的受力變形特徵、破壞模式、及模型材料的變形模量、極限承載力、極限變形等參量； （三）通過柱架低周反復荷載試驗，測定了柱架的抗側移剛度、柱架恢復力特性及滯回曲線、榫卯張角剛度及其變化規律、柱架及榫卯的極限承載力和極限變形、及榫卯減振參數； （四）通過斗?低周反復荷載試驗和受壓試驗，測定了古建築木構件與木構件間摩擦系數，斗?抗側移剛度，斗?恢復力特性及滯回曲線，斗?抗壓極限承載力及受力變形規律； （五）通過抬梁式殿堂間架模型振動臺試驗，測定了殿堂木構架結構自振周期，地震反應振形、阻尼特性及阻尼比；按結構分層特點對柱腳、柱頭和斗?層上的屋蓋的地震反應採用多點同步測量，對柱根滑移、榫卯變形、斗?的變形、復位、耗能減振參數等進行了定量分析。
  7. Under the analysis of a great deal of civil aviation accident, this command assistant system is brought forward which aimed to lowed the ratio of approach and landing accident reduction

    通過對大量民航飛行事故的分析，提出了一種旨在降低進近著陸過程事故率的輔助指揮系統。
  8. Effect of cold rolled reduction ratio on deep - drawing properties of low carbon al - killed and cold rolled steel sheet

    冷軋壓下率對低碳鋁鎮靜鋼冷軋板深沖性能的影響
  9. Features of dr1600 include automatic selection of both the correct reduction ratio and the proper focus

    Dr1600一大特點是能夠自動選擇正確的縮圖比例及準確的焦距。
  10. Result of numerical simulation shows that the grads of continuous phase " s velocities decreases with the presence of microbubble of which the diameter is 100 / / w, the profiles of air volume fraction in the boundary layers is similar to triangle or echelon, affected by interaction among the particle, there is a saturated air fraction, within the scope of saturated air fraction, increasing the air injection ratio can accrete the friction reduction ratio, under the condition of same air injection ratio, the free - steam velocity is larger, the effect of friction reduction is worse

    計算結果表明，直徑為100 m的微氣泡能減小近壁面連續相的速度梯度；微氣泡在邊界層中的濃度分佈近似為三角形或梯形分佈；受粒子間相互作用的影響，存在一飽和濃度；減阻率隨噴氣量的增大而增大，直至飽和噴氣量，此後，增大噴氣量，壁面摩擦阻力變化不大；相同噴氣量下，來流速度越大，減阻率越低。
  11. Effects of gaseous pollutants reduction ratio on energy eco - efficiency of coal - fired plant in china

    污染物的脫除率對燃煤電站生態效率的影響
  12. Gear reduction ratio

    齒輪減速比
  13. 2. the room temperature tensile strength of alloy made by mlsd relate to the extrusion temperature and the extrusion reduction ratio, with high temperature and reduction ratio, the tensile strength becomes low

    二、多層噴射沉積過共晶a1 - si合金的室溫強度與擠壓溫度和擠壓比有關，擠壓溫度越高，合金的強度會降低。
  14. Its reliability has been tested though examining. the influence laws of mould structure, including wiper die and the style, size and installed position of mandrel, have been studied. combined with the theoretical analysis of perfect pure bending, the tendency of relative bending radius r / d and relative wall thickness t / d to one of the major quality target - the maximum wall thickness reduction ratio is also studied

    通過數值模擬研究獲得了包括防皺塊和芯棒形式、尺寸和安裝位置在內的模具結構對製件成形質量的影響規律；結合對理想純彎曲的理論分析，研究獲得了相對彎曲半徑r / d 、相對壁厚t / d對製件主要質量指標之一的最大壁厚減薄率的影響趨勢和大小。
  15. Gross reduction ratio

    總破碎比
  16. Then paper introduces a method by which the engine size and the speed reduction ratio from the engine to drive wheels based on the cruising mode ( one of the two basic modes for an electrically peaking hybrid vehicle ' s operation )

    而後重點針對電力峰值型並聯混合動力電動汽車動力的兩種操作模式介紹了一種基於恆定高速行駛模式的，用來確定發動機大小以及發動機與驅動輪之間傳動比的方法。
  17. High reduction ratio during primary and secondary crushing stage

    初段，二段等各段破碎均有大破碎比。
  18. Unbalance reduction ratio

    不平衡量減少率
  19. The optimal extrusion parameters are as following : extrusion temperature is 375 - 400 ?, the reduction ratio is 25 : 1

    該合金的最佳擠壓工藝參數為，擠壓溫度為375 - 400 ，擠壓比為25 : 1 。
  20. Total reduction ratio

    總減速比
分享友人
分享到 Line

分享到臉書