residual ratio 中文意思是什麼
residual ratio
解釋
殘值比率-
Test method for determination of the maximum flocculation ratio and peptizing power in residual and heavy fuel oils optical detection method
測定剩餘和重燃料油的最大絮凝率和膠溶能力的試驗方法 -
Standard test method for determination of the maximum flocculation ratio and peptizing power in residual and heavy fuel oils optical detection method
測定殘余燃料油和重燃料油中最大絮凝率和膠溶能力的標準試驗方法 -
In an attempt for an economic evaluation of the p - residual effect the following producer prices for food crops in indonesia have been converted into us dollar ( using an average exchange ratio between indonesia rupiah and us $ of 1, 925 : 1 ) : 1 kg rice = 225 r, 1 kg maize = 175 r, 1 kg soybean = 700 r, 1 kg mungbean = 1, 200 r
為了對磷的殘效作嘗試性的經濟評價，下列印尼糧食作物產品價格被折成美元（印尼盧比與美元比率為1925 ： 1 ） ： 1公斤水稻= 225盧比， 1公斤玉米= 175盧比， 1公斤大豆= 700盧比， 1公斤綠豆= 1200盧比。 -
During the process of measuring compression ratio, the viscous fluid instead of burning gas is applied to measure the maximal volume. residual volume and working volume of the engine combustion cylinder respectively
在壓縮比測量裝置中，採用粘性液體，代替發動機工作燃氣，分別測量出發動機燃燒工作室的最大容積、余隙容積和工作容積，方便地計算出發動機的壓縮比。 -
The used approximately dimensioning to approximate the mass extraction ratio guarantees stable cavities for the time of stoping and the storage of teh residual brine but consider not the behaviour of the safety layers and their mechanical integrity
所使用的近似尺寸接近質量萃取率，從而確保了回採和儲存殘余鹵水時空穴的穩定性，但安全層及其設備的完整性未考慮在內。 -
Eddy current decay method for measurement of resistivity and residual resistance ratio of pure metals
純金屬電阻率與剩餘電阻比渦流衰減測量方法 -
Superconductivity - residual resistance ratio measurement - residual resistance ratio of nb - ti composite superconductors
超導性.剩餘電阻比測量. nb - ti復合超導體的剩餘電阻比 -
Signal - to - residual output - power ratio
信號對剩餘輸出功率比剩餘輸出電平 -
To certain monitoring area and the remote sensing ratio wave bands defined, by means of the criterion of mean residual sum of squares to carry on filtering of remote sensing factors, finally the important remote sensing wave bands influencing canopy density estimation are confirmed, meanwhile the operable software system is programmed
針對特定監測區域，對設置的遙感比值波段，採用平均殘差平方和準則進行篩選，最終確定對郁閉度估測有一定影響的遙感波段，並形成可操作的軟體系統。 -
The clues and techniques to improve the resolution of data processing are 1 ) removing the affection of near surface factors on data acquisition, including static correction and noise eliminating technique etc, 2 ) broadening the frequency band of pre - stack seismic data, including amplitude compensation and pre - stack deconvolution etc, 3 ) improving s / n ratio of high frequency and weak reflection signals through multiple coverage with high precision velocity analysis, residual static correction and high - order nmo, raising " dead line of high frequency reflection ", and 4 ) identifying post stack effective reflection frequency band, enhancing dominant frequency and so on
主要包括：消除近地表因素對資料採集的影響，包括靜校正和噪音壓制技術等；疊前拓寬地震資料領帶，包括振幅補償和疊前反褶積技術等；藉助高精度速度分析、剩餘靜校正和高次項nmo技術，通過多次覆蓋疊加，消除資料中隨機噪聲干擾、提高資料信噪比，尤其是高頻端反射信息的信噪比，改善高頻反射和弱反射信號信噪比，提高「高頻反射死亡線」 ；疊後有限反射頗帶識別、抬高優勢頻率等。 -
Under the same consolidation ratio and the vibration times, effect of the dynamic stress on the dynamic residual strain shows linear relationship, and effect of the vibration times on the dynamic residual strain increasing
在同一固結比和同振次條件下，動應力對動殘余應變的影響約呈線性關系，且振次對動殘余應變的影響呈逐漸增大的變化關系。 -
