rolling experiment 中文意思是什麼

rolling experiment 解釋
橫搖試驗
  • rolling : adj 1 旋轉的；滾動的；波動的，起伏的；滔滔地流的；隆隆響的。2 捲起的。3 左右搖擺的。4 〈美國〉起...
  • experiment : n 實驗；試驗；嘗試 （of） a scientific experiment 科學試驗，科學儀器設備。 a new experiment in ed...
  1. The velocity field has been designed in this article on defect of rolling workpiece surface about cross wedge rolling technique in the process of forming axial symmetry spare parts by result of simulated experiment of consult document [ 4 ]

    摘要依據文獻[ 4 ]的模擬實驗結果，擬定了楔橫軋工藝成形階梯軸類件時軋件表面出現表面缺陷（蛇皮狀或魚鱗狀缺陷）時的金屬流動速度場。
  2. The available maximum rolling angle of the platform is 30 and in the experiment the maximum rolling angle 10, 15, 20 was chosen. the rolling period of the platform is selected with 5 second, 7. 5 second and 10 second

    實驗中選定最大搖擺角度為10 、 15和20 ，搖擺周期為5秒、 7 . 5秒以及10秒，以及一些分離周期值。
  3. Through the experiment, the following results were given out, whether the system was rolling or not, there were always density oscillation gradients when the two - phase flow instabilities occurred, and the stability of the system was always strengthened with the increasing of the inlet mass flow or the increasing of the inlet subcooling of the test tube

    實驗結果表明，無論是搖擺還是不搖擺，系統發生的不穩定類型中都有密度波型脈動成分，系統的穩定性總是隨流量的增加而增強，隨入口過冷度的增加而增強。
  4. While cyclic deformation experiment under constant strain control is performed in 400, the material shows the continuous hardening until cyclic invalidation. ( 3 ) back stress attained by kwl " s method is used to analyse the bauschinger effect during an incremental step cyclic test and cyclic deformation test under constant strain control, it is shown that back stress increases with increasing plastic strain and the numbers of cycle, and the back stress is uniform, regardless of tension or compression conditions. ( 4 ) as far as recrystallized zircaloy - 4 plate is concerned, the back stress in transverse direction is higher than that in rolling direction due to the higher schmid factor in rolling direction

    對于再結晶狀態的zr一4合金板材試樣來說， t方向（橫向）試樣的背應力要高於r方向（軋制方向）的背應力，原因在於r方向的schmid因子高於t方向的schmid因子; 400下， zr一4合金的背應力要明顯低於室溫下的背應力;含氫200pg / g的zr一4合金的背應力大小與無滲氫的zr一4合金背應力相比，無明顯區別;固溶處理后， zr一4合金的背應力大小發生了變化，在較高塑性應變下，背應力均高於固溶處理前的背應力。
  5. The experiment research on friction moment dynamic error of rolling bearing

    滾動軸承摩擦力矩動態誤差的實驗研究
  6. In the course of developing and before application, the performance of carrier - borne aircraft illuminated guidance system under the environmental state of movement should be tested firstly, especially the performances and state measures of glide indicator, rolling indicator and gyrohorizon which offer ship ' s movement postures to carrier - borne aircraft in the illuminated guidance system, this needs to offer a artificial carrier on the land that can imitate ship ' s movement in the water. at present, simulating table only has single degree of freedom at home application to carrier - borne aircraft illuminated guidance system which need change test and measurement situation and adjust benchmark in the course of experiment

    艦載機燈光引導系統作為艦載機著艦引導特輔裝置是載機艦船上不可或缺的特種裝置，是保證飛行員的生命安全和艦載機安全回收的重要手段。其在開發過程中以及正式安裝使用前，首先要通過在運動環境狀態下的性能測試，特別是燈光引導系統中為艦載機提供艦船運動姿態的下滑指示器、橫搖指示器以及陀螺地平儀的性能和狀態檢測，這就需要在陸地上為它們提供一個可模擬艦船在水面運動的載體。
  7. But there has been no track spectrum that can reflect the real condition of chinese rail for a long time. many organizations have put forward some conclusions of track spectrum, but there is no unite conclusion at present in china. power calculation of locomotive and experiment on the rolling and vibration test - bed have to adopt foreign track spectrum

