resonance mode 中文意思是什麼

resonance mode 解釋
共振模式
  • resonance : n 1 回聲，反響；【物理學】共鳴，共振；【無線電】（波長的）調諧。2 【化學】中介（現象）。3 【醫學...
  • mode : n 1 法，樣，方法，方式。2 模，型；樣式，體裁，款式；習慣。3 風尚；〈the mode〉流行，時髦。4 【語...
  1. The combustor resonance properties are portrayed by instability zones, one zone for each acoustic mode.

    燃燒室的共振特性用不穩定區表示，每種聲振型都有一個這樣的區域。
  2. Accurate simulation of switch circuit is needed in pin switch design, while limited by assembling techniques, serial resonance and channel inter - coupling exist in the common joint that bring a lot of difficulties for simulation. 2 - dementions simulation software can not establish accurate circuit mode for pin diode switch which gives simulation error, and it costs much more time with 3 - dementation simulation software, which is not applicable in practice for pin switch design

    Pin開關的設計中需要對開關電路進行準確模擬，然而高頻、寬帶、多擲pin開關受裝配工藝的限制，開關公共結點附近存在著串聯諧振和相互耦合，給pin開關的準確模擬帶來了困難:二維模擬軟體很難對電路進行準確建模，模擬誤差較大;三維模擬軟體耗時過長，難以在實際設計中應用。
  3. Through the finite element analysis to the resonance main body, four troughs vibration was obtained which was the resonance main body ’ s working mode, simultaneously the design parameter ’ s affect on vibration characteristic was discovered

    通過對諧振主體進行有限元分析得出:四波腹振動模態為陀螺諧振主體的工作模態，同時找出了影響其振動特性的結構參數。
  4. The second - order resonance between superluminous r - x mode wave and magnetospheric electrons

    模電磁波與磁層電子的二階共振作用
  5. The modal parameters are the basic data for structure dynamic analysis and vibration control. the methods of modal parameters identification can be cataloged into phase resonance testing ( normal - mode force appropriation ) and phase separation approaches

    目前，識別模態參數的方法可分為相位共振法（適調多點激振法）和相位分離法兩種[ 1 ] 。
  6. The fourth, the power capacity and the special harmfulness of ghost mode resonance when a cylindrical box type window is used to transmit high power cw are studied in detail. the existing formula for calculating the average transmitting power capacity of cylindrical te11 mode box type window is revised and a formula for three dimensions simulation computation of the temperature increment of the dielectric disk in cylindrical te11 mode box type window is deduced

    第四，對圓柱盒型窗用於傳輸高功率連續波時的功率容限和鬼模振蕩的特殊危害性等問題進行了深入的研究，修正了現有的圓柱te _ （ 11 ）模盒型窗的平均傳輸功率容限的計算公式，並推導出了可用於三維模擬計算的圓柱te _ （ 11 ）模盒型窗中介質窗片溫升量的計算公式。
  7. Based on the results of previous researchers, the following instigations have been carried out in this paper : ( 1 ) employing a reasonable local resonance model which can accurately embody the heat - generation behavior due to resonance and vibration - heat mode in delaminated region, the dynamic response and temperature distribution in the small delamination region of a laminated beam are formulated. influence of the excitation frequency on the temperature gradient formation is analyzed numerically, and several meaningful conclusions are drawn. ( 2 ) for laminated plates with delaminations, due to complexity of the analytical solution, the finite element method is employed to analyze their temperature distributions and satisfactory results are also obtained

    本文在前人研究的基礎上，對此方法進行了進一步的探討，主要做了以下的工作： （ 1 ）選取合理的、能夠準確反映由共振而產生熱量的行為的局部響應模型，以及合理的振動熱模式，推導了一維層合梁小脫層區域的振動響應及梁的溫度分佈，並編製程序計算了該層合梁在激勵一段時間后的溫度分佈趨勢，分析了激勵頻率對溫度梯度形成的影響，得到了一些有意義的結論； （ 2 ）對於二維層合板，由於解析解的形式異常復雜，本文採用有限元計算軟體對其溫度分佈進行了分析，也得到了較為滿意的結果。
  8. The prerequisite of actively mode - locked fiber laser stable work is that the modulation signal frequency must be the integral multiple to the cavity resonance frequency

