return water temperature 中文意思是什麼

return water temperature 解釋
回水溫度
  • return : vi 1 回轉，回來，回去，返回，折回 （ to）。2 再來，又來；復發，回復，恢復。3 回頭說正經話，回到本...
  • water : n 1 水；雨水；露；〈常作 pl 〉 礦泉，溫泉；藥水。2 〈常 pl 〉水體；水域；水道；海；湖；河；海域；...
  • temperature : n. 1. 溫度，氣溫。2. 體溫。3. 〈口語〉發燒，高燒。
  1. An integrated process of wastewater treatment and utilization is presented. the process is made up of heating the soft water of room temperature by high temperature printing and dyeing wastewater via heat exchangers, reusing the low level base decrement wastewater of water washing for dust control and desulphurizing of stack gas and anaeration - aeration biological treatment of printing and dyeing wastewater. this process has fair economical benefit on the principle of so called waste control by waste itself. this might be an ideal process for printing and dyeing wastewater treatment and disposal, the effluent of this process is quite enough to meet the requirement of urban sewer collector. additionally also many advantages are attractive such as the complete return of biological sludge to digestion, no chemicals dosage and free of secondary pollution

    介紹了高溫印染廢水通過熱交換加熱常溫軟水、低濃度堿減量水洗廢水用於煙道氣除塵脫硫、厭氧-好氧處理一般印染廢水等印染廢水綜合處理技術，該技術具有較好的經濟效益，達到了以廢治廢的目的，生物污泥全部迴流硝化，不加任何藥劑，無二次污染，處理后水質達到城市截污管網標準要求，是一種較為理想的印染廢水處理工藝。
  2. High temperature water - source heat pump can reclaim loss - grade heat that is produced when energy - changed device such as boiler is operating, anti the return water of district heating supply system is heated

    摘要利用高溫水源熱泵設備可回收鍋爐等能量轉化設備產生大量的低溫餘熱，提高其溫度用於直接供熱。
  3. The experimental results showed that : in the summer operating mode, the refrigerating capacity and coefficient of performance of the system decreased with the increase of the temperature difference between supply and return ground - water and the water supply temperature ; in the winter operating mode, the refrigerating capacity and coefficient of performance of the system increased with the decrease of the temperature difference between supply and return ground - water and the increase of the water supply temperature. it also showed that, change the are of heat exchanger has great influence of refrigeration system

    本課題通過實驗測試井水進口溫度、進出口溫差以及在不同溫差下換熱器面積匹配對系統性能的影響。實驗結果表明，夏季工況下，隨著井水進口溫度的升高，進出口溫差的增大，系統製冷量減小，機組cop降低，系統運行性能惡化。冬季工況下，隨著井水進口溫度的升高，進出口溫差的減小，系統的制熱量增加，機組cop提高，系統運行性能優化。
  4. Standing clear of the outlet ( discharged water may be hot ), slowly lift and release the lever handle on the temperature and pressure relief valve to allow the valve to operate freely and return to its closed position

    經常清洗出口（排泄水可能是熱的） ，慢慢提起並釋放降溫減壓安全閥上的杠桿手柄，使得閥門能夠靈活工作並恢復到關閉位置。
  5. It can make the average temperature of the supplying water and return water in every substation tends to be equal, which guarantees well - proportioned flow distribution in the primary heating network. meanwhile, a comfortable living environment can be created in people ' s daily life

    通過模擬實驗證明，此演算法是可行的，具有使各熱力子站二次側供回水平均溫度趨於一致，達到均勻供熱的效果，從而能夠為用戶創造舒適的生活環境。
  6. Temperature difference between supply and return water

    水系統供水溫度與回水溫度之差
  7. Presents the on - off control mode of refrigerating machine by supply and return water temperature difference and load proportion with an example

    摘要以具體的工程實例介紹了利用供回水溫差和機組負荷百分數進行機組臺數啟停控研究制的方法。
  8. Presents two common heat recovery methods for water cooling chillers. recommends the control scheme by monitoring the return water temperature. presents two design schemes for chilled water systems

    摘要介紹了兩種常見的水冷冷水機組熱回收方式。推薦採用熱水回水溫度控制方案。介紹了冷水系統的兩種設計方案。
  9. Abstract : a thermo - economical diagnostic mathematical model for pressurizedwater reactor ( pwr ) nuclear cogeneration plant is proposed based on heat assignment method. this model simplifies the calculation of thermal system and can be used to calculate the index variations caused by heating steam parameters as temperature, return percentage and return place of the return water. some examples are given to show the usefulness of this model

    文摘:基於熱電聯產機組熱量法分配的特點，建立了熱電聯產壓水堆機組熱力系統發生變化對熱經濟性指標影響的計算模型，提出了供熱系統參數? ?供熱回水率、回水溫度、回水地點變化對壓水堆機組熱經濟性影響的定量診斷數學模型，可將復雜的熱力系統全面計算簡化成3個一次方程.通過實例計算，驗證了所提數學模型是正確可行的，同時具有概念清晰、計算簡捷的特點
  10. In this paper, it emphasized on the influence of the supply temperature of the ground - water, the temperature difference between supply and return ground - water, the flow - rate of the well on the system, the difference area of heat exchangers

    為了解決上述問題，我們建立了地下水源熱泵系統實驗臺，採用實驗和模擬相結合的方法，對系統的性能特性進行研究分析。
  11. The hvac system did not work well in yifu library of beijing university of technology, so we have a local investigation. finally we found out the reason for “ cold in winter and hot in summer ”. in may eighth, we tested the temperature of reading room 、 office ; supply and return water temperature ; water flow and the velocity of fan coil units. we simulate the library with energyplus, which is developed by u. s. a, compared the simulation results with the true temperature and they anastomosed well. on the basis of good simulation results, we simulate the hot day in summer and the cold day in witer and get the temperature of the reading room and the office

    于空調系統開啟的條件下測試了館內各功能房間的溫度;供、回水溫度及流量;風機盤管的出風速度。又運用美國新一代能耗分析軟體energyplus對當日館內的溫度進行模擬，將模擬值與實測值進行比較，驗證兩者基本吻合。進一步模擬出夏季與冬季設計日圖書館內各功能房間的室內溫度，作為分析依據。
分享友人
分享到 Line

分享到臉書