    但長期以來沒有能反映我國實際軌道狀況的軌道譜，雖然國內很多機構都已提出一些軌道譜的結論，但尚沒有統一性的結論提出，機車車輛動力學計算和滾動振動試驗臺試驗均只有採用國外軌道譜。
  8. Based on two fault diagnosis instrument systems for rolling bearing and car, several diagnosis strategies using integrated intelligence have been brought forward. applied methods that fault feature is extracted from high frequency resonance signal have also been presented. many experiment results have shown the effectiveness of these methods

    以滾動軸承和車輛故障診斷儀器系統為研究背景，提出了幾種集成智能故障診斷策略和從高頻共振信號中提取故障特徵的實用方法，並充分利用這些方法對滾動軸承和車輛的多種故障診斷進行了實驗研究，證明了這些診斷方法的有效性。
  9. Abstract : the paper analyses the forming process of eccentric shaft with cross - wedge rolling. the authors show the special forming method of eccentric shaft, take the brake - shoe shaft of ca141 truck as example and make an experiment on it. the research keeps up with standards of assembling and is put into production. the achievements have practical significance to extend the area of cross - wedge rolling forming to engineering use

    文摘:分析了利用楔橫軋工藝成形偏心件的過程，給出了偏心件的特殊成形方法，並以ca141汽車剎車蹄片軸為例進行了試驗，取得了滿意的結果，該研究成果對于開拓楔橫軋成形工藝應用的新領域有實際意義。
  10. The experiment is carried out on a rolling platform whose rolling period can be adjusted continuously

    在最大搖擺角度為30 ，搖擺周期連續可調的搖擺臺上進行了實驗研究。
  11. The rolling and the horizontal motion of ship are coupled intensely. meanwhile, the coupling motion is often presented as non - linear function according to experiment results and the ship is usually disturbed by sea wave when it cruises

    船舶的橫搖運動與水平面運動是強烈耦合的，而這種相互耦合的運動根據試驗數據往往被擬合為非線性函數的形式，同時船舶在海上運動又會受到海浪的干擾作用。
  12. With the orthogonal experiment method, the heat rolling processing parameters of the high - grade carbon steel ( 20 ) are established so as to realige the control and enhance the compositive mechanical property and cold crooked performance which advances the quality of the product

    運用正交試驗方法，確定優質碳素結構鋼（ 20 ）鋼板熱軋工藝參數，以便實現控制，提高20鋼板的綜合機械性能和冷彎工藝性能，提高產品質量。
  13. Abstract : with the orthogonal experiment method, the heat rolling processing parameters of the high - grade carbon steel ( 20 ) are established so as to realige the control and enhance the compositive mechanical property and cold crooked performance which advances the quality of the product

    文摘:運用正交試驗方法，確定優質碳素結構鋼（ 20 ）鋼板熱軋工藝參數，以便實現控制，提高20鋼板的綜合機械性能和冷彎工藝性能，提高產品質量。
  14. Setup of experimental system and experiment research first, coupling characteristic between flexible appendages and central rigid body is theoretically analyzed. based on simplifying the object studied, its theoretical model is derived by applying lagrange equation, and the coupling characteristic is analyzed. the control modals of flexible appendages are determined through calculating rolling couple coefficient and simulation of real coupling structure

    將研究對象簡化為帶有對稱柔性梁的剛性體，分析了柔性附件與中心剛體的運動耦合模式，並對影響中心剛體姿態角的反對稱耦合模式建立了動力學方程，通過對實際結構轉動耦合系數的計算和模擬分析，確定了柔性附件振動控制的重點模態。
  15. Experiment result shows that the high frequency resonance analysis based on half - complex wavelet can improved the sensitivity of rolling bearing fault diagnosis

    實驗結果表明基於半復小波的高頻共振分析法能提高滾動軸承的早期故障診斷率。
分享友人
分享到 Line

分享到臉書