    主動鎖模光纖激光器穩定工作的前提條件之一是調制信號頻率應為腔內縱模間隔的整數倍。
  9. The resonance equation of the sampled fiber bragg gratings is derived through the fourier ' s transform and the coupled - mode theory, which determine the wavelengths of the resonance peaks

    摘要利用傅里葉變換和耦合模理論得到了取樣布拉格光纖光柵的諧振方程，確定了其多諧振峰的位置。
  10. Then in this article resonance method is adopted. the paper analyzes the usual measurement methods of complex permittivity, then analyzes and chooses te0np circular cavity based on the methods of the te01n high - q circular cavity, uses the mode purifying and cavity dimension optimizing techniques. the resonant frequencies of varies modes in the resonant cavity have been drawn by using matlab software, which makes our work more rapid and convenient

    本文首先分析了復介電常數的常用測試方法，然後分析並選用了基於高q腔法原理的te0np圓柱腔，應用模式凈化和腔體優化技術，利用matlab這一運算性能強大的工具軟體編程，作出諧振腔中各個模式的頻率分布圖，使系統的設計工作清晰、便捷。
  11. The main research is as follows : analyze and research the boundary constraint and the structure characteristic and segment the frame making use of the shell element, the pipe element etc. on the base of it the practical finite element model has been established ; analyze the mode of the frame by dint of the finite element model. and get the inherent frequency and the vibration mode of the frame. tentatively estimate the dynamic characteristic of the frame and analyze the inherent frequency that may be lead to the resonance

    論文的主要研究工作如下：分析研究車架的邊界條件和結構特性，並用殼、管等單元對該車架進行離散，建立一種切實有效的車架有限元模型；對該車架的有限元模型進行模態分析，求得其的固有頻率和振型，並對車架的動態特性做出初步評估，分析可能引起車架振動的固有頻率；在模態分析基礎上，研究發動機輸出的簡諧力引起的車架位移響應（即諧響應分析） ，以考察摩托車車架各部位的振動情況並與模態分析對比，分析是否與該車架的固有頻率相耦合而導致共振；在深入研究車架的模態分析及諧響應分析、清晰地認識了摩托車車架動態特性的基礎上，分析並提出了採用橡膠減震器對車架進行隔振的減震方法。
  12. Anyway, the pyramid horn sensor can be a resonance sensor, which operates with high order mode. this provides physical explanation for the puzzle of sensitive operating point of the cpy - 1

    從而，揭露了角錐喇叭近場探頭摘要存在敏感工作點的奧秘一一即角錐喇叭探頭構成一種高次模諧振式探頭。
  13. 2 for the first time, the author brings forward the concept of " pyramid horn high order mode resonator " and pml - fdtd technique is used to analyze the electromagnetic field distribution in the pyramid horn. the results show that the pyramid horn sensor is much more sensitive than the open ended waveguide or transmission line sensors. the sensor we used is a kind of resonance sensor

    二、首次提出了「角錐喇叭高次模諧振腔」的概念，並且採用pml ? fdtd法分析了角錐喇叭場分佈狀態，從而，得出了角錐喇叭探頭比終端開口波導或傳輸線探頭靈敏得多的原因在於：我們採用的探頭是諧振式探頭，消聲瓦樣品的差別相當于對角錐諧振腔的微擾；採用波導或同軸線探頭，消聲瓦樣品的差別相當于對傳輸線終端負載有一點變化而已。
  14. ( 4 ) based on module theory, the operation state analysis of voltage - feed zcs buck converter has been simplified and the time - discrete mathematic modeling of dcm mode has been setup. ( 5 ) the stability operation parameter range has been decided according to the stability criterion, and the analysis of influent of resonance inductance and capacitance to converter ’ s chaos character is carried out