Doing the further research on the division frequency stack on the foundation of study of predecessor, at first the residual moveout correction is done to the seismic record, make the phase axle regularity, doing foundation for the same phase stack ; then carried on division scale processing by wavelet transform ; spectrum whitening is done to each scale, the high and low frequency band need to do prolongs, the middle frequency bands only increase the value of the frequency spectrum ; several kinds of methods that estimate the value of signal - noise ratio has been studied further, and summarize their advantage and disadvantage as well as the scope of application ; the seismic record after spectrum whitening is stacked by weighting with the value of the signal - noise ratio ; then estimate the value of signal - noise ratio which is each scale section after stacking, the scale that the signal - noise ratio is big is assigned big weighting, otherwise, the scale that signal - noise ratio value is small is assigned small weight ing, and carried on weighted reconstruct to each scale section
本文在前人研究的基礎上，在分頻疊加方面做了進一步的研究。首先對地震記錄進行剩餘時差校正，校齊同相軸，為同相疊加做好基礎工作；然後對地震記錄用小波變換的方法進行分尺度處理；對各個尺度分別做譜白化，對于高、低頻段需要做頻帶延拓，中間頻段僅提升頻譜值；對于幾種信噪比定量估計的方法進行了深入的研究，並且總結了它們的優缺點以及適用范圍；對譜白化后的地震記錄用信噪比估計值作為加權系數進行加權疊加；對于各尺度的疊加剖面也進行信噪比估計，對于信噪比大的尺度給予大的加權系數，反之，信噪比值小的尺度給予小的加權系數，對各尺度疊加剖面進行加權重構。 -
In the paper, some key technique such as low - order modes correction for wave - front error, normalized phase power spectrum, atmospheric turbulent phase structure function, the residual phase structure function after low - order correction and strehl ratio are all analyzed
提出了利用自適應光學系統校正低階模式波前誤差的方法與理論依據，引入規格化的相位譜，推導了大氣湍流相位結構函數、低階模式校正後的殘余相位結構函數以及斯特列爾比。 -
In active code for design of steel structures, axially compressed members are calculated not as torsional - flexural buckling but as flexural buckling with equivalent slenderness ratio, residual stress and initial geometry imperfection are also taken into account as flexural buckling
我國現行鋼結構設計規范（ gb50017 ）採用換算長細比的方法將彎扭失穩等效為彎曲失穩，其殘余應力和初始幾何缺陷均按彎曲失穩考慮。 -
The solution formula of dwell time is deduced by using the pulse iteration method and the smoothing fourier transition method, and the formula can be simplified referring to workpiece shape. according to the anastomotic status of the tool and workpiece surface, we present the new model of the inherent relation among local pressure density, removal rate, convergence ratio and residual errors, and the corresponding formulas are given. the forming cause of the edge effect in the polishing process is analyzed, and the means which reduces the edge effect is put forward
2 、針對計算機控制光學表面成形（ ccos ）的加工方式、誤差收斂特點，研製了去除函數呈高斯分佈的雙轉子結構研拋模；採用脈沖迭代法、平滑因子傅立葉變換法推導出駐留時間的演算法，求解過程中根據工件面形的特點作了各種形式的簡化；提出了工件表面和研拋模的吻合誤差與局部壓強、材料去除率、收斂比之間內在關系的數學模型，並推導出相應的計算公式；分析了邊緣效應產生的原因，在加工過程中採用相對壓力因子對去除函數進行修正，可以消除邊緣效應的影響。 -
In view of characteristics of seismic data of gobi - sand dune areas, this paper, through various data - processing means such as quality control, high - pass filltering, dip angle filltering, field static correction, surface consistency deconvolution, precise velocity analysis, denoising before stack, multiple iterative operation of residual static correction, denoising after stack and modification after shift, has raised the data quality of seismic profiles in low signal - to - noise ratio areas and managed to form the seismic data - processing technique for such complex areas as gobi, foreland and dune
摘要針對戈壁、沙丘地區地震資料的特點，通過對原始資料進行質量控制、高通濾波、傾角濾波、野外靜校正、地表一致性反褶積、精細速度分析、疊前去噪、剩餘靜校正多次迭代、疊後去噪和偏後修飾等處理，提高了低信噪比地區地震剖面的資料質量，摸索出了一套戈壁、山前、沙丘等復雜地區地震資料處理技術。 -
What is taken account of includes the effects of the material, geometrical shape, manner of loading, ratio of cycle stress, residual stress and short crack in weld toe on fatigue strength
該模型考慮了材料、幾何形式、荷載形式、應力比、尺寸效應、殘余應力及焊趾根部短裂紋等因素對疲勞強度的影響。 -
Superconductivity - part 4 : residual resistance ratio measurement - residual resistance ratio of nb - ti composite superconductors
超導性.第4部分:剩餘電阻比測量. nb - ti復合超導體的剩餘電阻比 -
Superconductivity - part 4 : residual resistance ratio measurement ; residual resistance ratio of nb - ti composite superconductors
超導性.第4部分:剩餘電阻比測量. nb - ti復合超導體的剩餘電阻比 -
Superconductivity - part 4 : residual resistance ratio measurement ; residual resistance ratio of nb - ti composite superconductors iec 61788 - 4 : 2001 ; german version en 61788 - 4 : 2001
超導性.第4部分:剩餘電阻比測量:鈮-鈦復合超導體的剩
分享友人