reference output power 中文意思是什麼

reference output power 解釋
參考輸出功率
  • reference : n 1 （對委員、審查人等的）委託；委託項目[范圍]。2 說到，論到，提到。3 參考；參考書；附註，引證；...
  • output : n. 1. 產量；生產，出產，產品。2. 【醫學】（糞便以外的）排泄物；排泄量。3. 【電學】發電力，輸出功率；供給量。4. 輸出信號。
  • power : n 1 力，力量；能力；體力，精力；（生理）機能；〈常 pl 〉才能。2 勢力，權力，權限；威力；政權；權...
  1. It is used to provide reference to operator of power plant. in recurrent composed bp networks, the relation of interior node is enhanced because the link weight of input layer and output layer are added, and the saturation of fault prediction is avoided by using the linear prompting function

    本文所建的用於鍋爐故障預測的遞推合成bp網路由於bp網路各層之間及輸入層與輸出層之間的連接權的增加和線性激勵函數的採用，極大地加強了內部節點的關聯能力，避免了bp網路預測的飽和性的出現。
  2. The topologies family include single four - quadrant power switch mode, push - pull mode, half - bridge mode, and full - bridge mode circuits. taking full - bridge mode circuit as an example, the operational mode, steady principles, transient voltage feedback control strategy of the converter are investigated. the output characteristic curve, the design for the key circuit parameters and the reference sinusoidal circuit which is synchronous with the signal of n or 1 / n times line voltage frequency are given

    該電路拓撲族包括單四象限功率開關式、推挽式、半橋式、全橋式電路，以全橋式電路為例分析研究了這類換器工作模式、穩態原理與電壓瞬時值反饋控制策略，給出了變換器的外特性曲線、關鍵電路參數、與電網電壓n倍頻或n分頻信號同步的基準正弦電路的設計。
  3. Constant output characteristic is performed by voltage feedback, and the dynamic characteristic control of power supply is realized by modifying the reference voltage in di / dt feedback loop

    利用電壓負反饋實現所要求的平外特性。對電源動特性的控制通過改變反饋電路中的給定焊接電壓實現。
  4. This dissertation present a new structure of rbwo and use the magic tool to simulate it and it is a good reference for further research on improving output power, efficiency and reducing the focusing magnetic

    本文的研究工作提出了一種hl - rbwo的結構並對其進行了粒子模擬；在思想方法上，在如何提高rbwo的輸出功率、輸出效率、降低聚焦磁場，對于研究進一步開發和利用高功率高效率低磁場微波源有一定的參考意義。
  5. The traditional bandgap reference circuit was improved in the design, which includes the applying of self - bias structure and cascode structure, output of the opamp was used as self - bias voltage, saving bias circuit, and then it was helpful to get low power consumption. through using poly resistance of high value with low temperature coefficient, we reduced the influnce to circuit, if power supply did not change, we must decrease operating current to decrease power consumption, and increasing value of resistor could decrease the operating current efficiently. poly resistance of high value had large value of squared resistor, so we could save layout area

    對傳統帶隙基準電路進行了改進設計，採用自偏置結構和鏡像電流鏡結構，利用運放的輸出電壓作為運放的偏置電壓，節省了偏置電路，降低了功耗;使用低溫度系數的多晶硅高值電阻，降低了電阻溫漂對電路的影響;在電源電壓不變的情況下，為了減小功耗就必須減小工作電流，而增大電阻的阻值能有效地減小工作電流，多晶硅高值電阻的方塊電阻很大，可以節省版圖面積。
  6. In the simulation experiment, the whole system model is founded by the software matlab / simulink. using the stator active power computed from the maximal output power of the wind turbine as the reference value of vector control system, the result of experiment approves that the control strategy is true. not only the frequency of stator current is constant, but the control of stator active and reactive are decoupled, and the output power tracks the maximal power of wind turbine

    在最後的模擬實驗中，本文利用matlab軟體建立了系統各部分的模擬模型，選用與風力機最大輸出功率對應的定子有功功率作為矢量控制的參考值做了模擬實驗，並給出了模擬結果，驗證了定子磁鏈定向矢量控制策略的正確性：既保證了定子輸出頻率的恆定，又達到了有功功率無功功率獨立解耦控制的目的，同時還較好地跟蹤了風力機的最大功率輸出。
  7. The hspice simulation result shows a temperature coefficient of 11 ppm / " c from - 40 ? to 100 ' c and output voltage variation of 1mv for supply voltage range from 8 v to 18 v. due to novel curvature compensation, the circuit structure of the proposed reference is simple and both chip area and power consumption are small

    Hspice模擬結果顯示：該基準源在- 40 100的溫度變化范圍內，具有11ppm的低溫度系數；當電源電壓在8 18v變化時，輸出電壓變化量僅為1mv ；並且電路結構簡單，具有較小的晶元面積和功耗。
  8. Reference output power

    參考輸出功率
分享友人
分享到 Line

分享到臉書