    （ 5 ）根據系統穩定性判據確定了穩定工作區域，得出主要元件參數的穩定工作范圍，設計了電壓反饋控制buck變換器的模擬電路並根據模擬結果分析了諧振元件的加入對于變換器運行穩定性和混沌特性的影響。
  15. The simulation results show that to start the oscillation, the length of the resonance cavity must be well matched with the radial span of the cavity ; mismatch of them will greatly affect the microwave development ; the output power of the microwave in rtto is affected by the microwave mode obviously. under the same conditions, the output power for temooi mode is the highest, and its start and saturation time of oscillation are the shortest. the results also show that the output power will decrease with the increase of the size of the extract window ; the operating state of rtto has great close relationship with the operating current, and there exists an optimum current value

    結果表明，束電壓一定時，諧振腔腔長和徑向間距必須良好匹配微波才能起振，匹配不佳會極大地影響微波產生；微波模式對微波產生功率影響很大，同等條件下， tem _ （ 001 ）模式的微波功率最高，起振時間和飽和時間最短；微波輸出功率隨提取口的增大而減小； rtto工作狀態與工作電流的大小關系密切，存在一個最佳工作電流值。
  16. Breaking off at wuwei on the hai - jin liens, after " ti " mode joined into wuwei 330kv transformer substation, it may bring some problems, such as fundamental frequency excessive voltage, resonance excessive vohage, stability, undercurrent, reactive power compensation, etc. these problem be analyzed. it provides the schemes of design and build wuwei transformer substation and reform the transmission line of hai - jin - jia

    在海金線武威開斷， 「 」入武威330kv變電站后可能帶來的如：工頻過電壓、諧振過電壓、穩定水平、潛供電流、無功補償等問題進行分析，對武威變電站的設計、建設及海金嘉線路改進提供方案。
  17. With a three wave interaction model, the pump wave mode is found to be strongly modulated by the background fluctuation, accumulated due to alfven resonance near the resonant layer

    通過三波共振模型的分析，可以發現pump波能被集聚在共振層附近的大幅度背景擾動強烈調制。
  18. In contrast to phase separation ( curve - fitting ) approaches which are largely mathematical, phase resonance testing is a physical technique. when a structure is vibrating in a normal mode, the undamped natural frequency and normal - mode shap of the structure are directly measured. in the classic phase resonance testing, the test data processing is simpler and the results are more accuracy

    相對于相位分離法來說，相位共振法是一種比較直觀的物理識別方法，在結構做「純模態」振動時，通過物理測量直接獲得模態參數;試驗數據處理工作量小，且精度一般比單輸入系統高。
  19. The second case is 1 / 2 subharmonic resonance - principal parametric resonance and 1 : 1 internal resonance. the final case is primary resonance for the second mode - principal parametric resonance and 1 : 2 internal resonance. the adjoint operator method and the theory of normal form are used to investigated the normal forms in the four dimensional nonlinear systems with cubic nonlinearities

    第一種共振情況是主共振-主參數共振和1 ： 1內共振的情形；第二種共振情況是1 2亞諧共振-主參數共振和1 ： 1內共振的情形；第三種共振情況是第二模態主共振-主參數共振和1 ： 2內共振的情形。
  20. Finally, we use resonance fluorescence theory to study the quadrature squeezing spectra in the resonance fluorescence of a v - type three - level atom driven by a coherent field and coupled to a single - mode cavity. the influence on the squeezing spectrum caused by cavity - induced quantum interference is discussed

    本文還應用共振熒光理論，研究了一個置於腔中的v型三能級原子的共振熒光的壓縮譜，探討了腔誘導量子干涉對原子共振熒光相振幅的壓縮譜的影響。
分享友人
分享到 Line

分享到臉書