rod end bearing 中文意思是什麼
rod end bearing
解釋
桿端軸承-
In the simulation, the mpc technique of msc. nastran is used to simulate the mechanical behavior of contact between the interfaces of piston pin and bearing of small end, crankpin and big end bearing, connecting rod body and bearing cap ; also constraints are applied to the connecting rod reasonably
分析中採用了patran中的多點約束（ mpc ）技術，有效地模擬了活塞銷與小頭孔內表面、曲柄銷與大頭孔內表面以及連桿體與大頭蓋接觸面的力學接觸狀態，並對連桿進行合理的約束。 -
When analyzing skew support continuous curved box girder bridge, curved grid girder analyzing method considering warping effect is applied. matrix displacement method is applied in analyzing skew support continuous curved thin - walled box girder bridge with restrained bearing. in order to convert original rigidity equations to structural rigidi ty equations that can be solved, bearing nodal displacement matrix can be introduced, then unknown quantities at the edge of beams can be consistent with the restrained directions of skew bearings, unit rigidity matrix and unit nodal forces can be gained. structural rigidity matrix can be composed according to matrix displacement method, so nodal displacements and inner forces on the end of the rod that are unknown can be gained calculating equations of inner forces on any cross - section can be solved
分析斜支承連續曲線箱梁橋時，採用考慮翹曲作用的曲線格子梁分析方法，應用矩陣位移法對具有約束支承形式的斜支承連續曲線薄壁箱梁橋進行分析，考慮到支座的約束條件並不與梁端彎曲角位移和扭轉角位移的方向一致，引入支座節點坐標矩陣，使得梁端的位移未知量與斜支座約束方向一致，來計算單元剛度矩陣和單元節點力，然後按照矩陣位移法組集總剛並建立結構剛度方程，根據結構剛度方程即可求解未知的節點位移及桿端力，推導出任意截面處的內力計算公式。 -
Suitable for each type of dual - surface molding, for example, spring end, bearing, magnet, connecting rod, piston ring, compressor valve and etc
適用於各種雙面加工例如：彈簧端面培林磁鐵連桿活塞環壓縮機閥片等。
分享友人